Black Diamond TC30 User Manual
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
These instructions are supplementary to the Installation and
Operating Instructions supplied with the replace and should be
kept together. Refer to the Installation and Operating Instructions
for proper gas supply, safety requirements and operating
instructions
TC30
BLACK DIAMOND
BURNER KIT
INSTRUCTIONS
PART#
TC30.NG03.C
For TC30 Series C
100308-12 TC30.NG03.C 5056.429.03
Contents of Package
A
B
C
F
D
E
NOTE:
MUST BE USED WITH PORCELAIN PANEL SET PART# TC30.PNLPBKB
A MANIFOLD ASSEMBLY
(including supply tube)
B BURNER TUBE
C BURNER SHIELD
D MEDIA SPACER, Center
E MEDIA SPACER, Front
F MEDIA SPACER, Rear
G HARDWARE PACKAGE
H 5 lbs. GLASS MEDIA
I BURNER TRAY
J PILOT SHIELD
(including pilot and pilot supply tube)
I
G
J
H
TC30.NGO3.C 100308
2
Black Diamond Burner Installation
A porcelain panel set must be used in conjunction with the installation of the burner
assembly. See Installation and Operating Instructions manual for details.
NOTE: Plug the 4 vacant holes in the bottom of the rebox with 1/2” screws,
as they are not required to attach this style of burner.
1. Remove three screws from the rear of
the rebox. Attach the manifold bracket
to the rear of the rebox with the three
screws previously removed. (Fig. #1)
INSTALL MANIFOLD ASSEMBLY
Fig #1
NOTE:
If unit is to be converted to Propane, see Propane conversion instructions on
page 7 before proceeding.
2. Attach the manifold supply tube to the
bulk head tting and tighten. (Fig. #2)
Ensure that there are no leaks.
ATTACH MANIFOLD SUPPLY TUBE
3. Attach the pilot supply tube to the bulk
head tting and tighten. (Fig. #3) Ensure
there are no leaks.
ATTACH PILOT SUPPLY TUBE
Fig #2
Fig #3
4. Attach spark electrode (ORANGE) and
sensor leads to the electrical bulk head.
(Fig. #4)
(The spark electrode connection is the
rearmost connector.)
TC30.NGO3.C 100308
Fig #4
ATTACH SPARK ELECTRODE
AND SENSOR LEADS
3
Fig #5
Fig #6
5. Install burner shield by tipping the shield
into the rebox. Route pilot up through
the opening in the burner shield.
(Fig. #5)
INSTALLING BURNER SHIELD
6. Attach the burner tray to the burner shield
using two screws at the back of the tray.
(Fig. #6)
Fig #7
BURNER TRAY PLACEMENT
7. Attach pilot shield to burner tray with two
screws. (Fig. #7)
PILOT SHIELD ATTACHMENT
TC30.NGO3.C 100308
4
Loading...