Bosch NES936UC/01, NES935UC/01, NES932UC/01, NES736UC/01, NES735UC/01 Installation Guide

NES 730 UC

NES 930 UC

Bosch Ceramic Glass Cooktops

Models: NES 730 UC, NES 930 UC

mnstaHation Instructions HodeHs: NES 730, NES 930

Table of Contents

NOTE: The blocked letters, such as A, shown below, refer to illustrations on

Pages 2 & 4. klatch these to the related text pages.

Overall Dimensions A .................................................................................................. 2

Power Supply B ............................................................................................................. 2

Cabinet Preparation and Clearances O .............................................................. 2, 3

junction Box Location D ............................................................................................. 2

Countertop Cutout Dimensions E .......................................................................... 2

Installing the Cooktop F ......................................................................................... 3-4

Secure Cooktop to Countertop O ...................................................................... 3-4

Solid Surface Countertop Installations H and | ................................................ 4-5

Electrical Connection ................................................................................................... S

iMPORTANT: Save these instructions for Local Electrical mnspector's use.

INSTALLER: Please leave these Installation Instructions with this unit for the owner.

OWNER: Please retain these instructions for future reference.

READ AND SAVE THESE mNSTRUCTmONS

OVERALL DIMENSIONS A

See Illustration A, Page 2. These dimensions are

overall.

POWER SUPPLY

ELECTRICAL POWER CONNECTION
FOR COOKTOP

Power Supply is dual rated: 240 Volts or 208 Volts,
4 wire, 60 Hz, with the following circuit breaker

requirements: Model NES 730 at 30 Amps; Model
NES 930 at 40 Amps

JUNCTION BOX LOCATION

Plan the installation of the unit so that the location

of the junction box is within 3 feet of the left rear
of the cooktop bottom. It must be accessible

from the front of the cabinet.

D

Connect only to a 4-wire 120/240 or 120/208 volt
ac system. The neutral is required for the operation

of this appliance and an independent ground is
required.

Install a junction box (not supplied), below the
counter top within 3 feet of flexible conduit

(supplied) located at the left rear corner of the
cooktop rough-in box.

PAGE U

mnstammationmnstructions Hodeb: NES 730_NES 930

OveraJJ Dimensions

Mode[ NES 730:Width 30"

Mode[ NES 930:Width 36"

All Models: Depth 2 [- [/8"

Height above countertop: 1/4"

Minimum Cabinet Clearances

Cabinet Bottom

Building Back

Wall

Required Power SuppJy

Mode[ NES 730:30 Amp circuit breaker

Mode[ NES 930:40 Amp circuit breaker

All 240 Volt, 4 Wire, 60 Hz

208 Volt, 4 Wire, 60 Hz

Junction Box Location

Wall

EEl

II/'"i4 oxZ

MODEL NO.

NES 730

NES 930

DIM.

B
C
B
C

Cooking Sut face

Counter Top Cutout Dimensions

2-I/2'
Setback Distance

(from front edge of co/rater
to]:_ to flont edc_e of cutout )

Minimum

Inches / (mm)

[9-7/8"/(505 mm}

28-3t4" t (73[ mm}

[9"7t8'' t (505 mm)

34-3/4"/ (883 mm)

1" Flat Area

I-3/4" Flat Area

1" Flat Area

CUTOUT

DIMENSIONS*

Maximum

Inches / (mm)

20" / (508 mm}
28-7tB" t (734 mm)
20" t (508 mm)
34-7/8 '' / (886 mm)

SFor solid surface countertop installations, use maximum cutout dimensions and

consult surface manufacturer for specific cutting instructions.

PAGE 2