Black & Decker VEC010BD User Manual

VEC010BD

KEY FEATURES:

• Rechargeable Jump-Start
System

• Easy-to-Read Charge
Indicators

•

Emergency Area Light

• Keyless ON/OFF Power
Switch

• 12 Volt DC Accessory
Outlet

• Battery Status Check

USER’S MANUAL

& WARRANTY INFORMATION

IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS

TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.

www.vectormfg.com

4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312 U.S.

Toll Free: [phone]

8

ST ART-IT

Jump-Starter

12 Volt DC Power Supply

Cordless • Rechargeable

TWO YEAR LIMITED WARRANTY PROGRAM

This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing, regarding this product. There is no other warranty , other than those
described herein.

This Vector Manufacturing product is warranted, to the original purchaser only, to be free of defects in
materials and workmanship for two years from the date of purchase without additional charge. The
warranty does not extend to subsequent purchasers or users. Vector Manufacturing will not be responsible
for any amount of damage in excess of the retail purchase price of the product under any circumstances.
Incidental and consequential damages are specifically excluded from coverage under this warranty.

This product is not intended for commercial use. This warranty does not apply to accessories or damage to
units from misuse or incorrect installation. Misuse includes wiring or connecting to improper polarity power
sources.

RETURN/REPAIR POLICY: Defective products, other than accessories, may be returned postage prepaid to
manufacturer. Any defective product, other than accessories, that is returned to manufacturer within 30 days
of the date of purchase will be replaced free of charge. If such a product is returned more than 30 days
but less than two years from the purchase date, manufacturer will repair the unit or, at its option, replace it
free of charge. If the unit is repaired, new or reconditioned replacement parts may be used, at Vector
Manufacturing’s option. A unit may be replaced with a new or reconditioned unit of the same or
comparable design. The repaired or replaced unit will then be warranted under the terms of the remainder
of the warranty period. The customer is responsible for the shipping charges on all returned items after 30
days. During the warranty period, manufacturer will be responsible for the return shipping charges.

LIMITATIONS: This warranty does not cover accessories, bulbs, fuses and batteries, defects resulting from
normal wear and tear (including chips, scratches, abrasions, discoloration or fading due to usage or
exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized
use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire, flood and
Acts of God.

If your problem is not covered by this warranty, call our Technical Support Department toll free at
[phone] for general repair information and charges if applicable. You may also contact us through
our website at www.vectormfg.com.

STATE LAW RIGHTS: This warranty gives you specific legal rights. Some states do not allow limitations on
how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages,
so the exclusions or limitations stated herein may not apply. This warranty gives the purchaser specific legal
rights; other rights, which vary from state to state, may apply.

TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact V ector Manufacturing Technical Support
by telephone, fax or mail (see below). We suggest that you keep the original packaging in case you need
to ship the unit. When returning a product, include your name, address, phone number, dated sales receipt
(or copy) and a description of the reason for return and product serial number. After repairing or replacing
the unit, we will make every effort to return it to you within four weeks.

WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Vector Manufacturing.
Enter “VEC010BD” as Model and “Jump-Starter” as Product Type. All Vector Manufacturing products must
be registered within 10 days of purchase to activate this warranty. Mail the completed registration form,
along with a copy of the original sales receipt to:

ATTN.: CUSTOMER SERVICE

4140 SW 30th Ave., Ft. Lauderdale, FL 33312

• TOLL FREE: [phone] • FAX: [phone] •

BD42905

© 2005 VECTOR MANUFACTURING

MADE IN CHINA

Vec010BD_Manual_042905 5/9/05 1:00 PM Page 8

iii

CAUTIONS
Use only the supplied cords/adapters for recharging this unit. Do not recharge for

more than 3-4 hours maximum using 12 volt DC method. Recharge unit after each use.
All on/off switches should be in the OFF position when the unit is charging or not in

use. Make sure all switches are in the OFF position before connection to a power
source or load.

Never insert anything other than the supplied power/recharging cords or
recommended appliance power/recharging cords into the 12 volt DC charging/power
socket on this unit. Do not use any accessory that is not recommended or provided by
the manufacturer.

Do not use this unit to operate appliances that draw more than 5 amps.
This system is not designed to be used as a replacement for a vehicular battery. Do

not attempt to operate a vehicle that does not have a battery installed.
Although this unit contains a non-spillable battery, it is recommended that it be kept

upright during storage, use and recharging. To avoid possible damage that may
shorten the unit’s working life, protect it from direct sunlight, direct heat and/or
moisture.

Check unit periodically for wear and tear. Replace worn or defective parts
immediately; contact the Customer Service Department at [phone].

Never submerge this unit in water, or expose it to rain or snow.
Keep unit out of reach of children (whether stored or in use).

SAVE THESE INSTRUCTIONS

ii

IMPORT ANT SAFETY INSTRUCTIONS

1. When working with lead acid batteries, always make sure immediate assistance is available in case
of accident or emergency.

2. Always use protective clothing and eyewear when using this product, contact with battery acid may
cause blindness and/or severe burns. Be aware of first aid procedures in case of accidental contact
with battery acid.

3. There is a risk of explosive gases being released when lead acid batteries are being charged or
discharged. Failure to follow instructions may cause property damage, explosive hazard, and/or
personal injury.

4. Make sure the power switch is OFF before connecting battery clamps to discharged batter y.

5. When charging unit from a 120 volt AC electrical outlet, in any wet or damp area, make sure that the
outlet used is protected by a ground fault interrupt (GFCI) outlet.

6. When charging the unit near water, do not allow the electrical cords and outlets to get wet; electrical
shock could result.

7. Jump-start procedures should only be performed in a safe, dr y, well-ventilated area.

8. Always store battery clamps when not in use. Never touch batter y clamps together – this can cause
dangerous sparks, power arcing, and/or explosion.

9. When using this unit in proximity to the vehicle’s battery and engine, stand the unit on a flat, stable
surface, and be sure to keep all clamps, cords, clothing and body parts away from moving vehicle
components.

10. Do not wear vinyl clothing when jump-starting a vehicle-friction can cause dangerous static electricity
sparks. Remove all jewelry or metal objects that could cause short circuits or react with batter y acid.

11. Always disconnect the negative (black) jumper cable first: followed by the positive (red) jumper cable.

12. Never allow red and black clamps to touch each other or another common metal conductor – this
could cause damage to the unit and/or create sparking/ explosion hazard. Always store battery
clamps when not in use.

13. Do not expose battery to fire or intense heat as it may explode. Before disposing of the battery, protect
exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

14. Do not smoke, use matches or cigarette lighters while working on a vehicle’s battery system.

15. All wires, cables, and cords must be positioned so they cannot be tripped over or damaged by moving
parts, pinching or abrading.

16. NEVER ATTEMPT TO JUMP-START A FROZEN BATTERY.

Note:

Read this manual and product labeling carefully before using. Follow
recommended warnings, cautions and safety procedures; as well as
manufacturer’s guidelines for your vehicle battery.

FIRST AID
Skin: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with

soap and water. If redness, pain, or irritation occurs, seek immediate medical attention.
Eyes: If batter y acid comes in contact with eyes, flush eyes immediately for a minimum of 15 minutes –

seek immediate medical attention.

Vec010BD_Manual_042905 5/9/05 1:00 PM Page ii