Page 1
Contact BlueAnt:
Power ON Solid Blue for 5 Seconds
Power OFF Red flash 3 times
Pairing Mode Blue flashing
Reset Blue flashing
Charging Solid Red
Charging with Power ON
Solid Red with a Purple Flash
Charging Complete Red indicator OFF
Low Battery All LED’s change to Red
Idle Blue flash every 8 seconds
Standby 2 Blue flashes every 5 seconds
Ongoing call NO LED’s
Nth America
support@myblueant.com
1 866 891-3032
Australia
Australia
support@blueant.com.au
1300 669 049
New Zealand
New Zealand
support@blueant.com.au
0800 443 122
United Kingdom
New Zealand
UKsupport@myblueant.com
0844 477 2996
LED Indicator Chart
QUICK START GUIDE
BLUETOOTH HEADSET
with Voice Isolation Technology
Keep this in your wallet for quick reference
DUAL MIC
®
Page 2
PAIRING
Before use, you must pair the headset with your cell phone. Pairing will create a stored connection in
the Z9 and your Bluetooth cell phone. Pairing has to be done only once, when first connecting to a
phone. The Z9 can store pairing information for three (3) different Bluetooth devices.
Pairing Procedure - This is an example procedure only.
These steps may differ from phone to phone, but the process will be the same.
1. First turn the phone OFF and then back ON again to refresh its memor y.
2. Bring the mobile phone to about 30cm from the Z9 Dual Microphone.
3. Find the Bluetooth menu in your mobile phone. Turn Bluetooth ON.
4. With the Z9 OFF, Press and Hold the MFB for about 6 seconds until the LED flashes Blue.
5. Your headset is now ready to be discovered by your Bluetooth mobile phone.
6. Perform Bluetooth a device discovery on your mobile phone t o add a new device. It takes a few
seconds to search for and find other Bluetooth devices around you.
7. When Bluetooth devices are found, the phone will display "BlueAnt Z9". Scr oll to it and press OK
to confirm that you want to pair with it.
Enter the Passkey "0000" when your phone prompts you. The phone will now pair with the BlueAnt Z9.
8.
9. If your Bluetooth phone menu supports it "set as authorized" or "add to trusted devices"
10. Again select the BlueAnt Z9 to connect with it. OR, Press the MFB to connect with the phone.
(Check your mobile phone user guide)
BUTTON FUNCTION MATRIX
Note:
Standby Mode means connected
to a device but not on a call.
Idle Mode means the Z9 is
ON but not connected to any device
Multiple button presses
mean click together
Power ON
Power OFF
Enter Pairing Mode
Connect to Device 1
Connect to Device 2
Connect to Device 3
Answer Call
End Call
Reject Call
Redial Last Number
Voice Dial Activate
Disconnect/Tranfer
Call Conference
Call Waiting
Volume Up
Volume Down
Mute
Turn LED’s OFF
Switch Voice Isolation
between Standard and Max
Reset Device
MFB
MFB
MFB
MFB
MFB
MFB
MFB
MFB
MFB
VOL
MFB
&
VOL
&
VOL
VOL
VOL
and
MFB
&MFB &
3 Seconds From OFF
3 Seconds Idle/Standby
6 Seconds From OFF
One Click Idle
Two Clicks Idle
Three Clicks Idle
Click Ringing
3 Seconds Active Call
3 Seconds Ringing
3 Seconds Standby
Click Standby
Click Connected
3 Seconds Active Call
3 seconds Active Call
Click Active Call
Click Active Call
3 Seconds Active Call
3 Seconds Idle/Standby
Click
Click
Active Call
Idle
Loading...