Bradley Corporation S19-120HFP Installation Manual

Installation

S19-120HFP

SA

5817)
53052-0309 U
I

W

LS,

262-251-

om

p.c

FAX: (

NEE FAL

ycor

ENOMO

.bradle

309, M

//www

800-BRADLEY

1-

http:

. BOX

TEL:

P.O

114-050

Frost-Proof Drench Shower

Table of Contents

Pre-Installation Information ........................ 2

Installation Instructions ........................... 3

Assembly of Components ......................... 4

Parts List ...................................... 4

215-148HFP Rev. K; ECN 12-05-016E
© 2012 Bradley
Page 1 of 5 8/9/2012

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 800.BRADLEY (800.272.3539) FAX [phone]
bradleycorp.com

S19-120HFP Installation

IMPORTANT

Installation

R

WI 53051

alls,

HENTLICH ZU
WEEK
WÖC

P.O. Box 309, Menomonee F

DAIRE

e(s) each week and sign

UNIT EACH

y malfunctions immediatel

hentlich im

TEST THIS

hrift. Jeglic

DIESES GERÄT 1ST
ESSAI HEBDOMA

Test-operate valv
Report an

Ventil(e) wöc

t immédiatement.

durch Untersc

Test le fonctionnement des v
signe en bas. S'il y à quelqu

un rappor

Date

Datum
Date

114-051

PRÜFEN.

Testbetrieb prüfen,
he Störung sofor

Signed
Unterschrift

below.

bestätigt
t melden.

y.

alves chaque semaine et
e chose qui ne v

Date Signed

Signe

THIS
SIDE
UP

a pas fait

Signed
Signed

Date
Date

P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA

TEL: 1-800-BRADLEY FAX: [phone])

http://www.bradleycorp.com

Packing List

•

•

•

•

Read this installation manual completely to ensure proper installation, then file it

with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the
installer.

Separate parts from packaging and make sure all parts are accounted for before

discarding any packaging material. If any parts are missing, do not begin installation
until you obtain the missing parts.

Flush the water supply lines before beginning installation and after installation is

complete. Test the unit for leaks and adequate water flow. Main water supply to the
eyewash should be “ON” at all times. Provisions shall be made to prevent unauthorized
shutoff.

The ANSI Z358.1 standard requires an uninterrupted supply of flushing fluid. Bradley

plumbed emergency fixtures require a minimum of 30 PSI (0.21 MPa) flowing pressure.
Flushing fluid should be tepid per ANSI Z358.1.

The inspection and testing results of this equipment should be recorded weekly

to verify proper operation. This equipment should be inspected annually to ensure
compliance with ANSI Z358.1.

Workers who may come in contact with potentially hazardous materials should be

trained regarding the placement and proper operation of emergency equipment per
ANSI Z358.1.

For questions regarding the operation or installation of this product, visit www.

bradleycorp.com or call 1-800-BRADLEY.

Product warranties and parts information may also be found under ”Products” on our

web site at www.bradleycorp.com.

2

8/9/2012 Bradley • 215-148HFP Rev. K; ECN 12-05-016E