Page 1
Installation Instructions
TC6011 Bracket Kit
The TC35270 steering control is recommended for use with this bracket kit.
1. Set front wheels of vehicle in straight ahead position.
2. Using 1-1/8" socket, remove two (2) existing
bolts and nuts from shock mount bar on the
driver's side.
3. Install the anchor bracket on the shock mount
Serial Number
bar on the driver's side using the existing
bolts and nuts. Tighten to manufacturers
specs.
4. Install solenoid end of TruCenter to back of
anchor bracket with a 3/4"-10 x 6" bolt, 3/4"
fl at washer and 3/4"-10 whiz nut, torque to
180 ft/lbs.
405-00164 Rev. C Page 1 of 3 3/18/14
5. On the passenger's side, install the tie rod
bracket using the appropriate U-Bolts for your
application. DO NOT TIGHTEN. The tie rod
bracket may be rotated to insure steering
control remains parallel to the ground.
Page 2
Installation Instructions
Ground
Solid State
Timer Relay
Fuse Bus
TC6011 Bracket Kit
7. Tighten U-bolts on the Tie Rod Bracket to 3035 ft/lbs of torque, while maintaining an even
amount of threads extending past each nut.
6. Install small end of TruCenter unit to top of tie
rod bracket with Items 3/4"-10 x 3-1/2" bolt,
3/4" fl at washers and 3/4"-10 1.59 fl ange nut,
torque to 180-200 ft/lbs.
Ground
Note: Check to be sure installed unit clears
all other parts of vehicle by turning steering
wheel to both extreme right and left positions.
If unit scrapes or binds at any point, make
necessary corrections by rotating unit on tie
rod to obtain necessary clearance. It may
also be necessary to dump the air from the
air suspension to insure that the RV's trac bar
and fuel tank to not come in contact with the
TruCenter.
8. Install TruCenter Steering Control wiring
according to instructions included in its
package.
9. DEALER OR INSTALLER: BE CERTAIN
USER RECEIVES INSTRUCTION SHEET.
Solid State
Timer Relay
Fuse Bus
Shown above Freightliner Chassis XC with Air Bags, 150 Gal. Fuel Tank
Insure that you use the proper T ruCenter steering control unit for your application. Using too strong or too weak of a steering
control may result in improper or undesirable handling.
Product Safety Policy Statement
It is, and shall continue to be, a primary objective of Blue Ox Towing Products to provide customers with safe and reliable products. Blue Ox will, and has, established safety procedures in product design, manufacture, promotion and
sales; and will coordinate efforts to promote customer safety to the greatest extent possible. Each department has
primary responsibility for the promotion of safety under the guidelines of the Product Safety Committee.
If the TruCenter is in an accident, it must be replaced. DO NOT use it again! An accident can cause unseen
damage and using it again could result in more damage or serious injury. DO NOT use the TruCenter if it is
damaged or missing parts.
405-00164 Rev. C Page 2 of 3 3/18/14
Page 3
Installation Instructions
TC6011 Bracket Kit
Note: Chassis shown may vary slightly from
your individual installation.
Parts List
Ref. No. Qty. Part No. Description
1 1 TC35270 ........................................................................... TruCenter Steering Control
2 1 62-3631 .......................................................TruCenter Weather Tight Cord Assembly
3 1 61-7332 ........................................................................TC6010 Anchor Bracket Plate
4 1 102-6343 .....................................................................................206 Tie Rod Bracket
5 1 201-0764 ......................................................................3/4"-10 x 6" Hex Bolt Grade 8
6 2* 201-0780 .................................................................3/4"-10 X 3-1/2" 1.59 Flange Bolt
7 2 203-0007 ......................................................................................3/4 Flat Washer, ZP
8 3* 202-0074 ......................................................................3/4"-10 Flange Whiz Lock Nut
9 1 63-2748 .............................................................................................1-1/2" U-Bolt Kit
10 1 63-2750 ..............................................................................................1-3/4" U-Bolt Kit
* 2 items are provided with the TruCenter
IMPORTANT: Use only genuine factory replacement parts on your bracket kit. Do not substitute homemade
or nontypical parts. If a bolt is lost or in need of replacement, for your safety and the preservation of your
bracket kit, be sure to use a replacement bolt of the same grade. Repair parts may be ordered through your
nearest Blue Ox dealer or distributor.
One Mill Road, Industrial Park
Pender, Nebraska 68047
© 2012 Blue Ox
Phone: (402) 385-3051
Fax: (402) 385-3360
www.blueox.com
405-00164 Rev. C Page 3 of 3 3/18/14
Loading...