Black & Decker GSR10 User Manual
Model/Modelo/Modèle
GSR10
USA/Canada 1-800-231-9786
Mexico 01-800-714-2503
www.blackanddecker.com
Accessories/Parts
(USA/Canada) 1-800-738-0245
Accesorios/Partes
(EE.UU/Canadá)
Accessoires/Pièces (É.-U./Canada)
PLEASE READ AND SAVE THIS USE AND CARE BOOK.
POR FAVOR LEA ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
VEUILLEZ LIRE ET CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION.
Stand Steamer
Vaporizador vertical de pie
Vaporisateur sur pied
GSR10Pub1000002369 6/14/05 4:57 PM Page 1
2
1
When using your appliance, basic precautions should always be
followed, including the following:
❑ Read all instructions.
❑ To reduce the risk of contact with hot water emitting from steam
vents, check appliance before each use by holding it away from body
and operating steam button.
❑ Use appliance only for its intended use.
❑ To reduce the risk of electric shock, do not immerse the appliance in
water or other liquids.
❑ Never yank cord to disconnect from outlet; instead, grasp plug and
pull to disconnect.
❑ Do not allow cord to touch hot surfaces. Let appliance cool
completely before putting away. Loop cord loosely around appliance
when storing.
❑ Always disconnect appliance from electrical outlet when filling with
water or emptying, and when not in use.
❑ Do not operate appliance with a damaged cord, or if the appliance
has been dropped or damaged.
❑ To reduce the risk of electric shock, do not disassemble or attempt to
repair the appliance, take it to a qualified service person for
examination and repair. Incorrect reassembly or repair could cause a
risk of fire, electric shock, or injury to persons when the appliance is
used.
❑ Close supervision is necessary for any appliance being used by or
near children. Do not leave appliance unattended while connected.
❑ Burns could occur from touching hot metal parts, hot water, or steam.
Use care when you turn a steam appliance upside down – there may
be hot water in the reservoir.
❑ To reduce the likelihood of circuit overload, do not operate another
high wattage appliance on the same circuit.
❑ If an extension cord is absolutely necessary, a 12.5 ampere rated cord
should be used. Cords rated for less amperage may overheat. Care
should be taken to arrange the cord so that the cord cannot be pulled
or tripped over.
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS.
GROUNDED PLUG
As a safety feature, this product is equipped with a grounded plug, which will
only fit into a three-prong outlet. Do not attempt to defeat this safety feature.
Improper connection of the grounding conductor may result in the risk of
electric shock. Consult a qualified electrician if you are in doubt as to
whether the outlet is properly grounded.
TAMPER-RESISTANT SCREW
Warning : This appliance is equipped with a tamper-resistant screw to
prevent removal of the outer cover. To reduce the risk of fire or electric
shock, do not attempt to remove the outer cover. There are no user-
serviceable parts inside. Repair should be done only
by authorized
service personnel.
Note: If the power supply cord is damaged, it should be replaced by
qualified personnel or in Latin America by an authorized service center
Thank you for purchasing the Black and Decker®Garment Steamer.
Your new Garment Steamer will change the way you press garments
forever. Up to one hour of continuous steam and a telescopic design
give you maximum flexibility to smooth away the wrinkles from hanging
garments, drapes and even upholstery without having to use an iron
or ironing board.
GSR10Pub1000002369 6/14/05 4:57 PM Page 2
4
3
1. Telescopic pole
2. Lint brush attachment
3. Flexible hose
4. Unit with water tank
5. Trouser clamps holder assembly
6. Trouser clamps
7. Steam nozzle/hanger holder and cord wrap assembly
†1.Steam nozzle holder
(Part # GSR10-03)
2. Steam nozzle
3. Steam nozzle button
†4.Lint brush attachment
(Part # GSR10-01)
5. Hanger holder
6. Clip for keeping hanger in place
7. Cord wrap
8. Telescopic pole
†9.Flexible hose
(Part # GSR10-08)
† 10. Trouser clamps (Part # GSR10-02)
†11. Trouser clamps holder
(Part # GSR10-05)
† 12. Lock nut for telescopic pole
(Part # GSR10-04)
† 13. Removable water tank
(Part # GSR10-06)
† 14. Water tank cap (not shown)
(Part # GSR10-07)
† 15. Wheel casters
(Part # GSR10-09)
16. Steam On/Off switch with
indicator lights
†Consumer replaceable
UNPACKING BOX CONTENTS
Important: For warranty verification, please do not remove line cord
sticker.
After you unpack your unit, verify that you received the following
parts (A):
GETTING FAMILIAR WITH YOUR UNIT
A
B
GSR10Pub1000002369 6/14/05 4:57 PM Page 4
ASSEMBLING YOUR UNIT
Inserting Flexible Hose
1. To connect the flexible hose, align connector prongs with
holes on the unit and push inside the connector (C).
2. Slide the lock nut through the hose all the way to the end.
3. Place lock nut over the unit connector and twist clockwise
tightly in place (D).
Inserting Trouser Clamps Holder Assembly
For your convenience the trouser clamps can be used as a
regular clip hanger at the top of the telescopic pole or to clip the
bottoms of the pants.
1. Loosen the holder lock nut by turning it counterclockwise.
2. Find the slot at the bottom of the pole, insert and slide holder
assembly with holder facing as shown (E).
Note: If using the trouser clamps as a regular clip hanger, slide
the holder assembly to the top of the pole.
3. Secure assembly in place by twisting the lock nut clockwise
until it is tight (F).
Tip: Make sure the trouser holder is in the upright position.
4. Insert and push trouser clamp bar securely into the holder.
Inserting Telescopic Tube
1. With the trouser clamp holder in place, remove the lock nut
from the unit connector by turning it counterclockwise (G).
2. Insert and slide the narrow end of the lock nut through the flat
end of the telescopic pole (H).
3. Hold the telescopic pole and insert into the connector.
a. Look inside the connector and find the alignment notch (J).
b.Take the telescopic pole, align the open slot at the end with
the notch inside the connector and push the telescopic pole
all the way inside the connector. You might have to wiggle
it to fit in.
Important: The slot on the telescopic pole must slide over the
notch inside the connector for the pole to slide into position.
4. Once the telescopic pole is inside the connector, twist the lock
nut clockwise until tight (K).
Inserting Steam Nozzle Holder Assembly
1. Pull up one extension tube at time and tighten each lock nut
by twisting clockwise (L).
2. Insert steam nozzle holder assembly at the top of the
telescopic pole and rotate it clockwise until securely
in place (M).
Steam Nozzle
1. Insert steam nozzle into its holder (N).
2. Attach the lint brush to the nozzle by inserting end tabs
into the nozzle slots (P).
Your unit is now assembled!
How to Use
This appliance is for household use only.
GETTING STARTED
Filling Water Tank
1. Make sure the unit is unplugged.
2. Place unit on the floor.
3. Grasp water tank handle and remove water tank.
4. Turn the water tank upside down and remove the cap by
turning it counterclockwise (Q).
5. Fill the water tank with water.
Important: Do not add cleaning solutions or any other chemicals
to the water in the tank. Only use regular tap water.
6. Replace the cap and tighten by turning it clockwise.
7. Insert water tank back into the unit securely in place.
STEAMING GARMENTS
Trousers
1. Make sure the unit is Off.
2. Using a clip hanger, hang the pants by the waist on the
hanger holder.
3. Stretch the pants and clip the bottoms using the trouser
clamps or move the trouser clamps holder to the top of
the pole and using the trouser clamps, hang the pants by
the waist (R).
Note: To steam other hanging garments, just hang your clothes on a regular
hanger on the hanger holder.
6
5
C
D
E
F
G
H
J
K
M
R
L
N
P
Q
or
GSR10Pub1000002369 6/14/05 4:57 PM Page 6
8
7
4. Plug in the unit into an electrical outlet.
5. Press the On/Off (I/0) switch (S).
6. Remove the steam nozzle from its holder facing upward, away
from you and press the Steam button (T). The indicator lights
on the unit illuminate and in a few seconds steam is released.
Important:
• Never place your hand in front of steam nozzle where steam
is being released.
• Do not leave the steam nozzle in one area for a long period of
time because the garment will get wet.
7. Use the lint brush to remove lint from the fabric as it steams.
Automatic Shutoff
The unit shuts off automatically:
• After 30 minutes of inactivity
• If water tank is empty
To use the unit again, turn Off then On and resume operation.
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service
personnel.
Cleaning
1. Make sure the unit is off.
2. Wait for the unit to cool down completely before draining the water tank.
3. Remove water tank and drain any remaining water.
4. Wipe the outside surface with a damp cloth. Never immerse the unit in water
or other liquids.
Storage
• Make sure unit is off and unplugged.
• Unit stores vertically for compact storage. If you need more height, you can
adjust the extension tubes.
• Insert the steam nozzle in its holder and wrap the cord around the cord wrap.
Important: If you want to leave your unit ready for daily use, just leave the water
tank filled and in place.
S
T
PROBLEM CAUSE SOLUTION
Steamer Does 1. Steamer is not plugged 1. Plug power cord into
Not Get Hot into electrical outlet. electrical outlet.
2. Flexible hose is not 2. Check flexible hose
connected properly. connection.
3. Unit shuts off 3. Turn off unit then
automatically. on again.
No Steam Water level is too low. Refill the water tank
following instructions
on page 6
Water Drips Condensation has formed Hold the steamer hose
From The inside the steamer hose. upright fully extended and
Steam Nozzle allow excess moisture to
drain back in the water
reservoir.
TROUBLESHOOTING
GSR10Pub1000002369 6/14/05 4:57 PM Page 8
10
9
Al utilizar el aparato eléctrico siempre deben tomarse precauciones
básicas de seguridad, incluyendo las siguientes
❑ Lea todas las instrucciones.
❑ Para reducer el riesgo de contacto con el agua caliente que emiten
las salidas de vapor, examine el aparato antes de cada uso. Para ello,
sosténgalo alejado de su cuerpo y oprima el botón de vapor.
❑ Utilice el aparato solamente con el fin provisto.
❑ Para reducir el riesgo de choque eléctrico, no sumerja el aparato en
agua ni en ningún otro líquido.
❑ Nunca tire del cable para desconectarlo, sujete el enchufe para
hacerlo.
❑ No permita que el cable entre en contacto con superficies calientes.
Permita que el aparato se enfríe antes de guardarlo. Enrolle el cable
holgadamente alrededor del aparato.
❑ Siempre desconecte el aparato cuando lo llene con agua o lo vacíe y
cuando no esté en uso.
❑ No utilice el aparato si tiene el cable o el enchufe averiado, si se ha
caído o si está dañado.
❑ Para reducir el riesgo de un choque eléctrico, no desarme el aparato
ni intente repararlo; llévelo a un agente de servicio calificado para
que pueda examinarlo o repararlo. El armarlo o repararlo
incorrectamente podrían ocasionar un riesgo de incendio, choque
eléctrico o lesiones personales al utilizar el aparato.
❑ La supervisión de un adulto es necesaria cuando el aparato es
utilizado por niños o cerca de ellos. No deje el aparato sin
supervisión mientras está conectado.
❑ Pueden producirse quemaduras al tocar partes metálicas calientes,
agua caliente o vapor. Tenga cuidado al invertir un aparato de vapor
ya que puede quedar agua caliente en el tanque.
❑ Para reducir la posibilidad de una sobrecarga, no opere ningún otro
aparato de alto consumo de corriente en el mismo circuito.
MEDIDAS IMPORTANTES
DE SEGURIDAD
CONSERVE ESTAS
INSTRUCCIONES.
ENCHUFE DE TIERRA:
Como medida de seguridad, este producto cuenta con un enchufe de tierra
que tiene tres contactos. No trate de alterar esta medida de seguridad. La
conexión inapropiada del conductor de tierra puede resultar en un riesgo de
choque eléctrico. Si tiene alguna duda, consulte con un eléctricista calificado
para asegurarse de que la toma de corriente sea una de tierra.
TORNILLO DE SEGURIDAD
Advertencia: Este aparato cuenta con un tornillo de seguridad para evitar
la remoción de la cubierta exterior del mismo. A fin de reducir el riesgo
de incendio o de choque eléctrico, por favor no trate de remover la
cubierta exterior. Este producto no contiene piezas reparables por el
consumidor. Toda reparación se debe llevar a cabo únicamente por
personal de servicio autorizado
Nota: Si el cordón de alimentación es dañado, en América Latina debe
sustituirse por personal calificado o por el centro de servicio autorizado.
❑ En caso de que se necesite una extensión, se debe emplear un cable
con capacidad de 12.5 amperios. Los cables de extensión de menos
amperaje pueden sobrecalentarse. La extensión debe colocarse de
manera que nadie se enrede ni se tropiece con ella.
Gracias por comprar un vaporizador vertical Black and Decker®.
Con el nuevo vaporizador vertical ya no volverá a planchar sus prendas
de la misma manera. Su diseño telescópico y vapor continuo de hasta una
hora de duración le otorgan la máxima flexibilidad para suavizar arrugas
de prendas de vestir, cortinas e incluso tapicería sin necesidad de usar una
plancha convencional o una tabla de planchar.
GSR10Pub1000002369 6/14/05 4:57 PM Page 10
Loading...