Black & Decker CO75, CO85BM, CO85 User Manual

Please Read and Save this Use and Care Book Por favor lea este instructivo antes de usar el producto Veuillez lire et conserver ce guide d’entretien et d’utilisation

††Spacemaker

Can Openers Abrelatas Ouvre-boîte

Accessories/Parts (USA/Canada) Accesorios/Partes (EE.UU/Canadá) Accessoires/Pièces (É.-U./Canada) 1-800-738-0245

Models Modelos Modèles

❑

CO75

❑

CO85

❑

CO85BM

USA/Canada 1-800-231-9786 Mexico 01-800-714-2503

www.blackanddecker.com

CO75Pub600066R1 7/21/06 3:18 PM Page 1

When using electrical appliances, basic safety precautions should always be followed, including the following:

❑ Read all instructions. ❑ To protect against electrical hazards, do not immerse appliance in water

or other liquid.

❑ Close supervision is necessary when any appliance is used by or near

children.

❑ Unplug from outlet when not in use, before putting on or taking off parts,

and before cleaning.

❑ Avoid contact with moving parts. ❑ Do not operate any appliance with a damaged cord or plug, or after the

appliance malfunctions, or has been dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.

❑ The use of attachments not recommended or sold by the appliance

manufacturer may cause fire, electric shock or injury.

❑ Do not use outdoors. ❑ Do not let cord hang over edge of table or counter or touch hot surfaces. ❑ Do not open pressurized (aerosol-type) cans. ❑ Do not open cans of flammable liquids such as lighter fluids ❑ Do not use appliance for other than intended use. ❑ To reduce the risk of fire or electric shock, do not operate any heating

appliance beneath the mounted unit.

❑ Do not mount the storage bracket/unit over or near any portion of a heating

or cooking appliance or a sink or basin.

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS.

POLARIZED PLUG

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.

ELECTRICAL CORD

The cord of this appliance was selected to reduce the possibility of tangling in or tripping over a longer cord. If more length is needed, use an extension cord rated no less than 15-amperes. (For 220 volts rated products, use an extension cord rated no less than 6-amperes). When using an extension cord, do not let it drape over the working area or dangle where someone could accidentally trip over it. Handle cord carefully for longer life; avoid jerking or straining it at outlet and appliance connections.

TAMPER-RESISTANT SCREW Warning : This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electric shock, do not attempt to remove the outer cover. There are no user-serviceable parts inside.

Repair should be done only

by authorized service personnel.

Note: If the power supply cord is damaged, it should be replaced by qualified personnel or in Latin America by an authorized service center.

CO75Pub600066R1 7/21/06 3:18 PM Page 2

Product may vary slightly from what is illustrated.

How to Use

This product is for household use only.

Important: For warranty verification, do not remove line cord sticker. UNPACKING BOX CONTENTS

1. Remove the unit from the cardboard packaging.

2. Remove the blade assembly from cardboard insert and any stickers attached to the blade assembly. To replace blade assembly, follow instructions under Care and Cleaning, Replacing Blade Assembly.

3. Verify that you have received 4 mounting washers with 4 mounting screws, (2) 1/2" and (2) 1/4" spacer mounting assemblies.

CHOOSING A MOUNTING LOCATION Important: Do not try to open cans or sharpen knives unless the unit is properly

mounted. When selecting a mounting location:

• Consider your normal work pattern and the possible addition of other under-the-

cabinet appliances.

• To reduce risk of fire or electric shock, do not place any heating or cooking appliance

under the unit.

• Do not mount near or over a sink.

• Do not mount the unit behind, under or in front of under-cabinet lighting appliances.

• Be sure to mount the can opener within reach of an electrical outlet.

INSTALLING YOUR CAN OPENER

1. First, determine if your cabinet has a flat bottom (A) —or an overhang (lip extending down) bottom (B).

2. If your cabinet has a flat bottom, you will need to use one 1/2" spacer mounting assembly.

3. If it has an overhang, measure the overhang with a ruler to determine how many 1/2" or 1/4"spacer mounting assemblies you will need. For example, if the measurement is 1", then use two 1/2" spacer mounting assemblies.

4. With the doors of the cabinet open, use the spacer mounting assembly as a guide to mark one rear and one front hole.

5. a. If your cabinet has an overhang:

Slide the mounting assembly forward until one side of the assembly touches the inside surface of the overhang.

b. If your cabinet has a flat bottom:

Place the mounting assembly approximately 1/4"-1/2" back from the front edge of the cabinet. Important: Be sure the

can opener is not set too far back.

6. Close the cabinet door, hold the unit up to the cabinet floor, and lift the lever to be sure it clears the cabinet door (C).

1. Locating post (not shown)

2. Cord storage (not shown)

3. Piercing lever

4. Knife sharpener (Models CO85 & CO85BM)

†5. Blade assembly with magnet

White Blade (Part# CO75-01) Black Blade (Part# CO85BM-01)

6. Bottle opener

†7.4 mounting washers and 4 mounting screws

(2) 1/2", (2) 1/4" spacer mounting assemblies (Part # CO75-02)

† Consumer replaceable/removable parts















Flush Bottom

Overhang Bottom

CO75Pub600066R1 7/21/06 3:18 PM Page 4

7. Mark the 4 holes through the assembly onto the underside

of the cabinet with a pencil (D).

8. Remove the spacer mounting assembly.

9. Empty the contents from the bottom shelf. Be sure the underside of the cabinet is free of grease or dirt.

10. Cover the countertop to catch wood chips from drilling.

Caution: Wear eye protection to prevent injury from shavings when drilling.

11. Make a small starter hole by hammering a nail or using a small drill bit.

12. Hold the 1/4" drill vertically at the hole marks and drill up through the bottom of the cabinet.

13. Place a plastic washer on each screw with the flat side of the washer resting on the cabinet shelf (E).

14. For a flat bottom cabinet: a. Drop the screw through the drilled hole from inside the cabinet. b. Repeat the procedure with the remaining screw and washer.

For cabinets with an overhang: Push the proper number of spacer assemblies onto the screws coming through the

cabinet bottom.

15. Line up the 4 holes in the top of the can opener with the exposed screws beneath

the spacer assemblies and tightenthe screws into the top of the can opener.

16. Pull out the cord form the cord storage and plug into electric outlet.

Your unit is ready for use!

OPENING A CAN

1. Lift the piercing lever.

2. Tip the can so that the rim is under the locating post, then push down on the lever, making sure the cutter blade is inside the rim (F).

Note: Because of the hands-free feature, it is not necessary to hold the lever down or hold the can during cutting. However, you may have to support very tall or heavy cans.

Tip: When the can is opened, the can opener will stop automatically.

3. To remove the can, hold it with one hand and raise the lever with the other. Caution: Avoid contact with the cut edges of the can or lids — they are sharp. Carefully

discard the lid from the magnet.

USING KNIFE SHARPENER (models CO85 & CO85BM)

1. For best results, sharpen the entire blade length in one continuous stroke carefully pressing down on the blade as you pull it through the slot (G).

2. Repeat for desired sharpness.

Important Tips:

• Use caution when washing and drying knives after sharpening.

• Do not sharpen serrated blades, as this will smooth their edges.

• Do not sharpen scissors.

USING BOTTLE OPENER

1. Grasp the bottle.

2. Position the cap under the metal "hook" and pull sideways

to the right (H).

Important Tips:

• Do not use this can opener to open cans with a pull tab, peel-off foil seal, or rolling key, rimless cans or cans with angled corner.

• Open frozen juices or foods in cardboard cans right from the freezer. Aluminum lids will not stick to the magnet.

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified service personnel.

Important: Unplug the cord before cleaning the unit.

REMOVING BLADE ASSEMBLY

1. Lift the piercing lever up as far as it will go.

2. Carefully grip the blade assembly and pull it away from the can

opener (J).

3. Wash in sudsy water by hand and dry thoroughly. Do not put the blade assembly in the dishwasher.

4. Before replacing the blade assembly, wipe the can opener body, knife sharpener (Models CO85 & CO85BM) and area around the geared wheel with a slightly damp cloth or sponge.

REPLACING BLADE ASSEMBLY

1. Align key post on the blade assembly with key slot on the unit (K).

2. Push in blade assembly and turn clockwise until it locks into position (L).

CO75Pub600066R1 7/21/06 3:18 PM Page 6

+ 9 hidden pages