Boston Acoustics SPS G510, SPS G512 User Manual

5
4
3
2
1
G512 Part List:
1. Speaker Gasket
2. SPS Assembly
3. G5 Basket Assembly
4. Top Screw x 8
5. Bottom Screw x 10
SPS™Removal / Installation
Instructions
G510 Part List:
1. Speaker Gasket
2. SPS Assembly
3. G5 Basket Assembly
4. Top Screw x 8
5. Bottom Screw x 8
SPS™Assembly Installation Instructions
1. Install the SPS™assemblyvinto the basketw. The basket and frame are notched to prevent the SPS incorrectly. Make sure the SPS™assembly mounts firmly into the frame with the speaker terminals located in the correct location.
2. Install the top screws that secure the SPS™assemblyvto the basket. Eight top screwsxsecure the SPS™assembly to the top of the frame (mounting flange) and 10 bottom screwsy (G512) and 8 bottom screws y(G510) secure the SPS™assembly to the frame (top plate/spi­der).
3. Install the integral gasketu.
Warning: If disassembling the G5 for customization; where the
SPS
will be reused, store the SPS™assembly in a safe location with the voice coil facing up and protected; damage to the voice coil, even minor damage, can ruin the SPS
assembly from being installed
assembly
.
SPS™Assembly Removal Instructions
1. Remove the integral gasketu.
2. Remove the top screws that secure the SPS ketw. Eight top screwsxsecure the SPS™assembly to the top of the frame (mounting flange) and 10 bottom screwsy (G512) and 8 bot tom screws y(G510) secure the SPS™assembly to the frame (top plate/spider).
3. Once all the screws are removed, the SPS™assembly will slide out of the basket. Use care when removing the SPS™assembly from the basket.
Boston Acoustics, Inc. 300 Jubilee Drive, Peabody, MA 01960 USA
T: 978.538.5000 F: 978.538.5100 W: bostonacoustics.com
SPS, is a trademark and Boston, Boston Acoustics, and the Boston Acoustics logo are registered trademarks of Boston Acoustics, Inc. Specifications are subject to change without notice. All rights reserved. Covered by patents issued and/or pending. © 2004 Boston Acoustics, Inc.
assemblyvto the bas-
042-002216-0
-
Loading...