Bosch Appliances 3.21.0002 User Manual

Security Systems

From Telephone Nuremberg

STVC/PRM

Product Management [phone] 25.06.2010

Release Letter

Product:

Version:

This letter contains latest information about the above mentioned software.

Configuration Manager

3.21.0002

1. General

Configuration Manager is a generic configuration tool for all Bosch IP Network Video Produ cts, both
software modules and hardware devices.

It is used for configuration and licensing of the various products where it is included on the product
CD.

Configuration Manager version 3.21.0002 is a maintenance release based on version 3.20.0004 and
is part of BVIP Lite Suite 3.21.

Make sure to always use the latest released version.

1
BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany

Security Systems

From Telephone Nuremberg

STVC/PRM

Product Management [phone] 25.06.2010

2. New Features

 Updated manual and help file in German and English

3. Restrictions; Known Issues

 VGA settings for VIP XD are not available in this Configuration Manager version. Must be set

up via the product’s web site.

 Encryption Site License (option) must be installed to make AES encryption usable.
 Under Vista when using UAC, Configuration Manager must be run as administrator for valid

licensing.

 When using the Wizard to re-configure this will not work for password-protected devices.
 FTP address must be IP address only, URL is not supported.
 When the integrated iqn-Mapper shall be used in a non-VRM environment, the iSCSI

configuration passwords must be set equal at all iSCSI targets.

 Alarm input rules of AutoDomes running firmware version 4.10 can not be configured correctly

in Configuration Manager. The Web interface shall be used instead.

 After changing the IP address of a device the settings page might not be updated

automatically. Manual refresh might be required.

 The Wizard may run into a timeout situation when configuring a camera with motion recording.

A “Retry” button appears which needs to be pressed then.

 When time zone had been changed in Advanced Mode, synchronization to PC in Basic Mode

does not update time zone.

 The “Save” button is not activated in Basic Mode when DHCP settings are changed.
 In Date/Time settings page, the date and time values shown are from PC instead of from

device.

 Upload of a configuration file might be incomplete if it includes recording settings.

It is recommended to check the settings manually.

Note:

If multiple Configuration Managers are used in the network, maintaining the same or an
overlapping set of devices simultaneously, unpredictable effects might occur when writing to
the devices.

2
BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany