Bradley Corporation S19-130, S19-130A Installation Manual

S19-130

Installation

S19-130

Drench Shower Vertical Supply with
Plastic Showerhead

Douche d’urgence verticale avec
douche en plastique

Ducha de alto flujo de suministro
vertical con cabezal rociador de
plástico

S19-130A

Drench Shower Vertical Supply with
Stainless Steel Showerhead

Douche d’urgence verticale avec
douche en acier inox

S19-130A

Ducha de alto flujo de suministro
vertical con cabezal rociador de acero
inoxidable

Table of Contents

Pre-Installation Information ......................... 2

Installation Instructions ............................ 3

S19-130 Components and Parts List ................. 4

S19-130A Components and Parts List ................ 5

Table des matières

Avant l’installation ................................ 6

Instructions d’installation ........................... 7

S19-130 Composantes et Liste des pièces............. 8

S19-130A Composantes et Liste des pièces ........... 9

Contenido

Información previa a la instalación .................. 10

Instrucciones de instalación ....................... 11

S19-130 Componentes y Lista de piezas ............. 12

S19-130A Componentes y Lista de piezas............ 13

215-152 Rev. R; ECN 12-05-016G
© 2012 Bradley
Page 1 of 13 11/8/2012

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 800.BRADLEY (800.272.3539) FAX [phone]
bradleycorp.com

S19-130, S19-130A Installation

IMPORTANT

Installation

R

WI 53051

alls,

HENTLICH ZU
WEEK
WÖC

P.O. Box 309, Menomonee F

DAIRE

e(s) each week and sign

UNIT EACH

y malfunctions immediatel

hentlich im

TEST THIS

hrift. Jeglic

DIESES GERÄT 1ST
ESSAI HEBDOMA

Test-operate valv
Report an

Ventil(e) wöc

t immédiatement.

durch Untersc

Test le fonctionnement des v
signe en bas. S'il y à quelqu

un rappor

Date

Datum
Date

114-051

PRÜFEN.

Testbetrieb prüfen,
he Störung sofor

Signed
Unterschrift

below.

bestätigt
t melden.

y.

alves chaque semaine et
e chose qui ne v

Date Signed

Signe

THIS
SIDE
UP

a pas fait

Signed
Signed

Date
Date

P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA

TEL: 1-800-BRADLEY FAX: [phone])

http://www.bradleycorp.com

Packing List

•

•

•

•

Read this installation manual completely to ensure proper installation, then file it with the

owner or maintenance department. Compliance and conformity to drain requirements and
other local codes and ordinances is the responsibility of the installer.

Separate parts from packaging and make sure all parts are accounted for before discarding

any packaging material. If any parts are missing, do not begin installation until you obtain
the missing parts.

Flush the water supply lines before beginning installation and after installation is complete.

Test the unit for leaks and adequate water flow. Main water supply to the eyewash should be
“ON” at all times. Provisions shall be made to prevent unauthorized shutoff.

The ANSI Z358.1 standard requires an uninterrupted supply of flushing fluid. Bradley

plumbed emergency fixtures require a minimum of 30 PSI (0.21 MPa) flowing pressure.
Flushing fluid should be tepid per ANSI Z358.1.

The inspection and testing results of this equipment should be recorded weekly to verify

proper operation. This equipment should be inspected annually to ensure compliance with
ANSI Z358.1.

Workers who may come in contact with potentially hazardous materials should be trained

regarding the placement and proper operation of emergency equipment per ANSI Z358.1.

For questions regarding the operation or installation of this product, visit www.bradleycorp.

com or call 1-800-BRADLEY.

Product warranties and service parts information may also be found under ”Products” on our

web site at www.bradleycorp.com.

2

11/8/2012 Bradley • 215-152 Rev. R; ECN 12-05-016G

Installation S19-130, S19-130A

Installation

Supplies Required:

• Teflon tape and pipe sealant

• Piping to 1" NPT water supply inlet

• Adequate supply pipe supports

• Minimum 4" (102 mm) drain to accommodate

30 gallons (115 liters) per minute discharge
for shower waste

• Sign-mounting hardware

Local codes may require the installation of a

backflow prevention valve to complete proper
installation. Compliance with local codes is the
responsibility of the installer. Valve must be
tested annually to verify that it is functioning
properly. Backflow prevention valves are not
included with the fixture and may be supplied
by the contractor or purchased from Bradley
Corporation.

Step 1: Assemble components

1. 1Assemble the components as shown on page 4
(S19-130) or page 5 (S19-130A).

• Apply pipe sealant to all male-threaded pipe
joints.

• Use the rubber grip pad provided or a strap
wrench around pipes when tightening to
prevent marring. Place the grip pad on the
pipe, then put the wrench over the grip pad
and turn the pipe with the wrench.

• Bottom edge of showerhead should be 84"
(2134mm) from the floor.

(203mm)

(2134mm) to

9³⁄₈"

(238mm)

(195mm)

8"

84"

Floor

7¾"

S19-130

6¼"

(158mm)

Ø 3¹⁄₁₀"

(79mm)

S19-130A

Ø 10¾"

(273mm)

25½"

(648mm)

9"

(229mm)

25½"

(648mm)

Step 2: Connect water supply

84"

IMPORTANT! Do not rely on Bradley’s Drench

Shower to support supply piping.

1. Connect water supply piping to 1" NPT inlet
on unit (piping supplied by installer). Provide
adequate supports (supplied by installer) for
supply pipe using pipe hangers or other means.

2. Mount the safety sign to the wall using sign­mounting hardware supplied by installer.

Bradley • 215-152 Rev. R; ECN 12-05-016G 11/8/2012

(2134mm) to

Floor

All dimensions assume standard thread

engagement. Variations in manufacturing allow
for +/- ¹⁄₈” (3mm) per threaded joint. To find
the tolerance of a dimension, add the number
of thread joints in between a dimension and
multiply it by ¹⁄₈” (3mm).

9"

(229mm)

3

S19-130, S19-130A Installation

Assembly of Components and Parts List - S19-130

1" NPT

Supply Inlet

3.1

3.2

3.3

3.4

3.5

3.11

2

3

5

P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA

TEL: 1-800-BRADLEY FAX: [phone])

http://www.bradleycorp.com

114-050

NOTE: Use

teflon tape

only.

Item Part No. Qty. Description

1 S24-188 1 Plastic Showerhead Assembly
2 128-156A 1 Pull Rod - 25½" Long
3 S30-060 1 Stay-Open Ball Valve Assembly

3.1 S27-278 1 Ball Valve with Jam Nut

3.11 110-214 1 Jam Nut (only)

3.2 140-720 1 Stop Bracket

1

R

P.O. Box 309, Menomonee Falls, WI 53051

TEST THIS UNIT EACH WEEK
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE

Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait

4

un rapport immédiatement.

Date

Signed

Date Signed

Datum

Unterschrift

Date

Signed

Date

Signe

Date

Signed

Items 3.1–3.5 come preassembled as Item 3.

Item Part No. Qty. Description

3.3 124-048 1 Washer

3.4 128-132 1 Handle

3.5 142-002DC 1 Lockwasher
4 204-421 1 Emergency Inspection Tag
5 114-050 1 Safety Sign

4

11/8/2012 Bradley • 215-152 Rev. R; ECN 12-05-016G