B&M CONSOLE MEGASHIFTER FOR 68-69 CAMARO User Manual

Cable Adjustment W arning

GM TH-200,TH-350,TH-400,TH-200-4R

TH-700-R4, 4L60, 4L60-E, 4L65-E, 4L80-E & 4L85-E

lever shown.

Z-GATE, STARSHIFTER,

QUICKSILVER #80683 W/ 3-SPD,

MEGASHIFTER, UNIMATIC,

PRO STICK, SPORT SHIFTER,

HAMMER, QUICKSILVER #80683 W/4-SPD,

PRO RATCHET #80842 W/4-SPD

STEALTH PRO RATCHET #81120 W/ 4-SPD

BANDIT SHIFTER W/ 4-SPD

INSTALLATION

Note: Be careful. Select the correct hole for your

shifter. Wrong hole will destroy the cable, shifter

and/or transmission in one shift! (GM trans. only)

PRO RATCHET #80842 W/ 3-SPD

DO NOT KINK CABLE

Note: Do not kink cable anywhere along it’s length.

If cable has a kink, it will lock up. Cable should be

kept straight for 2 inches on each end where it leaves

the brass. Any of the above will destroy the cable,

shifter and/or transmission in one shift!

MELTED CABLES

Note: if your cable is close to your exhaust it will

melt or become brittle. If this is the case, you will

need to make a heat shield. Do not wrap the cable,

this retains heat.Heat will destroy the cable!

CABLE ADJUSTMENT

Note: if you don’t adjust the cable correctly, you will

destroy the cable, shifter and/or transmission in one shift. Put the transmission in low gear and shifter in low gear, set the swivel so it slides in and out of the

correct hole freely(See installation picture). Then

move the transmission and shifter to park (all the

way the other way) then rotate the cable swivel until

it slips in and out of the hole freely. Now go back and forth between Park and low gear and fine tune the adjustment. See instructions for further details.

9500535-06