BLACKHAWK! SPECOPS FOLDER SHOTGUN STOCK User Manual

SpecOps Folder

Owner’s Manual

www.BLACKHAWK.com

©BLACKHAWK! Products Group™NORFOLK, VA U.S.A. 1.800.694.5263

50107099 REV. 04.08

Page 1 Page 6

www.BLACKHAWK.com

©BLACKHAWK! Products Group™NORFOLK, VA U.S.A. 1.800.694.5263

Installation Instructions Product Maintenance & Information

ATTENTION: Read and follow all instructions and warnings prior to installation and/or firing a

SpecOps Folder equipped shotgun.

Take extra time to review the shooting tips & techniques sec-

tion of this manual.

If you are at all unsure of your ability to install your SpecOps Folder safely,

please seek the services of a competent gunsmith.

WARNING 1: Before beginning stock installation, make sure that the shotgun is UNLOADED.

Carefully check the chamber and magazine making both visual and touch verification.

WARNING 2: The BLACKHAWK! SpecOps Folder is NOT compatible with the Mossberg 590 DA. Use of the SpecOps Stock with the Mossberg 590 DA will cause product failure and possible injury.

WARNING 3: Remington 870 SpecOps Folder CAN NOT be used with oversized or extended safeties. Oversized or extended safeties will cause product failure and possible injury. Contact BLACKHAWK! customer service for recommended safety options.

NOTICE: The SpecOps Folder is not compatible with the FN "Tactical" Shotgun. Prior to installing a SpecOps Folder the "Tactical" trigger group must be replaced with a standard Winchester 1300/FN Police trigger group. Contact Winchester or FN for replacement trigger group.

NOTICE: The BLACKHAWK! SpecOps Folder is not compatible with receiver mounted shell or ammunition carriers.

TOOLS REQUIRED:

• Socket Wrench, Long Extension and Sockets

• Medium Phillips Screwdriver

• Large Flat Blade Screwdriver

• Extended “Ball End” Allen Wrench

Remington 3/16” (SAE) - Moss., Win., FN 1/4” (SAE) Allen wrench is available from BLACKHAWK!

• Blue Loctite #242 (optional)

INSTALLATION STEPS:

1. Remove original stock. Refer to manufacturer’s instructions for the best method to remove

stock. Normally the pad is held in place by two Phillips screws and the stock is held on by one bolt. Remove the pad by unscrewing the Phillips screws and remove the stock bolt to free the stock from the shotgun. (Fig. 1) Remington owners: Remove any metal spacers from the back of

the receiver.

Fig. 1

www.BLACKHAWK.com

2. To begin installation attach the SpecOps Folder to the shotgun, align pistol grip with the rear of

the shotgun receiver. Insert ball end allen wrench into the hole located on the bottom of the SpecOps Folder (Fig. 2 & 3) and firmly tighten the pre-installed Hex head bolt and washers. During installation, make sure that the stock is properly aligned and square with the receiver. Be careful not to strip or cross thread mounting bolt or receiver nut.

Note: For Winchester SpecOps Folder, there should not be a gap between stock and shotgun after installation. Continue to tighten bolt until gap is closed.

Note: For Mossberg SpecOps Folder only, remove rubber o-ring from stock bolt. Remove o-ring by inserting ball end allen wrench into hole located on the bottom of the SpecOps Folder. Turn wrench counter clockwise while applying pressure to the bolt with finger. Turn wrench untill rubber o-ring is removed.

Fig. 2

Fig. 3

+ 5 hidden pages