Blitz FATT DC Quick Start Manual

Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes

Warning

*Installation should start after the contents of this instruction manual
is read and fully understood

*Injury may be cause by improper installati on.
*Installation should be entrusted to a professional technician.
*Double check all wire connections. Avoid all plastic or painted
surface for ground wire. Bad ground may cause poor actuation of
turbo timer and cause the breakdown of this product.

Caution for installation work

Features

Auto Timer
Manual Timer
Temperature
Battery Voltage
Stop Watch
5 Lap Times

Blitz Performance Sales Inc
17300 Railroad St. #B
City of Industry CA 91748
Tel [phone]
Fax [phone]

www.Blitz-Performance.com

1. Vehicles equipped with computer preset automatic steering.

-Note that steering wheel does not tilt up even if the ignition key
is pull out when the product is installed in vehicles equipped with

computer preset automatic tilt steering.

2. Vehicles equipped with automatic light control.

-Note that the light may be kept on even after the timer is off. When
the turbo timer is actuated with the light switch is AUTOMATIC.
The light will remain on after the car shuts off.

3. Actuation of air conditioner.

-Depending on the types of automobile, extremely large electric
current may flow and cause breakdown of the turbo timer when the
turbo timer and air conditioner is simultaneously actuated. Be sure

to turn off air condition when the turbo timer is actuated.

Page 1

Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes

Installati o n Procedure

1. Remove lower instrument panel as shown in figure 1 #B. genuine Blitz turbo timer harness (sold separately) into the starter

2. Remove upper and lower steering column cover as shown in figure 1 #A. coupler.

3. Locate the key ignition coupler. 5. Connect the Blitz turbo timer harness to the 3 pin connector

4. Pull out the starter coupler located in figure 1 and connect the

as shown below.

6. Connect 3 pin harness to 4 pin harness.

7. Ground all black wires as shown in figure 2. Ground should be metallic
portions and avoid painted surfaces.

8. The purple wire should be grounded or hooked up to the hand break.

*Illustration shown above is reverse.

Page 2