Bosch VTC-204 User guide
Technical Specifications
Dimensions
23(0.91)
77.8(3.06)
74.8(2.94)
Installation
VTC-204 Series - Operation Manual
CONNECTION
MOUNTING
POSITION
mm(in)
50(1.97)
Ф40(1.57)
28.6(1.13)
24.8(0.98)
1/4"-20 UNC
3-Ф3.2(0.13)
Video
CCD Camera 1/3-inch Super HAD CCD
Effective pixels (HxV) 500 x 582 (PAL) / 510 x 492 (NTSC)
Color Resolution 380 TVL (min.)
Electronics shutter 1/50 to 1/120,000 s (PAL), 1/60 to 1/120,000 s (NTSC)
Output Signal 1 VPP composite video, 75 ohm
Output connection BNC connector
S/N Ratio Greater than 45 dB
Gamma 0.45
Minimum Illumination 0.5 lx at F2.0 / 30IRE
Lens 3.6 mm xed
Mechanical
Housing Compact, water resistant
Construction Robust aluminum
Weight 68 g (2.4 oz) approximately
Electrical
Power 12 VDC, 120 mA max.
Power Supply Not included
Environmental
Operational Temp. -10 °C to +50 °C (+14 °F to +122 °F)
Storage Temp. -20 °C to +60 °C (-4 °F to +140 °F)
Environment IP67 cer ti ed
In wet or moist applications, seal
camera connections to ensure
protection against water ingress
Never face the camera towards bright (sun)light
12 VDC
BNC Female
12 VDC Power Supply Class2
Video IN(75 Ohm)
MONITOR
Not supplied
Caution
These servicing instructions are for use by qualied service personnel only. To reduce the risk of electric shock do not perform
any servicing other than that contained in the operating instructions unless you are qualied to do so.
In USA and Canada, Use Class 2 Power Supply Only.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.”
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
Caution
Any changes or modications in construction of this device which are not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
1. A regulated DC12V 300mA power supply is recommended for use with this camera for the best picture and the most stable
operation.
An unregulated power supply can cause damage to the camera. When unregulated power supply is applied, product warranty
will be void.
2. The camera signal must be terminated with 75 Ohm. If your monitor is switched to high impedance then please adjust
accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal components. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may cause smear on the picture and possible
damage to the CCD.
5. Do not remove the product label with serial number, removing the label will void the product warranty.
(Waste Electrical & Electronic Equipment)
This marking shown on the product or its literature, indicate that it should not be disposed with other household wastes at
the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material
resources.
This product should not be mixed with other commercial wastes purchased this product, or their local government ofce, for
details of where and how they can take item for environmentally safe recycling. Business users should contact their supplier
and check the terms and conditions of the purchase contract. Household users should contact either the retailer where they
for disposal.
(Applicable in the European Union and other European countries with separate collection systems)
CAUTION
Correct Disposal of This Product
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER(OR BACK). NO USABLE PARTS ARE
INSIDE. LEAVE SERVICING TO QUALIFED SERVICE PERSONNEL.
This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufcient mangnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operating and maintenance(servicing)
instruction in the literature accompanying the appliance.
Important safety instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Clean only with dry cloth.
6) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
7) Do not install near any heat sources such as radiators, heat
registers,stoves, or other apparatus (including ampliers) that produce heat.
8) Do not defeat the safety purpose of the polarized or
grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet.
9) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specied by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specied by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for
long periods of time.
13) Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
CAUTION
Loading...