Braeburn 7390 User Manual

®

Installer Guide

7390

Wireless Remote Indoor Sensor

smart connect

TM

Please read all instructions before proceeding.

The wireless remote indoor sensor monitors temperature at a remote indoor
location and transmits the temperature data wirelessly to the thermostat. The
thermostat can be set to monitor temperature at the thermostat location, at
the sensor location or by combining the temperature at the thermostat and the
remote location(s). Up to 4 wireless indoor remote sensors can be connected.

Specifications

1

Operating Temperature: 40 - 99 ˚F
Storage Temperature: 14 - 140 ˚F
Operating Humidity: 5 - 95% Rh

Blue LED Indicator

- 1 flash every 30 seconds: Normal operation

- 3 flashes every 30 seconds: Sending sensor data to thermostat

- 1 flash every 2 seconds: Sensor is in pairing mode

- Solid for 60 seconds: Successfully paired remote sensor

Red LED Indicator

- 3 flashes every 30 seconds: Low battery

- 1 flash every 10 seconds: Lost communication with thermostat

IMPORTANT: Before mounting the remote sensor, you should verify there is good
wireless communication in the area you wish to mount it by first pairing it in that
location. If you are having trouble pairing in that location, try moving the remote
sensor to a location closer to the thermostat.

Control Range: 45 - 90˚F
Battery Power: 3.0 Volt DC
Accuracy: +/- 1˚F

7390-100-01

Pairing Remote Sensor(s)

2

See thermostat Installer Guide for additional information on pairing sensors.

1. Enter the wireless setup mode on the thermostat you wish to pair with the

remote sensor. Proceed until you see the word SENS in the display with a
flashing symbol.

2.

Make sure batteries are properly installed in
the remote sensor and then press and hold
the CONNECT button for 3 seconds.

3. The remote sensor will enter pairing mode
for 60 seconds. During this time the blue
LED will flash once every 2 seconds.

4. The thermostat will display IDS1, IDS2,

IDS3 or IDS4 indicating that wireless remote

indoor sensor 1, 2, 3 or 4 was successfully
paired. The symbol will stop flashing and
the blue LED on the remote sensor will turn
on for 60 seconds.

5. You can repeat this process to pair additional wireless remote sensors or exit
the wireless setup mode on the thermostat.

NOTE: Sensors that have already been paired will appear in the thermostat display
first, with a solid symbol.

A maximum of 4 wireless remote indoor sensors can be connected.
A maximum of 4 wireless remote sensors total can be connected.

Installation

3

Remote sensors should be mounted on an interior wall, approximately 5 feet above
the floor. For a more accurate temperature reading, keep the sensor away from
heating and cooling vents and out of direct sunlight.

NOTE: Test location by pairing your thermostat before mounting (see section 2).

+

–

–

+

Connect
Button

Installer Guide 2