99628071_GB_A.qxd 21/01/03 13:46 Page 1
User Guide
Trapeze Hood
99628071_GB_A.qxd 21/01/03 13:46 Page 2
Contents
Introduction |
P.2 |
||
Know the various parts of your hood |
P.3 |
||
Safety recommendations |
P.3 |
||
Installation conditions |
P.4 |
||
Installing your hood |
P.5-8 |
||
Connecting your hood |
P.9 |
||
Using your hood |
P.9 |
||
Changing a bulb |
P.9 |
||
Cleaning your hood |
P.10 |
||
How to contact us ? |
P.11 |
||
Throughout this manual, |
|
|
indicates safety recommendations, |
|
|||
|
|||
|
|
|
indicates advice to help you make the |
|
|
|
best use of your duct |
Introduction
Dear Customer,
Thank you for choosing the BRANDT hood.
Our design staff have produced a new generation of kitchen equipment, to make everyday cooking a pleasure.
The modern, attractive design of your new Brandt hood will blend smoothly into your kitchen installation, providing an optimum combination of easy use and performance.
The Brandt range also includes a huge choice of fitted cooking hobs, ovens, dish-washers and refrigerators, that will match your new Brandt hood.
Of course, we make every effort to ensure that our products meet all your requirements, and our Customer Relations department is at your disposal, to answer all your questions and to listen to all your suggestions (see back cover of manual).
Brandt has always been a leader in the development of new products, thus enhancing the quality of everyday life by providing increasingly efficient products, that are easy to use, respect the environment, and are attractive and reliable.
The BRANDT name.
2
99628071_GB_A.qxd 21/01/03 13:46 Page 3
Know the various parts of your Hood ?
|
Control buttons |
|
(see below) |
Filter Cartridge |
Light |
|
3-speed model
I Slow speed
II Medium speed I II III III Fast speed
Lighting
Note: If more than one speed button has been depressed, the hood operates at the fastest.
The hood stops working when no buttons are depressed.
Safety recommendations
Please become familiar with the safety recommendations, before installing and using your hood.
This hood is designed for normal household use. This hood contains no asbestos.
- Do not allow naked flames to burn beneath the duct, i.e. do not cook " flambé " dishes or allow a gas ring to burn with no receptacle placed on it (extracted flames could damage the duct).
- Frying under the duct should be constantly monitored.
- Repair work should only be carried out by an approved specialist. - The metal filters should be regularly cleaned.
- The hood must not be installed or used over a fuel burning (wood, coal, etc.) stove.
To obtain optimum efficiency from your hood:
- You should preferably use the rear cooking rings on your cooker. We recommend that the hood should be switched on from the beginning of the cooking and, in certain cases, may be allowed to run for a few minutes after the end of the cooking.
Note :
- When a cooking hood is used simultaneously with other equipment burning gas or similar fuels, the room must be adequately ventilated.
When the duct is running at max. power, the air in a kitchen is entirely evacuated, and thus replaced, in a few minutes.
IMPORTANT
- In the case of a kitchen heated by equipment connected to a chimney (e.g. a stove, etc.), the hood must be installed in recirculating mode.
- Do not use the hood without the metal filters.
3
99628071_GB_A.qxd 21/01/03 13:46 Page 4
Installation conditions
If you have an air outlet to outdoors:
Your hood can be connected to this outlet through an evacuation duct (enamel finished, in aluminium, flexihose or other non-inflammable material), with internal diameter 150 mm (not supplied).
Otherwise, an adapter may be used to connect your hood to an evacuation duct with internal diameter 125 mm (supplied with your hood).
If you have no air outlet to outdoors:
All our units can be used in recirculating mode (with no outlet to outdoors).
In this case, an active carbon filter should be installed, to eliminate smells.
Width:
600 or 900 mm Depending on model
Depth:
500 mm
Overall height under conduit:
285 mm
Overall height: 820 /1235
Outlet outer diameter:
150 mm (with non-return valve) or 125 mm.
70 mm minimum for ventilator shaft
285
minimum 820 - maximum 1235
or900 600
4