Transferring your Phonebook Contacts to the S4 17
ENGLISH
3
Automatically Transferring your Phonebook Contacts to the S4 17
Manually Transferring your Phonebook Contacts to the S4 17
Updating your Phonebook Contacts on the S4 18
Listening to Audio 19
Adjusting the Volume 20
Using 2 Phones with the S4 (Multipoint) 21
Which Phone is Used for Calls? 21
Multiple Calls (Call Waiting)* 22
Switching the S4 On and Off 23
Firmware Upgrades 23
Function Reference 24
Phone Specifi c Tips and Tricks 26
Android 26
4
ENGLISH
Apple® iPhone® 26
BlackBerry 27
Other Models 27
Troubleshooting 28
Resetting the S4 33
Specifi cations 34
Help and Support 35
Terms and Conditions 36
5
Touch-Sensitive
Volume Controls
Speak to me
Introduction
The S4 speakerphone is the fi rst true handsfree voice
controlled Bluetooth car speakerphone.
There is no need to take your hands off the wheel or your
eyes off the road to use the S4. Simply say the trigger phrase
BlueAnt Speak To Me™ and the S4 will be ready for your voice commands.
You can make outgoing calls and answer incoming calls using just your voice,
and you will always know who is calling you without looking at your phone
because the S4 will read out the caller’s name or number when the phone rings.
6
Battery
Indicator
Multi-Function
Button (the
symbol)
Bluetooth
Indicator
BlueAnt
Microphone
Handsfree
Trigger
Indicator
ENGLISH
Remove the Protective Cover
The plastic cover on your S4 is intended to protect it during transit. Please remove it before using your S4.
Charge Your S4
Your S4 has been given an initial partial charge to get you started,
but for best results we recommend you charge it using the supplied
USB cable and adaptor:
> You should charge the S4 whenever it announces that the battery is
Very Low.
> A full charge takes about 3-4 hours.
> During charging, the battery indicator light turns red.
> When the light goes out, the charge is complete.
Battery
Indicator
BlueAnt
ON
OFF
Charging
Port
7
Pair the S4 with your Phone
To use the S4 you need to pair it with your phone.
1. Slide the power switch on the side of the S4 to the ON position.
2. If this is the fi rst time you have used the S4 it will go straight to pairing mode. The voice prompts will start to
talk you through the pairing process and the light will fl ash blue.
For subsequent pairings, say BlueAnt Speak To Me, wait for the S4 to ask you to Say A Command and then
say Pair Me.
3. Follow the voice prompts to pair the S4 with your phone. The pairing code is 0000 (four zeros).
Transfer your Phonebook
Once the pairing is complete your S4 will attempt to transfer the contacts from your phonebook so that it can
announce the names of incoming callers.
Note: If your phone prompts you to allow a connection to the S4, you must select “YES” or “OK”.
8
ENGLISH
BlackBerry
®
If you are using a BlackBerry smartphone you may see a message like this one.
Select “Don’t ask this again” so that a tick appears in the box, and then choose “YES”.
™
Android
On Android devices a message about the phonebook transfer may appear
in the notifi cations area at the top of the screen.
In order to transfer your contacts you must swipe your fi nger over this message
and accept the phonebook transfer request from the S4.
Automatic Transfer Not Supported
Some phones do not support automatic phonebook transfers. If this is the case on
your phone the S4 will announce that it cannot transfer the contacts automatically.
See “Manually Transferring your Phonebook Contacts to the S4” on page 17 for help.
Accept connection request
from BlueAnt S4?
YES
NO
Don’t ask this again
Phonebook Access Request
Notifi cation
shown on
Android
devices
9
Install the S4 in your Car
BlueAnt
1. Slide the sun visor clip onto the edge of the car sun visor. Your S4 is supplied with a choice of visor clips so you
can select the most appropriate one for your vehicle.
2. Attach the magnetic back of the S4 to the fi xed sun visor clip.
1
Sun Visor
Clip
Don’t forget: Drive safely and within the law.
Please refer to the relevant national or local legislation regarding the usage of mobile devices while driving.
Remember that driving is your fi rst priority: please read the enclosed safety information booklet for tips on the
safe use of your BlueAnt device.
10
2
ENGLISH
Using the Handsfree Trigger
Your S4 is designed to be a true handsfree device. Simply say the trigger phrase BlueAnt Speak To Me and the
S4 will be ready to receive your voice commands.
12
BlueAnt
Speak To Me
When the S4 asks you to Say A Command, immediately say one of the voice commands loudly and clearly.
Note: The handsfree trigger only works when the green handsfree trigger indicator light on the front of the
device is on. This tells you that the S4 is listening for your voice.
Handsfree
Trigger
Indicator
Say A
Command
BlueAntBlueAnt
11
Handsfree Trigger Battery Saving Mode
Using the handsfree trigger gives you true handsfree operation, as the S4 is always listening for your voice.
If you want your S4 to run for longer between charges, slide the power switch to the
middle position to activate “battery saving mode”.
OFFON
In this mode the S4 only listens for 2 minutes after the last action.
Once the 2 minutes are up, the green indicator light goes out and the S4 stops listening. To re-activate the S4,
tap the
symbol instead of saying BlueAnt Speak To Me:
12
Say A
Command
BlueAnt
12
BlueAnt
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.