ADVANCED HANDHELD STEAMER
VAPORIZADOR DE MANO AVANZADO
use and care manual
manual de uso y cuidado
HGS350 Series
Serie HGS350
IMPORTANT SAFETY INSTRUCTIONS
When using your steamer, basic safety precautions should
always be followed, including the following:
• READ ALL INSTRUCTIONS BEFORE USING.
• To reduce the risk of contact with hot water emitting from
steam vents, check appliance before each use by holding it
away from body and operating steam button.
• Only use steamer for intended use.
• To reduce the risk of electric shock, do not immerse the
steamer in water or other liquids.
• Never pull on the cord to disconnect from the electrical
outlet; instead grasp plug and pull to disconnect. .
• Do not allow cord to touch hot surfaces. Let steamer
cool completely before putting away. Loop cord loosely
together and secure with provided Velcro strap when
storing.
• Always turn the steamer off by pressing and holding the
power button for 3 seconds, until the blue indicator light
turns off, and then unplug from the electric outlet before
filling with water, emptying, or cleaning, and when not in
use.
• Do not operate the steamer with a damaged cord, or if the
appliance has been dropped or damaged, or if it is leaking.
To reduce the risk of electric shock, do not disassemble or
attempt to repair the steamer; take it to a qualified service
person for examination and repair, or call the appropriate
toll-free number in this manual. Incorrect reassembly or
repair can cause a risk of fire, electric shock, or injury to
persons when the steamer is used.
• Close supervision is necessary for any appliance being
used by or near children. Do not leave the steamer
unattended while connected.
• Burns can occur from touching hot metal parts, hot water,
or steam. Use care when you turn a steam appliance upside
down – there may be hot water in the reservoir. Avoid rapid
movement of steamer to minimize hot water spillage.
• To reduce the likelihood of circuit overload, do not operate
another high wattage appliance on the same circuit.
• If an extension cord is absolutely necessary, a minimum
13-ampere cord should be used. Cords rated for less
amperage can result in a risk of fire or electrical shock due
to overheating. Care should be taken to arrange the cord
so that it cannot be pulled or tripped over.
• Do not use outdoors.
• Do not use anything other than water in the steamer while
in use or during cleaning.
• Never steam clothing while on a body.
• Never aim the steam directly towards people, animals
or plants. The steam is very hot and can results in burns.
Burns can occur from touching hot parts (including the
steamer head and frames), hot water, or steam.
• Never hold the steam head down while at rest or tilt it in a
backward position as this may result in hot water discharge
and possibly injury.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliances by a person responsible for their safety.
• To avoid burns, when putting on or taking off attachments,
be sure the unit is off and no steam is being emitted.
• Children should be supervised to ensure that they do not
play with the appliance.
• The steamer must be used and rested on a stable surface.
SAVE THESE INSTRUCTIONS.
This product is for household use only.
POLARIZED PLUG (120V models only)
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not
attempt to modify the plug in any way.
2
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a
tamper-resistant screw to prevent removal
of the outer cover. To reduce the risk of fire
or electrical shock, do not attempt to remove
the outer cover. There are no user-serviceable
parts inside. Repair should be done only by
authorized service personnel.
Note: If the power supply cord is damaged, in
order to avoid a hazard, it should be replaced
by qualified personnel.
GETTING TO KNOW YOUR STEAMER
1
2
3
9
4
6
5
11
7
8
10
1. Heated pressing plate
2. Steam trigger
3. Continuous steam switch
4. Comfort grip handle
5. Removable water tank
(Part # HGS350-01)
6. Power button (not shown)
Product may vary slightly from what is illustrated.
*Lint frame included in select models only.
• Remove all labels, tags and stickers attached to the body, or cord of the
steamer and the plastic band around the power plug.
• Remove and save literature.
• Read all the instructions before using your steamer.
IMPORTANT NOTES
• Using distilled, purified, or filtered water is highly recommended to maintain
optimal performance. Tap water contains minerals that build up over time.
• Any water droplets visible inside the tank are from individual quality
control tests done to ensure every steamer meets our high standards for
product performance.
• Do not put perfumes, oils, or other additives in the water tank.
• Always review the garment manufacturer’s care label instructions before
steaming, and always test fabrics for colorfastness in inconspicuous
areas (such as an inseam). Steamers are not recommended for use on
leather, suede, vinyl, plastic, or other steam sensitive fabrics.
• During use the steamer and accessories will become hot. Avoid
attaching or removing frames while still hot.
• After preheating, prime water pump by holding the steam trigger until
steam forms.
• It is normal to feel or hear the water pump in the handle.
• The water pump may become louder when the water level in the tank is
low. Check and refill tank, as needed.
ATTACHING FRAMES
The steamer comes with three optional-use attachment frames
recommended for use with a variety of fabrics and
upholstery.
1. Select the proper frame using the following chart.
2. While the frame and steamer are cool, gently attach
the top of the frame over the top the steamer head and
then click the bottom of the frame into place. (A)
Note: Frame tab points down when in correct position.
3. Allow steamer to cool prior to removing frame. Gently
pull on the tab. (B)
Note: Be careful when removing frames as condensation
may build up during use.
4
A
B
FrameUsage
Lint Frame
Garment Care Label: For any garments that call
for medium to high heat and allow for use of
steam.
Tip: Frame helps remove lint, hair, and animal fur.
Delicate Fabric Frame
Upholstery Frame
Garment Care Label: For any garments that call
for low heat and allow for use of steam.
Tip: For items with embellishment, turn the garment inside out to better remove wrinkles and
avoid damage to sensitive areas.
See how to use scent attachment below.
Upholstered Fabrics: Great for refreshing bedding, mattresses, curtains, plush toys, furniture,
and hard surfaces (such as counters or desks that
are not heat sensitive).
Tip: Always test for colorfastness and heat sensitivity on an inconspicuous area.
USING THE DELICATE FABRIC FRAME WITH
SCENT ATTACHMENT
The delicate fabric frame is most efficient with the scent
attachment inserted. You may use the scent attachment
with or without the foam pad inside. Adding scent is
optional and at your discretion.
1. To use the scent attachment as a diffuser, pull it from
the delicate fabric frame and put 4 to 8 drops or sprays
of perfume or essential oil on the small foam pad. (C)
2. Insert the scent attachment inside the delicate fabric
frame (D) and attach delicate fabric frame to the
steamer. Activate steam to diffuse the scent over the
fabric.
Note: Only put scent on the foam pad and not on any other
part of the fabric frame or in the water tank. Do not use other substances on
the scent attachment.
Caution: Keep perfume and essential oils away from eyes and mucous
membranes. Only use fragrance in a ventilated room. Do not use fragrance in
the presence of pregnant women, children under 8 years old, or anyone with
allergies, asthma, or a lung disease.
CC
DD
5
FILLING THE WATER TANK
1. Place the steamer on its base on a stable surface.
2. Hold the handle to stabilize and pull out the removable
water tank with the other hand. (E)
3. Gently pull out the rubber water tank cover at the top
of the tank. (F)
Tip: Using distilled, purified, or filtered water is highly
recommended and will reduce mineral buildup. Do not use
oils, perfumes, or scented additives.
4. Using a clean measuring cup, pour water into opening
until water reaches the “MAX” level mark on the top
of the tank. (G) Do not overfill. Close the rubber cover
securely.
5. Dry off any excess water from the tank. Push water
tank back into the steamer base; click into place.
6. To refill at any time during use, turn steamer off by
pressing the power button until the blue indicator
light is off, unplug from outlet, and follow the above
procedure.
Tip: After refilling, allow to reheat for 45 seconds and then prime pump by
holding steam trigger until steam forms.
EE
FF
GG
USING THE HANDHELD STEAMER
1. Read the manufacturer's fabric label to make sure the fabrics are
suitable for steaming.
• If you see “do not iron” or this icon
frame and make sure to test on an inconspicuous area prior to
steaming the entire garment.
• If you see “do not steam” or this icon
2. Refer to the “Attaching Frames” section for determining whether to use a
frame. Attach or remove frames while the steamer and frames are cool.
• Hang the garment in an area that will not be impacted by the heat
and steam, such as on a shower rod.
3. Plug the steamer into an outlet and then press the power
button. (H) The power button light will slowly blink,
indicating that the steamer is heating.
4. After about 45 seconds the power light will stay on,
indicating the steamer is preheated.
5. Prime the water pump by holding steam trigger until
steam forms.
, attach the delicate fabric
, do not steam the garment.
HH
6
6. To generate steam, press down on the steam trigger
with your index finger. (I) As long as the trigger is held
down, steam will emit from the steamer. When the
trigger is released, the steam will stop.
• To generate a constant flow of steam without holding
the trigger, press the steam trigger and then slide the
continuous steam switch down. (J) This will activate
the continuous steam feature. To turn the steam off,
press the trigger, push the continuous steam switch
up and then release trigger.
7. With your free hand keep the fabric taut. Steam the
garment with slow, downward strokes, keeping the head
of the steamer in contact with the fabric. (K)
Note: It is normal to feel or hear the water pump in the handle.
Note: If the steamer is left inactive, the auto shut-off
feature will activate, indicated by the rapidly blinking
Power Button. To resume steaming after the auto shut-off
is activated, either press the steam trigger or press the
power button. Allow the steamer to preheat if needed.
8. When finished steaming, press and hold the power button
until its blue light turns off (about 3 seconds) and unplug
from outlet. (L)
9. Stand steamer on its base and allow it to completely
cool off before storing. (M) To avoid mineral buildup,
empty the tank after each use.
II
JJ
KK
LL
Auto Shut-Off
The steamer will automatically switch to auto shut-off
mode after being left inactive for 15 minutes. The boiler and
water pump will turn off until reactivated. Rapid blinking of
the power button light indicates that the steamer is going
into auto shut-off mode. To resume steaming, press the
steam trigger or power button and wait for steamer to fully reheat.
Using Steam Around the Home
Using steam on items that can tolerate hot, damp steam without damage
is non-toxic, and inexpensive. Steam upholstery, draperies, linens and home
textiles to refresh.
MM
7
CLEANING AND CARE
This product contains no user serviceable parts. Refer to qualified service
personnel.
CLEANING STEAMER EXTERIOR
1. Make sure steamer is off, unplugged and completely cool.
2. Wipe the ironing plate and outer surface with soft, damp cloth. Water
and small amounts of gentle household soaps, such as dishwashing
liquid, can be used on the exterior. Never use heavy-duty cleaner, or
abrasive scouring pads that may scratch or discolor the steamer.
3. After the steamer has been thoroughly dried, turn it back on and lightly
steam over an old cloth. This will help remove any reside left in the
steam holes.
4. When finished cleaning, turn the steamer off by pressing the power
button until the blue power light turns off (about 3 seconds). Unplug,
empty tank, and allow time to cool before storing.
CLEANING FRAMES AND ACCESSORIES
For all accessories, allow to fully dry before using again or storing.
Accessories are not suitable for cleaning in a washing machine.
• Lint frame: Wipe with damp cloth to clean.
• Delicate frame: Wash with cold water and small amounts of gentle
cleanser if needed. The fabric in the frame cannot be removed. The foam
pad inside the scent attachment can be removed and hand washed with
warm water and a few drops of laundry detergent or dish soap.
• Upholstery frame: The fabric on this frame can be removed and hand
washed with cold water and gentle cleanser.
STORING THE STEAMER
1. Check that the steamer is unplugged and completely cool.
2. Gather the cord into even ovals and then gently cinch
with the strip of hook and loop. (N)
3. Always store steamer upright on its base to prevent
water leakage.
Tip: Emptying the tank after each use is recommended
because standing water can leave a residue over time.
NN
STEAMING TIPS AND TRICKS
• This steamer is designed to use distilled, purified, or filtered water. Tap
water contains minerals that build up. Using water with perfumes or
scented additives is also not recommended.
8
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.