Bradley Smoker LD-3072-STD, LD-3071-STD User Manual

Installation

LD-3071-3 shown

LD-3072-3 shown

Installation

Read this entire installation manual to ensure proper installation. When fi nished with
the installation, fi le this manual with the owner or maintenance department. Compliance
and conformity to local codes and ordinances is the responsibility of the installer.

LD-3071/STD
LD-3072/STD

Terreon® Lav Deck™ - 3070 Series

Table of Contents

Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Supplies Required . . . . . . . . . . . . . . . . . . . . . . . .2

Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Rough-Ins and Installation . . . . . . . . . . . . . . . . . .4

Cleaning and Maintenance . . . . . . . . . . . . . . . . .5

IMPORTANT!

Packing List

Separate parts from packaging and make sure all parts are accounted for before

•

•

•

IS
H
T

E
ID
S

P
U

discarding any packaging material. If any parts are missing, do not begin installation

•

until you obtain the missing parts.

Make sure that all water supply lines have been fl ushed and then completely turned off
before beginning installation. Debris in supply lines can cause valves to malfunction.

Turn OFF electrical power to the electrical outlets, then unplug all electrical units prior
to installation. Electrical power MUST remain off until installation is completed. After
installation is complete, turn on the water supply fi rst, then turn on the electrical power.

Hardware supplied by installer must be appropriate for wall construction. Wall anchors
used must have a minimum pull-out rating of 1,000 lbs.

Product warranties and service parts information may be found on our web site at
bradleycorp.com.

215-1640; EN 07-1111
© 2008 Bradley Corporation
Page 1 of 5 4/1/08

P.O. Box 309, Menomonee Falls, WI 53052-0309
Phone: 1-800-BRADLEY Fax: [phone]
bradleycorp.com

LD-3071/STD, LD-3072/STD Installation

Optional Components

Contact your Bradley representative for Terreon® lav deck and sink options.

Stainless Steel Trap Cover

(186-1769)

5WL Textured Stainless Steel Trap Cover

(186-1770)

Support Bracket Assembly

(S45-2406)

1-1/2" Strainer/Tailpiece

(269-1584)

1-1/2" Polypropylene P-trap

(269-1697)

or

1-1/2" Polished Chrome-Plated

Brass P-trap

(S29-094)

Supplies Required:

• 3/8" wall anchors, bolts and washers to mount lav deck to wall (minimum pull-out rating of 1,000 lbs.)

• 1/2" NPT hot/cold or tempered supply piping

• 1-1/2" NPT drain piping

• Construction adhesive

• OPTIONAL: mounting brackets for Lav Decks (available from Bradley)

• OPTIONAL FOR STAINLESS STEEL TRAP COVER: four #10 wall anchors and mounting fasteners (for each cover) suitable for
wall construction

2 4/1/08 Bradley Corporation • 215-1640; EN 07-1111