Blodgett 10E-SBC User Manual

10E-SBC

Electric Boiler Free

Tabletop Convection Steamers

Project

10E-SBC BOILER FREE COnvECtIOn StEamER

Item No.

Quantity

q Model 10E-SBC (single compartment,10 pan electric boiler free steamer

with plumbing connections) on a stand

CONSTRUCTION

n Stainless steel construction
n Stainless steel door with strong continuous hinge and are field reversible

for left or right swing

n Insulated door has a one piece, replaceable seal
n Easy open handle and latch provide positive lock and seal when the door

is pushed or slammed shut

n Hidden magnetic door switch cuts power to blower and steam flow to that

cavity, when the door is opened

n Pan support racks shall be polished stainless steel and removable for

easy cleaning

n Electric connectionless steam reservoir is easy to clean through the cav-

ity door.

OPERATION

n ON-OFF rocker switch
n Electronic timer with continuous steam setting
n Timed steam and stop buttons
n Ready light indicates when cavity is ready for steaming
n Unit shall come ready to steam in 15 - 20 minutes from a cold start, and

provide warm cavity-instant steam capacity. Cavity is kept warm and
ready for instant steam between loads.

n Powerful side mounted blower, which increases steam velocity and pro-

vides efficient steam distribution throughout cavity and between loaded
pans and no side vents for increased water/spray resistance.

n Electric-heated steam generating reservoir provides atmospheric steam

to the cavity at approximately 212F. The high-efficiency steam generating
reservoir shall have water level sensors.

n Steam reservoir does not require a pressure gauge or switches
n Automatic drain in steam reservoir

Shown with optional pan racks and casters

OPTIONS AND ACCESSORIES

(AT ADDITIONAL CHARGE)

q Pan racks for support stand
q Flanged foot kit for support stand
q Caster kit for support stand
q Heat shield kit

44 Lakeside Avenue, Burlington, VT 05401 • Phone: [phone] • Fax: [phone]

CAPACITY

Pan Size 10E-SBC

12” x 20” x 1” 20 pans

12” x 20” x 2.5” 10 pans

12” x 20” x 4” 6 pans

STANDARD FEATURES

n Stainless steel stand
n One year parts and labor warranty*

* For all international markets, contact your local distributor.

BLODGETT

10E-SBC BOILER FREE StEamER

Steam exhaust

1.31 (34)

Mounting holes in base use
3/8”-16 bolts which must
not extend into steamer by
more than 3/8” (10).

1.13 (29)

25.19
(639)

26 (660)

TOP VIEW

3

2

1

1.38 (35)

0.88 (22)

1.44 (36)

24.75
(628)

4.81 (122)

35.38
(899)

Water supply

Electrical
Supply

Drain

APPROVAL/STAMP

DIMENSIONS ARE IN INCHES (MM)

Steam
exhaust

REAR VIEW

Drain

5

Unit

STEAM FREE

ZONE

4

18 (457)

NOTES:

1. 2 (51) hose

Drain connection:

type (drain free venting). DO NOT
connect directly to drain, allow 2”
air gap.

2. 3/4” male hose

Water supply:

connection. 30 to 60 PSIG with a
flow rate of 0.75-1.50 GPM.
Pressure regulation is required for
water pressure over 60 PSI. DO
NOT use treated water

3. see chart,

Electrical connection:

conduit hose size=1.38” hole.

4. If the floor drain only services this
steamer, then the drain may be
located within the steam free zone.
Steam free zone must be observed
if other appliances cause steam at
the floor drain.

5. Do not install steamer directly
above steam venting floor drains.

SHORT FORM SPECIFICATIONS

Provide Blodgett model 10E-SBC (10 pan) boilerfree steamer with a self-contained, atmospheric, electric-heated steam
generating reservoir. Construction shall be all stainless steel. Cavity shall have a powerful sidemounted blower to cir-

culate steam. Standard operating controls shall include: an onoff rocker switch; electronic timer, with continuous steam,
timed steam and stop buttons; READY light. Door shall be field-reversible and shall be equipped with an easy-open

latch and hidden magnetic door switch. The atmospheric steam generating reservoir shall not require a pressure gauge

or switches; shall have an automatic drain and shall have 12 KW of dry element heating capacity. Steamer shall come
up to READY in 15 minutes from a cold start and shall provide warm cavity, instant steam capability.. Provide options

and accessories as indicated.

27.56
(700)

31.06
(79)
min.

30.63 (778)

6 (152)

FRONT VIEW

Finished
floor

(not shown)

1.5 (38) min.

2.63 (87) max.

39.88

(1012)

1

5 (127)

w/casters

SIDE VIEW

32.25
(819)

Optional racks

POWER SUPPLY AND CONNECTION

VAC Phase Hz Amps

208V 3 60 59

240V 3 60 51

480V 3 60 25

2

3

42.81

(1088)

MAXIMUM INPUT:

10E-SBC 21 kW

SHIPPING INFORMATION:

10E-SBC 469 lbs. (213 kg)

MININUM REQUIRED CLEARANCES:

Left and right side 2” (51mm)

Rear 6” (152mm)

44 Lakeside Avenue, Burlington, VT 05401 • Phone: [phone] • Fax: [phone]

Printed in U.S.A. NOTE: FOR COMMERCIAL USE ONLY

NOTE: The company reserves the right to make substitutions of components
without prior notice.

BLODGETT

P/N S00139 Rev B (11/12)