Bradford White URG2PDV40S6N, URG2PDV50S6N, URG2PDV50H6N User Manual
Residential Ultra Low NOx
Power Direct Vent Gas Water Heater
Photo is of
URG2PDV50H6N
FEATURING:
The FVIR Eco-Defender Safety System® Models Feature:
®
■ ENERGY STAR
ENERGY STAR
Qualified—Some models qualify for the September 1, 2010 minimum
®
EF requirement, as well as most utility rebate programs.
■ Ultra Low NOx Burner with Primary and Secondary Air Distribution Devices—Ensures
proper air to gas ratio for reduction of NOx generated by the combustion process.
■ Closed Combustion Venting System—Power Direct Vent closed combustion system
utilizes external air for combustion and exhausts directly to the outside through a separate
two-pipe system. The equivalent feet of intake venting cannot be greater than the
equivalent feet of exhaust venting.
■ Bradford White ICON System
™
—Intelligent gas control with spark to pilot ignition system
eliminates the constant burning pilot. This results in savings of pilot gas during standby
periods (120 VAC).
-- Enhanced Performance—Proprietary algorithms provide enhanced First Hour Rating and
tighter temperature differential.
-- Advanced Temperature Control System—Microprocessor constantly monitors and
controls burner operation to maintain consistent and accurate water temperature levels.
-- Intelligent Diagnostics—An exclusive green LED light prompts the installer during
start-up and provides ten different diagnostic codes to assist in troubleshooting.
-- Separate Immersed Thermowell—High-strength advanced polymer composite
thermowell provides isolation between electric temperature sensor and surrounding
water. No need to drain the tank when removing gas valve.
■ Cast Aluminum Air Intake Boot—A cast molded air intake boot design provides
exceptional durability during installation and operation.
■ Flammable Vapor Sensor—Electronic sensor prevents burner operation if flammable
vapors are detected. The sensor will also prevent operation if there is ongoing flammable
vapors burning inside the combustion chamber.
■ Factory-Installed Hydrojet
®
Total Performance System—Sediment reducing device
that also increases first hour delivery of hot water while minimizing temperature build-up in
tank.
■ Vitraglas
protection from the highly corrosive effects of hot water. This formula (Vitraglas
®
Lining—An exclusively engineered enamel formula that provides superior tank
®
) is fused
to the steel surface by firing at a temperature of over 1600°F (871°C).
■ Optional Concentric Vent Kit Termination—Concentric termination fitting provides for
only one exit opening through a wall or roof. (Subtract 10ft. (3m) for intake pipe and 10ft.
(3m) for exhaust pipe when calculating total vent length.)
■ Horizontal and Vertical Venting—PVC, ABS, or CPVC (Maximum equivalent vent length
for each pipe on reverse side).
■ Insulation System—2" (51mm) Non-CFC foam insulation covers the sides and top of the
tank, reducing heat loss. This results in less energy consumption, improved efficiencies,
and jacket rigidity.
■ Water Connections— 3⁄4" (19mm) NPT factory-installed true dielectric fittings extend
water heater life and simplify water line connections.
■ 3/4" NPT Side Connections—(URG2PDV50H6N only).
■ Factory-Installed Heat Traps—Design incorporates a flexible disk that reduces heat loss
in piping and eliminates the potential for noise generation.
■ Protective Magnesium Anode Rod.
■ T&P Relief Valve—Installed.
■ Low Restrictive Brass Drain Valve—Durable tamper proof design.
■ Complies with the latest Ultra Low NOx requirement (10 ng/J NOx limit).
6 or 10-Year Limited Tank Warranties / 6 or 10- Year Limited Warranty on Component Parts
For more information on warranty, please visit www.bradfordwhite.com
For products installed in USA, Canada, and Puerto Rico. Some states do not allow limitations on warranties. See complete
copy of the warranty included with the heater.
MANUFACTURED UNDER ONE OR MORE OF THE FOLLOWING U.S. PATENTS: 5,682,666; 7,634,976; 5,660,165; 5,954,492; 6,056,542; 6,935,280; 5,372,185; 5,485,879; 5,574,822; 7,971,560; 7,992,526; 6,684,821;
7,334,419; 7,866,168; 7,270,087; 7,007,748; 5,596,952; 6,142,216; 7,699,026; 5,341,770; 7,337,517; 7,665,211; 7,665,210; 7,063,132; 7,063,133; 7,559,293; 7,900,589; 5,943,984; 8,082,888; 5,988,117; 7,621,238;
7,650,859; 5,761,379; 7,409,925; 5,277,171; 8,146,772; 7,458,341; 2,262,174. OTHER U.S. AND FOREIGN PATENT APPLICATIONS PENDING. CURRENT CANADIAN PATENTS: 2,314,845; 2,504,824; 2,108,186;
2,143,031; 2,409,271; 2,548,958; 2,112,515; 2,476,685; 2,239,007; 2,092,105; 2,107,012. Defender Safety System
®
, Vitraglas® and Hydrojet® are registered trademarks of Bradford White® Corporation.
1128-A-0418
Residential Power Direct Vent Gas Water Heater
A
R
C
COMBUSTION
Power Direct Vent Models
NATURAL GAS
Model
Number
★ URG2PDV40S6N
★ URG2PDV50S6N
★ URG2PDV50H6N
Model
Number
★ URG2PDV40S6N
★ URG2PDV50S6N
★ URG2PDV50H6N
Model
Number
★ URG2PDV40S6N
★ URG2PDV50S6N
★ URG2PDV50H6N
Nominal
Gal.
Capacity
U.S.
Gal.
40
50
48
A
Floor to
Exhaust
Conn.
in.
7
59
/8
607/8
691/16
A
Floor to
Exhaust
Conn.
mm.
1521
1546
1754
Imp.
Gal.
33
42
40
B
Jacket
Dia.
in.
22
24
22
B
Jacket
Dia.
mm.
559
610
559
DOE
Rated
Storage
Volume
(Gal.)
38
48
46
C
Vent
Size
in.
2 or 3
2 or 3
3 or 4
C
Vent
Size
mm.
51 or 76
51 or 76
76 or 102
BTU/Hr.
40,000
40,000
50,000
D
Floor to
T&P
Conn.
in.
42
431/16
525/16
D
Floor to
T&P
Conn.
mm.
1081
1094
1329
Input
9
/16
First
Hour
Rating
(Gal.)
E
Floor to
Gas
Conn.
in.
15
13
/16
1315/16
1315/16
E
Floor to
Gas
Conn.
mm.
354
354
354
73
80
82
Uniform
Energy
Factor
F
Floor to
Top of
Heater
in.
499/16
509/16
599/16
F
Floor to
Top of
Heater
mm.
1259
1284
1513
0.64
0.68
0.68
G
Floor to
Water
Conn.
in.
15
50
/16
52
3
50
/16
G
Floor to
Water
Conn.
mm.
1294
1321
1275
Recovery at
90°F Rise*
U.S.
Imp.
GPH
GPH
43
43
64
H
Depth
in.
5
32
/16
345/16
307/16
H
Depth
mm.
821
872
773
★ URG2PDV40S6N
36
★ URG2PDV50S6N
36
★ URG2PDV50H6N
45
J
C/L of
Water
Conn.
in.
8
8
11
J
C/L of
Water
Conn.
mm.
203
203
279
Model
Number
K
Floor to
Space
Heating Inlet
in.
N/A
N/A
13
13
/16
K
Floor to
Space
Heating Inlet
mm.
N/A
N/A
351
Meet or exceed ASHRAE 90.1b (current standard) C.E.C. Listed
78% Recovery Efficiency
Nominal
Liter
Capacity
151
189
182
L
Floor to
Space
Heating Outlet
in.
N/A
N/A
5
52
/16
L
Floor to
Space
Heating Outlet
mm.
N/A
N/A
1329
Storage
Volume
(Liters)
M
Water
Conn.
NPT
in.
3
/4
3
/4
3
/4
M
Water
Conn.
NPT
mm.
19
19
19
DOE
Rated
144
182
174
N
Floor to
Air
Intake
in.
7
59
/16
607/16
693/16
N
Floor to
Air
Intake
mm.
1510
1535
1757
Input
kW
11.7
11.7
14.7
P
C/L Distance
from Intake
to Exhaust
in.
10
111/2
87/8
C/L Distance
from Intake
to Exhaust
mm.
267
292
225
1
/2
P
First
Hour
Rating
(Liters)
277
303
311
Uniform
Energy
Factor
R
Space
Heating
Conn. Size
in.
3
/4
3
/4
3
/4
R
Space
Heating
Conn. Size
mm.
19
19
19
0.64
0.68
0.68
S
Gas
Conn.
Size
in.
1
/2
1
/2
1
/2
S
Gas
Conn.
Size
mm.
13
13
13
Recovery at
50°C Rise*
Liters/
Hour
163
163
242
Approx.
Shipping
Weight
lbs.
170
196
208
Approx.
Shipping
Weight
kg.
77
89
94
Available in Natural Gas only. For 10 year model, change suffix “6” to “10”. *Based on manufacturer’s rated recovery efficiency. 110 VAC Required for
Power Venting / 110 VAC, 60Hz., 3.1 Amperes. Uniform Energy Factor and First Hour Rating is based on the latest AHRI directory listings.
H = ENERGY STAR
A
G
F
®
Qualified.
C
R
B
S
2" Vent Pipe
Max. Intake Length
P
H
M
RAIN
CAP
A
J
M
INTAKE/
AIR
VENT
EXHAUST
Concentric Vent
Kit Termination
A (in.)
291/4
A (in.)
361/4
D & L
2" Kit
P/N 239-44069-02
N
3" Kit
P/N 239-44069-01
Max. Exhaust Length
Min. Vent Length
Number
of
90° Elbows
3" Vent Pipe
Max. Intake Length
Max. Exhaust Length
Min. Vent Length
Number
of
90°
4" Vent Pipe
Max. Intake Length
Max. Exhaust Length
Min. Vent Length
Number
of
90°
URG2PDV40S6N
URG2PDV50S6N
35
ft.
35
ft.
7 ft.
1
30 ft.
25
2
ft.
3
20 ft.
URG2PDV40S6N
URG2PDV50S6N URG2PDV50H6N
85 ft.
85 ft.
7 ft.
80 ft.
1
75 ft.
2
70 ft.
3
1
2
3
60 ft.
60 ft.
7 ft.
55 ft.
5
0 ft.
45 ft.
URG2PDV50H6N
100 ft.
100 ft.
7 ft.
95 ft.
90
ft.
85 ft.
Subtract 5ft. (1.5m) for each additional
90º elbow.
R
E
K
General:
All gas water heaters are certified at 300 PSI test pressure (2068 kPa) and 150 PSI working pressure (1034 kPa). All water connections are 3⁄4" NPT
(19mm). All gas connections are 1/2" (13mm).
All models design-certified by CSA International (formerly AGA/CGA), to meet ANSI standard Z-21.10.1 and peak performance rated.
Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement.
Suitable for Water (Potable) Heating and Space Heating.
Toxic chemicals, such as those used for boiler treatment, shall NEVER be introduced into this system. This unit may NEVER be connected to any existing
heating system or component(s) previously used with a non-potable water heating appliance.
For field service, contact your professional installer or local Bradford White sales representative.
Ambler, PA
Sales 800-523-2931 n Fax 215-641-1612
Technical Support 800-334-3393
Warranty 800-531-2111
n
n
Email techserv@bradfordwhite.com
Email warranty@bradfordwhite.com
International: Telephone 1-215-641-9400 n Email international@bradfordwhite.com / www.bradfordwhite.com
©2018, Bradford White Corporation. All rights reserved.
Printed in U.S.A.1128-A-0418
Loading...