Black & Decker Wjd225 Instruction Manual

M	AX

		l
10	00m
		l
	50	0m

ENGLISH 5

ITALIANO 8

ΕΛΛΗΝΙΚΑ 11

2	3

1	4

5

MA	X

		l
	00	m
10
		6
		l
	50	0m

2

5

A

4

7

C

B

5

D

4

RESET

3

E

3

9

8

F

11

10

G

H

4

Intended use

Your Black & Decker water filter has been designed to deliver pure filtered water quickly, removing high levels of chlorine and limescale. This product is intended for household use only.

Using your filter jug

Only filter cold water.

Do not use the filter jug for any other purpose than filtering water.

Treated water should be consumed or discarded within two days.

If the water filter has not been used for more than

48 hours, flush the filter twice with fresh cold water and discard the water before using as normal.

If the water filter is not be used for an extended period, remove the filter cartridge, place it in a clean plastic bag and store it in a refrigerator. Before using the filter after storage, follow the preparation instructions in this manual.

Always store filter cartridges out of direct sunlight and away from heat sources.

Additional safety instructions for non-rechargeable batteries

Never attempt to open for any reason.

Do not store in locations where the temperature may exceed 40 °C.

When disposing of batteries, follow the instructions given in the section "Protecting the Environment". Do not incinerate the batteries.

Never try to recharge non-rechargeable batteries. Install batteries correctly.

Make sure the contact faces are clean.

Do not mix different types or brands of batteries. Keep batteries away from small children.

Under extreme conditions, battery leakage may occur. If liquid is noticed on the batteries, carefully wipe the liquid off using a cloth. Avoid skin contact.

Features

1.Spout

2.Lid

3.Cartridge life indicator

4.Water tank

5.Aqua OptimaTM filter cartridge

6.Filter jug

7.Seal

Unpacking

Remove all packaging from the filter jug.

ENGLISH

Remove the lid by gripping the sides of the lid (2) and lifting it from the filter jug.

Take the water tank (4) and the filter cartridge (5) out of the filter jug (6) and remove any packaging.

Clean the filter jug (6) with cold fresh water.

Assembly

Preparing the water filter cartridge (fig. A and B)

Prepare the filter cartridge (5) by carefully following all the instructions on the packaging.

Remove the cartridge (5) from the packaging (fig. A). Note: There may be a small residue of black carbon particles in the packaging or adhering to the body of the cartridge. This is normal, these particles are harmless and will be washed off during the following preparation process.

Immerse the cartridge (5) in cold fresh water and shake the cartridge (5) to remove the air trapped within the cartridge (5) (fig B).

Note: Some loose carbon particles may be released during this process. This is normal and does not affect the performance of the filter cartridge.

Fitting the Aqua OptimaTM filter cartridge (fig. C and D)

Remove the lid (2).

Remove the water tank (4) from the filter jug (6). Make sure that the seal (7) is seated correctly in the base of the water tank (4) (fig. C).

Note: If the seal is missing or incorrectly fitted, unfiltered water may leak into the filter jug.

Put the filter cartridge (5) into the recess in the base of the water tank (4).

Press the filter cartridge (5) against the seal (7) and turn it clockwise to lock it in place (fig. D).

Make sure that the filter cartridge (5) is securely locked in place.

Put the water tank (4) into the filter jug (6). Fit the lid (2).

Fill the water tank (4) with cold water, the water will pass through the cartridge (5) into the filter jug (6).

Discard the water.

Repeat the process of filling and discarding once more. Fill the water tank (4), the filter jug (6) is now ready for use.

Filter cartridge life indicator (fig. E)

The cartridge life indicator (3) will remind you when to change the filter cartridge (5).

Note: It is recommended that the filter cartridge is changed every four weeks.

To set the cartridge life indicator (3):

5