We suggest you keep your receipt with this owner’s guide.
WARNINGS:
DO NOT use mobile phone adapters to connect headset to airplane seat
•
jacks as this could re sult in personal injury such as burns or property
damage due to overheating. Remove and disconnect immediately if you
experience warming sensation or loss of audio.
• Contains small parts which may be a choking hazard.
Not suitable for children under age 3.
• This product contains magnetic material.
• Long-term exposure to loud music may cause hearing damage. It is best
to avoid high volume levels when using headset, especially for extended
periods.
• Use caution when usin g your headset/headphones while operating a
vehicle or engaging in any activity that requires your full attention. Check
and follow local laws regarding mobile phone and headset/headphones
use. Some jurisdiction s impose specific limitations, such as sin gle earpiece
configuration, on the use of such products while driving.
ENGLISH2
This product conforms to a ll EU Directive requirements.
The complete Declaration of Conformity can be found at
www.Bose.com/compliance.
English
CAUTIONS:
Sounds that you rely on as reminders or warnings may have an unfamiliar
•
character when using headset. Be aware of how these sounds may vary in
character so you can recognize them as needed.
• Do not drop, sit on, or allow the headset to be immersed in water.
Contents
English
Connecting to a mobile phone or
audio device
You can connect the headset to most smartphones with either
the 3.5 mm stereo plug (compatible with standard headphone
jacks) or by using the additional 3.5 mm adapter if needed.
The correct connection should allow:
• Stereo sound to be heard during music playback and
communications
• Your voice to be heard by the person on the other end of a
phone call
• The Answer/End button to operate as expected
Without adapter
The Bose® MIE2 mobile
headset works with most
Android™, Blackberry
®
Windows
without the additional 3.5 mm
adapter.
1. Plug the headset into the
headphone/headset jack on
the phone.
2. Put on the headset.
smartphones
®
, and
With adapter
The Bose MIE2 mobile headset
includes an additional 3.5mm
adapter. If your phone does not
respond when you press the
Answer/End button, you are
getting partial or no sound, or the
microphone is not picking up
sound, you may need to use the
additional 3.5mm adapter.
1. Attach the adapter to the
headset cable and plug the
headset with the adapter into
the headphone/headset jack
on the phone.
2. Put on the headset.
3
Answering and ending calls
12
The Bose® MIE2 mobile headset includes an easy to access
Answer/End button with integrated microphone. Simply press
the Answer/End button to perform an action.
Note: Some phones may require you to press twice or press
and hold the Answer/End button for a few seconds to perform
functions.
Answering calls
When you receive an incoming call,
press and release the Answer/End
button to answer.
Ending calls
When you are ready to end your call,
press and release the Answer/End
button.
Note: Some unique phone and music playback functions, like
last number redial, voice commands, and track navigation are
device-dependent, and may be accessible using the Answer/End
button. Refer to your mobile phone user’s manual to find out
what features are available.
Using a single earpiece
The Bose® MIE2 mobile headset can be used with only the
right (R) earpiece in your ear. This allows you to take calls and
still hear surrounding sounds.
English
Importance of Proper Fit
When you wear the headset properly, it provides the comfort
and clarity you expect from Bose®.
Fitting the headphone to your ear
The headphone earpiece has a soft StayHear® tip attached,
allowing it to rest comfortably in the bowl of your ear. The wing
part of the tip fits just under your ear ridge.
Note: Each tip is marked with either an L or an R
to indicate which earpiece it is for. Be sure to
attach the left StayHear
the right StayHear
To determine if the tip is the right size:
1. Insert the earpiece into the canal just enough
for the headphone to rest lightly against your ear.
2. Tilt the headphone back and press the tip wing under the
ear ridge until it is secure.
The tips should fit comfortably yet securely in the bowl of
the ear.
®
tip to the left earpiece and
®
tip to the right earpiece.
4
Changing ear tips
12 3
StayHear
®
tips
Select the eartip size that provides you with the best comfort
and fit.
1. Gently peel the edges of the attached tip away from the
earpiece, using care not to tear the tip.
CAUTION: To prevent damage, do not pull on the StayHear
tip wing.
2. Position the opening of the new tip over the nozzle and the
small slot over the nozzle hook.
Note: Each tip is marked with either an L or an R to
indicate which earpiece it is for. Be sure to attach the
left StayHear
StayHear
3. Ease the base of the tip down around the base
®
tip to the left earpiece and the right
®
tip to the right earpiece.
of the earpiece until the tip feels secured.
English
Adjusting for comfort and stability
There are several ways you can adjust your headset to provide
additional comfort and stability. Using the adjustment slider and
clothing clip you can customize how you wear your headset.
®
Using the adjustment slider
Move the adjustment slider up or down to reduce
or increase the amount of loose cord between the
left and right earpiece. Finding the right position
for the slider can help optimize the placement of
the Answer/End button and integrated
microphone.
Using the clothing clip
Use the clothing clip to fasten the cable to your
clothing, for convenience, stability, and to help
manage the cable. This can be helpful during
high-movement activities or when using the
headset in a single earpiece configuration.
5
English
Troubleshooting
If you experience any trouble using your headset, try the following troubleshooting instructions. If you still need help, or need to
purchase replacement parts, see the contact information on the inside back cover for assistance in your area.
ProblemWhat to do
No audio/intermittent
sound/sound from
only one earpiece
Incoming call ring
tone not heard
through headset
Excessive bass• Turn off any audio enhancement features on the audio source.
Low volume/poor
audio
Microphone is not
picking up sound
Phone not responding
when Answer/End
button is pressed
Phone unexpectedly
ends call
Ear tips falling off• Make sure the ear tips are securely attached to the earpiece and nozzle hook.
Lost ear tip• Visit owners.Bose.com for replacement tips.
Sound is muffled from
earpiece
• Make sure that the headset plug is securely connected to the headphone/headset jack (not the line out jack).
• Try another audio device.
• Try using the additional 3.5 mm adapter cable.
• Make sure your phone is set to pass the ring tone through to the headset. Check your phone settings and
make adjustments as needed.
Note: This feature may not be available on all phones.
• Turn off any “sound checker” or other audio signal altering features on the audio source.
• Make sure ear tips and headset nozzles are clear of any debris or wax build-up.
• Make sure the volume level of the audio source is turned up.
• Try using the additional 3.5 mm adapter cable.
• Make sure the microphone is not being blocked or covered.
The microphone is located on the back of the Answer/End button (you may notice the small opening for the
microphone).
• Try using the additional 3.5 mm adapter cable.
Note: Some phones may require you to press and hold the Answer/End button for a few seconds to perform
functions.
• Some phones will end a call if the headset is unplugged during a call.
• Make sure that the headset plug is securely connected to the headphone/headset jack.
• Check phone signal strength to ensure network coverage.
• Make sure ear tips and headset nozzles are clear of any debris or wax build-up.
• Unplug the headset from the audio source, then plug back in making sure they are securely connected.
• Try another audio device.
6
English
Cleaning
Your headset may require periodic cleaning:
• Ear tips: First, remove them from the headset and wash the
tips with a mild detergent and water. Make sure you thoroughly
rinse and dry them before putting them back on the headset.
• Headset nozzles, Microphone, Answer/End button: Clean only
with a dry, soft cotton swab or equivalent. Never insert any
cleaning tool into the nozzle or microphone opening.
Limited Warranty
You r B ose® MIE2 mobile headset is covered by a limited
warranty. Details of the limited warranty are provided on the
product registration card that is included in the carton. Please
refer to the card for instructions on how to register. Failure to
register will not affect your limited warranty rights.
Names and Contents of Toxic or Hazardous Substances or Elements
Toxic or Hazardous Substances and Elements
Cadmium
Lead (Pb) Mercury (Hg)
Part Name
PCBs
Metal parts
Plastic parts
Speakers
Cables
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials
for this part is below the limit requirement in SJ/T 11363-2006.
X: Indicates that this toxic or hazardous su bstance contained in at least one of the homogeneous
materials used for this part is above the limit requiremen t in SJ/T 11363-2006.
X000 0 0
X000 0 0
0000 0 0
X000 0 0
X000 0 0
Hexavalent
(Cd)
(CR(VI))
Polybrominated
Biphenyl (PBB)
Polybrominated
diphenylether
(PBDE)
Android is a trademark of Google Inc.
BlackBerry, BlackBerry compatible, and related marks are the
property of Research In Motion Limited (RIM) and are registered
and/or used in the U.S. and elsewhere. Used under license. RIM
is not responsible for the sale or use of this product and its compliance with safety and regulatory standards.
Windows is a registered trademark of Microsoft Corporation in
the United States and other countries.