Bosch 560 DDC, 583 DDC, FHP560, FHP583 Quick Start Manual

Quick Start Guide

560/583 DDC

Please refer to the included Hardware User’s Guide and BACview Installation and
Operation Manual for more detailed information on setting up and using the controllers.

8733914716(2014/02)

2 |

Quick Start Guide

8733914716 DDC (2014/02) Subject to change without prior notice Quick Start Guide

Quick Start Guide

CONTENTS

Quick Start Guide – Hardware Setup .................4

Controller Features .............................4

Getting Started ...................................5

Jumper Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

DIP Switch Settings ...............................6

Rotary Dial Settings ...............................7

Power Up .......................................7

Quick Start Guide – Software Setup ..................8

Software Conguration Tools ....................8

Handheld BACview Module Features ..............8

Virtual BACview Module Features .................9

Getting Connected ...............................10

Conguring Application Parameters using BACview ...11

Modifying Parameter Values Using BACview .........11

Customizing Program Features Using BACview ......12

Useful Shortcuts for Tweaking Program Features

Using BACview ...............................12

Congurable I/O Port Assignments (SW 7.03.06) ......13

Wiring Diagram .................................14

Typical FHP560 Wiring Diagram ...................14

Table of Contents

| 3

Quick Start Guide Subject to change without prior notice 8733914716 DDC (2014/02)

4 |

Hardware Setup

Quick Start Guide – Hardware Setup

Controller Features

Battery

Quick Start Guide

Network

LON Connector

Rotary Switch

Jumper Bank

RNET

Connector

Universal

Inputs

IN-1 to IN-6

Local Access Port

(see page 10)

24VAC

DIP Switch
Bank

Analog
Outputs
(583 only)

Digital
Outputs

Part Number

8733914716 DDC (2014/02) Subject to change without prior notice Quick Start Guide

©Copyright 2014 Bosch, Inc All rights reserved

FHP 560 Controller

Quick Start Guide

Input Selection Jumpers for IN-1 & IN-2
(e.g. for a 0-5V CO2 Sensor
connected to IN-1, the jumper
should be set in bottom position)

IN-1 & IN-2 Jumper
Settings Label

Communications Selection Jumper
(i.e. jumper in bottom position for
BACnet over ARC156, or, jumper in top
position for EIA-485 using BACnet over
MS/TP, LON, Modbus, or N2 protocols)

Communications Selection label

Getting Started

| 5

GETTING STARTED

Perform a quick visual inspection to ensure the
controller has no external damage and all connectors
are intact. Ensure wiring is per desired application
(see sample FHP 560 wiring diagram on page 14).

Refer to I/O port conguration (page 13) for further

details on wiring inputs and outputs.

JUMPER SETTINGS

Verify that hardware conguration for jumpers

match corresponding Heat Pump system
application. If the controller is networked, ensure

communications jumper is set to EIA-485, unless
the network protocol is BACnet over ARC156.

Quick Start Guide Subject to change without prior notice 8733914716 DDC (2014/02)

In the above diagram, IN-1 and IN-2 are set to Thermistor/Dry

Contact, and Communications is set to BACnet over ARC156.