Bowers and Wilkins DM-14 Brochure

DM14

Floor-standing loudspeaker system

Product Summary

●

The DM14 is one of a series of new loudspeakers which together form the B&W DM range for
the eighties. The design brief for the entire range was to benefit from the most sophisticated high
technology tools.

●

The DM14 follows the frequency linearity, freedom from all forms of distortion and colouration
must be to monitor standard, and that the model should be fitted with audio powered overload
protection.

Technical highlights

●

The driver configuration chosen consists of two 150mm bass/midrange drivers operating in a
totally sealed enclosure, designed so as to ensure a low Q, well damped third order high
pass characteristic.

●

The HF section utilises the TW26 high frequency transducer. All the DM 14 drivers are over
engineered so work totally within their limits of power output, frequency response and
dispersion.

●

The DM14 employs acoustic suspension rear loading for the bass/midrange drivers. The
sealed enclosure is constructed of 12mm high-density particle board, laminated with 6mm
bituminous pads, and a 19mm meditle front baffle assembly.

B&W Loudspeakers Ltd reserves the right to amend details of the specifications without notice in line with technical developments. E & OE. All trademarks acknowledged.

www.bwspeakers.com

Drive Units

Frequency Response

1 x 26mm polyester weave dome
26mm dia. high temperature voice coil
1 x 100mm midrange polymide fibre
matrix cone
2 x 150mm bass driver diameter
Bextrene cone with PVA compound
coating
80Hz – 20kHz ± 2dB free-field

Sensitivity
Nominal Impedance
Power Handling

Dimensions

Finish

86dB spl at 1m
8 ohms
15W. No upper limit because of
overload protection device
Height: 567mm Width: 256mm
Depth: 295mm
Standard: teakor walnut
Special: black ash or rosewood