Bosch UHI-OG-0, UHO-HGS-50, UHO-HGS-10, UHO-HBGS-10, UHO-HPBS-10 User Manual
...
UHI/UHO Series
UHI-OG-0 | UHI-OGS-0 | UHO-HGS-10 | UHO-HBGS-10 | UHOHBPS-10 | UHO-HGS-50 | UHO-HBGS-50 | UHO-HPS-50 | UHOHBPS-50 | UHO-HBGS-60
en User Manual
UHI/UHO Series | en 3
1 Unpacking 11
2Service 11
3Description 12
4 Installation 13
4.1 Tools required 13
4.2 Camera requirements 13
4.3 Cable requirements 14
4.3.1 Video transmission (coaxial) 14
4.3.2 Input power cord 14
4.3.3 Lens control cable 15
4.4 Housing mounting 15
4.5 Opening the cover 16
4.6 Camera/Lens installation 16
4.7 Camera/Lens wiring 18
4.7.1 Fittings 18
4.7.2 Conduit 19
4.7.3 Feed-through Wiring 19
4.7.4 Power Connections 20
4.8 Video coax connection 24
4.9 Lens wiring 25
4.10 Camera/Lens adjustment 25
4.11 Final assembly 25
4.12 Sunshield 26
4.13 Fuse replacement 26
5 UHO-HBPS-10, -50, and UHO-HPS-50 27
5.1 Camera/lens wiring 27
5.2 Video coax connection 28
Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01
4 en | UHI/UHO Series
6Operation 28
7 Maintenance 28
8 Exploded view 29
docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems
UHI/UHO Series | en 5
Important safety instructions
Read, follow, and retain for future reference all of the following safety
instructions. Heed all warnings on the unit and in the operating instructions
before operating the unit.
1. Cleaning - Unplug the unit from the outlet before cleaning. Follow any
instructions provided with the unit. Generally, using a dry cloth for
cleaning is sufficient, but you can also use a moist fluff-free cloth or
leather shammy. Do not use liquid cleaners or aerosol cleaners.
2. Heat Sources - Do not install the unit near any heat sources such as
radiators, heaters, stoves, or other equipment (including amplifiers)
that produce heat.
3. Ventilation - Any openings in the unit enclosure are provided for ventilation to prevent overheating and ensure reliable operation. Do not block
or cover these openings. Do not place the unit in an enclosure unless
proper ventilation is provided, or the manufacturer's instructions have
been adhered to.
4. Object and liquid entry - Never push objects of any kind into this unit
through openings as they may touch dangerous voltage points or shortout parts that could result in a fire or electrical shock. Never spill liquid
of any kind on the unit. Do not place objects filled with liquids, such as
vases or cups, on the unit.
5. Lightning - For added protection during a lightning storm, or when leaving this unit unattended and unused for long periods, unplug the unit
from the wall outlet and disconnect the cable system. This will prevent
damage to the unit from lightning and power line surges.
6. Overloading - Do not overload outlets and extension cords. This can
cause fire or electrical shock.
7. Power cord and plug protection - Protect the plug and power cord from
foot traffic, being pinched by items placed upon or against them at
electrical outlets, and its exit from the unit. For units intended to operate with 230 VAC, 50 Hz, the input and output power cord must comply
with the latest versions of IEC Publication 227 or IEC Publication 245.
8. Power disconnect - Units with or without ON/OFF switches have power
supplied to the unit whenever the power cord is inserted into the
power source; however, the unit is operational only when the ON/OFF
switch is in the ON position. The power cord is the main power disconnect device for switching off the voltage for all units.
9. Power sources - Operate the unit only from the type of power source
indicated on the label. Before proceeding, be sure to disconnect the
power from the cable to be installed into the unit.
– For battery powered units, refer to the operating instruc-
tions.
Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01
6 en | UHI/UHO Series
– For external power supplied units, use only the recom-
mended or approved power supplies.
– For limited power source units, this power source must
comply with EN60950. Substitutions may damage the unit
or cause fire or shock.
– For 24 VAC units, voltage applied to the unit's power input
should not exceed 25.4 VAC. User-supplied wiring must
comply with local electrical codes (Class 2 power levels).
Do not ground the supply at the terminals or at the unit's
power supply terminals.
– If unsure of the type of power supply to use, contact your
dealer or local power company.
10. Servicing - Do not attempt to service this unit yourself. Opening or
removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
11. Damage requiring service - Unplug the unit from the main AC power
source and refer servicing to qualified service personnel when any damage to the equipment has occurred, such as:
– the power supply cord or plug is damaged;
– exposure to moisture, water, and/or inclement weather
(rain, snow, etc.);
– liquid has been spilled in or on the equipment;
– an object has fallen into the unit;
– unit has been dropped or the unit cabinet is damaged;
– unit exhibits a distinct change in performance;
– unit does not operate normally when the user correctly fol-
lows the operating instructions.
12. Replacement parts - Be sure the service technician uses replacement
parts specified by the manufacturer, or that have the same characteristics as the original parts. Unauthorized substitutions may cause fire,
electrical shock, or other hazards.
13. Safety check - Safety checks should be performed upon completion of
service or repairs to the unit to ensure proper operating condition.
14. Installation - This installation should be made by a qualified service person in accordance with the manufacturer's instructions and in accordance with applicable local codes.
15. Attachments, changes or modifications - Only use attachments/accessories specified by the manufacturer. Any change or modification not
expressly approved by Bosch of the equipment or authorization agreement could void the user's guarantee or authority to operate the equipment.
docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems
UHI/UHO Series | en 7
DANGER! High risk:
This symbol indicates an imminently hazardous situation such
as "Dangerous Voltage" inside the product. If not avoided, this
will result in an electrical shock, serious bodily injury, or death.
WARNING! Medium risk:
Indicates a potentially hazardous situation.
!
!
If not avoided, this could result in serious bodily injury or death.
WARNING! Medium risk:
Indicates a potentially hazardous situation. If not avoided, this
may result in minor or moderate injury. Alerts the user to
important instructions accompanying the unit.
CAUTION!
Indicates a potentially hazardous situation.
If not avoided, this may result in property damage or risk of
damage to the unit.
NOTICE!
This symbol indicates information or a company policy that
i
Accessories - Do not place this unit on an unstable stand, tripod, bracket, or
mount. The unit may fall, causing serious injury and/or serious damage to
the unit. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer. When a cart is used, use caution and care when moving
the cart/apparatus combination to avoid injury from tip-over. Quick stops,
excessive force, or uneven surfaces may cause the cart/unit combination to
overturn. Mount the unit per the manufacturer's instructions.
All-pole power switch - Incorporate an all-pole power switch, with a contact
separation of at least 3 mm in each pole, into the electrical installation of
the building to disconnect the unit by switching off the voltage to the unit.
Camera grounding - For mounting the camera in potentially damp environments, ensure to ground the system using the ground connection of the
power supply connector. See Section 4.7.4 Power Connections.
Camera lens - An assembled camera lens in the outdoor housing must comply and be tested in accordance with UL/IEC60950. Any output or signal
lines from the camera must be SELV or Limited Power Source. For safety
reasons the environmental specification of the camera lens assembly must
be within the environmental specification of -10 °C (+14 °F) to +50 °C
(+122 °F).
relates directly or indirectly to the safety of personnel or
protection of property.
Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01
8 en | UHI/UHO Series
Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140 feet, in accordance with NEC 800 (CEC Section 60).
Coax grounding
– Ground the cable system if connecting an outside cable
system to the unit.
– Connect outdoor equipment to the unit's inputs only after
this unit has had its grounding plug connected to a
grounded outlet or its ground terminal is properly connected to a ground source.
– Disconnect the unit's input connectors from outdoor
equipment before disconnecting the grounding plug or
grounding terminal.
– Follow proper safety precautions such as grounding for
any outdoor device connected to this unit.
U.S.A. models only - Section 810 of the National Electrical Code, ANSI/NFPA
No.70, provides information regarding proper grounding of the mount and
supporting structure, grounding of the coax to a discharge unit, size of
grounding conductors, location of discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
Disposal - Your Bosch product was developed and manufactured with high-quality material and components that can be
recycled and reused. This symbol means that electronic and
electrical appliances, which have reached the end of their working life, must be collected and disposed of separately from
household waste material. Separate collecting systems are usually in place for disused electronic and electrical products.
Please dispose of these units at an environmentally compatible
recycling facility, per European Directive 2002/96/EC.
Environmental statement - Bosch has a strong commitment towards the
environment. This unit has been designed to respect the environment as
much as possible.
Electrostatic-sensitive device - Use proper CMOS/MOS-FET handling precautions to avoid electrostatic discharge. NOTE: Wear required grounded wrist
straps and observe proper ESD safety precautions when handling the electrostatic-sensitive printed circuit boards.
Outdoor signals - The installation for outdoor signals, especially regarding
clearance from power and lightning conductors and transient protection,
must be in accordance with NEC725 and NEC800 (CEC Rule 16-224 and CEC
Section 60).
Permanently connected equipment - Incorporate a readily accessible disconnect device in the building installation wiring.
Pluggable equipment - Install the socket outlet near the equipment so it is
easily accessible.
docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems
UHI/UHO Series | en 9
Power lines - Do not locate the camera near overhead power lines, power
circuits, or electrical lights, nor where it may contact such power lines, circuits, or lights.
Video loss - Video loss is inherent to digital video recording; therefore,
Bosch Security Systems cannot be held liable for any damage that results
from missing video information. To minimize the risk of lost digital information, Bosch Security Systems recommends multiple, redundant recording
systems, and a procedure to back up all analog and digital information.
Warning - This device is intended for use in public areas only. U.S. federal
law strictly prohibits surreptitious recording of oral communications.
FCC & ICES Information
(U.S.A. and Canadian Models Only)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– reorient or relocate the receiving antenna;
– increase the separation between the equipment and
receiver;
– connect the equipment into an outlet on a circuit different
from that to which the receiver is connected;
– consult the dealer or an experienced radio/TV technician
for help.
Disclaimer
Underwriter Laboratories Inc. ("UL") has not tested the performance or reliability of the security or signaling aspects of this product. UL has only tested
fire, shock and/or casualty hazards as outlined in UL's Standard(s) for Safety
for Closed Circuit Television Equipment, UL 2044. UL Certification does not
cover the performance or reliability of the security or signaling aspects of
this product.
UL MAKES NO REPRESENTATIONS, WARRANTIES, OR CERTIFICATIONS
WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY
SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS PRODUCT.
Bosch Security Systems User Manual docnumber | V 2.0 | 2007.01
10 en | UHI/UHO Series
docnumber | V 2.0 | 2007.01 User Manual Bosch Security Systems
Loading...