Do not use the tablet in situations where it might cause danger.
Transportation Safety
Please observe all transportation laws and regulations.
Please drive with both hands on the wheel.
DO NOT TEXT AND DRIVE
Hospital Safety
Please follow hospital rules and limitations.
Please turn off your tablet when near medical instruments.
Airport Safety
Remember to follow all airport and flight safety regulations.
Please do not use your tablet during flight.
Chemical Warning
Do not use your tablet around fuels or chemicals.
Temperature Warning
Do not subject your tablet to extreme temperature conditions.
Water Hazard
Your tablet is not waterproof. Keep it away from water and liquids.
Emergency Calls
Make sure your tablet is switched on and in a service area. In home
screen, tap the phone key and dial the emergency number.
Accessories and Batteries
3
Use only Blu authorized batteries and accessories.
Information Backup
Remember to keep a written record of all important information.
RF Exposure
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest
certified power level in all tested frequency bands, and placed in
positions that simulate RF exposure in usage near the body with the
separation of 0 mm. Although the SAR is determined at the highest
certified power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because
the device is designed to operate at multiple power levels so as to
use only the power required to reach the network. In general, the
closer you are to a wireless base station antenna, the lower the
power output.
The exposure standard for wireless employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6W/kg.
Tests for SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands.
The FCC has granted an Equipment Authorization for this model
device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model
device is on file with the FCC and can be found under the Display
Grant section of www.fcc.gov/oet/ea/fccid after searching on: FCC
ID:YHLBLUTB803G.
4
For this device, the highest reported SAR value for for usage near
the body is 1.50 W/kg.
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
5
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate
the equipment.
Appearance
6
SIM Slot
Memory
Card
Introduction
Installation of the SIM Card
Please keep the SIM card out of the reach of children.
The SIM card and its contact are easily damaged due
to scratching or bending. Please be cautious when
carrying, installing or taking out the SIM card.
Note: Please contact your cellular tablet service
provider directly to obtain the SIM card.
To insert SIM card:
1. Power off tablet and insert the SIM card.
2. Insert an SD card. (For additional storage capacity)
3. Power on the tablet.
Power On and Off
On - Please ensure the SIM card has been properly inserted into the
tablet. Long press the Power key to switch on the tablet on.
Off - In standby mode, long press on Power key until an options
menu appears. Select Power Off in the menu and confirm in the
pop-up prompt to switch off the tablet.
Security
You may set a security lock feature as a security measure for the
7
Keypad
Call Logs
tablet. For further information regarding password locks, password
revision and other functions please enter into the security option in
system settings.
Call Functions
At the dial keyboard, enter the phone number and then click the dial
key. If dialing an extension, you may click the dial pad icon in the
bottom of the screen to open the interface and enter the number of
the extension. You may also press and hold the 0 key to add a (+)
sign when adding an international dialing prefix.
Call Logs
Every number called and received will be saved in the call log. All
numbers in the call log can be dialed directly by clicking the dial icon
on the right side of the screen. When the number appears on the list,
8
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.