Installation Sheet
TM
What’s in the box?
1
Blossom Controller
2
Blossom Bracket
3
Four Wall Screws
4
Ethernet Cord
5
Blossom Bridge
6
Wire Labels
Connect
1
the Ethernet cable
1
2
What you will need:
• iOS or Android Device
• Internet Router and Service
C
P
1 2 345 6
6
COMMON
PUMP
6 5 432 1
C
7 8 91011 12
COMMON
12 11 1098 7
3
4
5
Plug in
the Blossom Bridge
Note: Make sure the Bridge is
plugged in direc tly into a power
socket . Avoid any power
protec tion str ip. You should see a
green lig ht once you connect i t.
2
Connect one end of the provided
Ethernet cable into the Blossom Bridge.
Connect the other end of the Ethernet cable into
an open port on your router.
Label the wires
of your old controller
Keep track of your common wire. We provide you
a black label for it. If you have a pump relay wire,
use the gray label for it.
If you want to keep
your zones in the
same valve numbers
you can use the
orange stickers.
Power up by plugging the Blossom
Bridge directly into an electrical outlet
near your internet router.
Remove
your old controller
Dismount your old watering controller from the
wall.