Bradley Smoker EXPRESS SS-2-AST-JUV User Manual
IMPORTANT
Read this entire installation manual
to ensure proper installation, then
file these instructions with the
owner or maintenance department.
Flush all the water supply lines
before making connections.
Wall anchors used must have a
minimum pull-out rating of 1,000
lbs.
Product warranties may be found
under "Product Information" on our
web site at www.bradleycorp.com.
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . .2
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
Installation Instructions . . . . . . . . . . . . . . . . 5-11
Cleaning and Maintenance . . . . . . . . . . . . . . . .12
Soap Dispenser Maintenance . . . . . . . . . . .13-14
Check Valve Troubleshooting . . . . . . . . . . . . . .14
Assembly of Components . . . . . . . . . . . . . .15-16
Metering Air Valve Maintenance . . . . . . . . . . .17
Metering Air Valve Troubleshooting . . . . . .17-18
Vernatherm™ Mixing Valve . . . . . . . . . . . . . . .19
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY FAX 262-251-5817
http://www.bradleycorp.com
SS-2/AST/STD
SS-2/AST/JUV
Express® Lavatory
System SS-Series
(Standard* and Juvenile Height)
Express® Lavatory Systems
are ADA compliant.
Installation
Instructions
OBSOLETE
215-1244 Rev. D; EN 08-805
© 2008 Bradley Corporation
Page 1 of 19 4/26/08
2
Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV Installation - Obsolete
4/24/08 Bradley Corporation • 215-1244 Rev. D; EN 08-805
Pre-Installation Information
Barrier-free and ADA compliant - standard height mounting
The SS-2/AST/STD Express® Lavatory System is compliant with Americans with Disabilities Act
(ADA). When mounted at 34" rim height, the Express® meets ADA, ANSI and UFAS requirements for barrier-free clearances, reaches and controls. Always check local codes and ordinances
for compliance.
Barrier-free and ADA compliant - juvenile height mounting
The SS-2/AST/JUV Express® Lavatory System is compliant with Americans with Disabilities Act
(ADA) Accessibility Guidelines for Buildings and Facilities: Building Elements Designed for
Children's Use; Final Rule.
Pushbutton and air valve
Each sprayhead is controlled by a pushbutton air valve, enabling each user to activate a single flow
of water. Air valves use 0.5 gpm for a ten-second duration, meeting the ANSI/ASHRAE/IES
90A-1980 Standard.
Supplies required for installation:
• (6) 3/8" wall anchors, bolts and washers to mount frame and bowl to wall
(minimum pull-out rating of 1,000 lbs.)
• 1/2" NPT hot and cold supply piping
• 1-1/2" NPT drain piping
3
Express® Lavatory System SS-Series
Installation - Obsolete SS-2/AST/STD, SS-2/AST/JUV
Bradley Corporation • 215-1244 Rev. D; EN 08-805 4/24/08
8"
(203)
22" (559)
34" (864)
6"
(152)
50"
(1270)
8" (203)
Radius
30"
(762)
8.5"
(216)
21"
(533)
10" (254)
Radius
Dimensions continue . . .
38-1/4"
(971)
SS-2/AST/STD Express® Lavatory System Dimensions
Standard Height Mounting
4
Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV Installation - Obsolete
4/24/08 Bradley Corporation • 215-1244 Rev. D; EN 08-805
Dimensions continued . . .
38"
(965)
34"
(864)
29"
(737)
11"
(279)
9"
(229)
6"
(152)
4"
(102)
30"
(762)
25"
(635)
11"
(279)
9"
(229)
6"
(152)
4"
(102)
34"
(864)
Standard Height
SS-2/AST/STD
Juvenile Height
SS-2/AST/JUV
5
Express® Lavatory System SS-Series
Installation - Obsolete SS-2/AST/STD, SS-2/AST/JUV
Bradley Corporation • 215-1244 Rev. D; EN 08-805 4/24/08
Installation Instructions
Step 1: Rough in
Note: See Figure 1a below (for Standard Height) and Figure 1b on page 6 (for Juvenile Height)
when roughing in the Express®.
IMPORTANT: Flush the supply lines before making connections. Debris in supply
lines can cause the valves to malfunction.
IMPORTANT: Dimensions shown in Figure 1a are for Standard Height and in
Figure 1a for Juvenile Height.
1. Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.
2. Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.
3. Install (6) 3/8" wall anchors with a minimum pull-out rating of 1,000 lbs. (supplied by
installer) at the locations shown in Figures 1a and 1b.
(MM)
32"
(813)
28-5/8"
(727)
25"
(635)
11-3/8"
(289)
(6) 3/8" WALL
ANCHORS WITH
MINIMUM PULLOUT
RATING OF 1,000
LBS.
23-1/2"
(597)
9-3/8"
(238)
2-3/4"
(70)
1"
(25)
23-1/2"
(597)
9-3/8"
(238)
1/2" NPT HOT AND
COLD SUPPLIES,
OR TEMPERED
SUPPLY - STUB
OUT 2" (50) FROM
WALL
FINISHED
FLOOR
CENTERLINE
15-1/4"
(387)
1-1/2" NPT DRAIN -
STUB OUT 2" (50)
FROM WALL
Figure 1a
Installation Instructions continue . . .
3"
(76)
SS-2/AST/STD Express® Lavatory System Dimensions
Standard Height Mounting
6
Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV Installation - Obsolete
4/24/08 Bradley Corporation • 215-1244 Rev. D; EN 08-805
Installation Instructions continue . . .
Figure 1b
(MM)
28"
(711)
24-5/8"
(625)
21"
(533)
11-3/8"
(289)
(6) 3/8" WALL
ANCHORS WITH
MINIMUM PULLOUT
RATING OF 1,000
LBS.
23-1/2"
(597)
9-3/8"
(238)
2-3/4"
(70)
1"
(25)
23-1/2"
(597)
9-3/8"
(238)
1/2” NPT HOT AND
COLD SUPPLIES
OR TEMPERED
SUPPLY - STUB
OUT 2” (50) FROM
WALL
FINISHED
FLOOR
CENTERLINE
15-1/4"
(387)
1-1/2" NPT DRAIN -
STUB OUT 2" (50)
FROM WALL
3"
(76)
SS-2/AST/JUV Express® Lavatory System Dimensions
Juvenile Height Mounting
Loading...