Black & Decker CMD3400MBC User Manual

Please Read and Save this Use and Care Book Veuillez lire et conserver ce guide d’entretien et d’utilisation
12-Cup Programmable Coffeemaker
* Filters not included. * Filtres non compris.
IMPORTANT / IMPORTANT
WASH CARAFE BEFORE FIRST USE!
LAVER LA CARAFE AVANT
LA PREMIÈRE UTILISATION!
USA/Canada 1-800-231-9786
www.applicaconsumerproductsinc.com
Accessories/Parts (USA/Canada) Accessoires/Pièces (É.-U./Canada) 1-800-738-0245
Model Modèle
CMD3400MBC
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following:
Read all instructions.
Do not touch hot surfaces. Use handle or knobs.
To protect against electric shock, do not place cord, plug or appliance in water or other liquids.
Close supervision is necessary when any appliance is used by or near children.
Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts and before cleaning the appliance.
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair, or adjustment. Or, call the appropriate toll-free number on the cover of this manual.
The use of an accessory not evaluated for use with this appliance may cause injuries.
Do not use outdoors.
Do not let cord hang over the edge of table or counter, or touch hot surfaces.
Do not place on or near a hot gas or electric burner or in a heated oven.
Keep the lid on the carafe when in use.
The carafe is designed for use with the appliance. It must never be used on a range top.
Do not clean the carafe with abrasive cleansers, steel wool, or other abrasives material.
Do not set a hot carafe down on a wet or cold surface. Do not use the carafe if the glass is cracked or has a loose or weakened
handle.
Do not use this appliance for other than intended use.
To disconnect, turn any control to off, then remove plug from wall outlet.
Scalding may occur if the lid is removed during the brewing cycles.
POLARIZED PLUG (120V Models Only)
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW Warning : This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electric shock, do not attempt to remove the outer cover. There are no user-serviceable parts inside. Repair should be done only by authorized service personnel.
ELECTRICAL CORD
a) A short power-supply cord (or detachable power-supply cord) is to be provided
to reduce the risk resulting from becoming entangled in or tripping over a longer cord.
b) Longer detachable power-supply cords or extension cords are available and
may be used if care is exercised in their use.
c) If a long detachable power-supply cord or extension cord is used,
1) The marked electrical rating of the detachable power-supply cord or extension cord should be at least as great as the electrical rating of the appliance,
2) If the appliance is of the grounded type, the extension cord should be a grounding-type 3-wire cord, and
3) The longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.
Note: If the power supply cord is damaged, it should be replaced by qualified personnel or in Latin America by an authorized service center.
SAVE THESE INSTRUCTIONS.
This product is for household use only.
21
TABLE OF CONTENTS
OPEN
-12
MA
X
-1
0
-2
-
8
-
6
-4
12:00
-
+
P R OG
H R
MIN
GETTING FAMILIAR WITH YOUR UNIT
Pages
Getting Familiar with Your Unit ................................................4
Control Panel ..........................................................................5
Getting Started .........................................................................6
Water Filter .............................................................................6
Water Filter Replacement ........................................................7
Setting the Clock ..................................................................... 7
Brewing Coffee ........................................................................7
Sneak-A-Cup® Interrupt Feature ..............................................8
Temperature Control for Warming Plate ...................................8
Delayed Brewing .....................................................................9
Coffee Brewing Tips ................................................................9
Care and Cleaning ..................................................................10
Treat Carafe with Care ............................................................10
Water Filter Holder .................................................................10
Mineral Deposits and Clogging ..............................................11
INTRODUCTION
Thank you for choosing the Black & Decker® 12-Cup Programmable Coffeemaker. Your new coffeemaker comes with an easy-to-set timer so you can wake up to the aroma and taste of fresh-brewed coffee anytime. Cannot wait until brewing cycle is finished? The Sneak-A-Cup® Interrupt Feature makes it easy to grab a cup before brewing is done.
3
1. Backlit LCD display and control panel
2. Flip-up water reservoir cover †3. Water filter holder and Carbon filter
(Part # DCM3000-WF) (inside water reservoir) (Call the 800 number on the front cover for replacements)
4. Brew basket compartment release button
5. Backlit water reservoir with cup level markings
6. Sneak-A-Cup® interrupt feature
Product may vary slightly from what is illustrated.
Perfect Pour® Carafe
Water Filter
Freshness Indicator
7. Water-fill and brewed-coffee markings †8. 12-cup/60-oz. (1800 ml)
Perfect Pour® glass carafe (Part # DCM3000-GLASS)
9. Warming plate †10. Coffee scoop
(Part # DCM3000-SCOOP)
11. Brew basket compartment †12. Removable brew basket
(Part # CMD3400-BREW) †Consumer replaceable/removable parts
Brew Strength
4
Audible Ready Signal
Adjustable Warming Plate Temperature
Sneak-A-
®
Cup
OPEN
-12
M
AX
-1
0
-8
-6
-
+
O
PEN
-1
2
MA
X
-1
0
-2
-8
-
6
-4
-
+
P
R O G
HR
MI N
CONTROL PANEL
6:00
AM
FRESH
-
+
AUTO
-
+
PROG
HR
MIN
1. Backlit LCD display Shows:
• Current time of day
• Preset auto brew cycle
• Freshness indicator
• Temperature bar for warming plate
2. Auto Button: Activates the auto brewing function.
3. Brew Strength Button: Allows you to select Mild, Regular or Strong coffee
4. Min Button: Sets desired minutes.
5. Temperature Control for Warming Plate: Press the left or right button to decrease or increase the temperature of the warming plate.
6. Hour Button: Sets desired hour.
7. Prog Button: Allows you to select a specific time for brewing coffee.
8. Power Button: Unit comes on and starts brewing cycle or unit shuts off and cancels brewing cycle.
How to Use
This product is for household use only.
GETTING STARTED
• Remove all packing material, and any stickers from the product.
• Remove and save literature.
• Wash all removable parts as instructed in Care and Cleaning section of this
manual.
• Uncoil power cord and plug into standard electrical outlet.
• Open water reservoir cover and pour fresh cold water up to 12-cup level mark into the water reservoir (A).
A
B
Brew water through unit without adding coffee grounds. Note: This removes any dust or residue that may remain in the system during the
manufacturing process.
• Discard the water from the carafe and paper filter from brew basket.
• Press the Power button to shut off the unit.
• Unplug the unit and allow it to cool down.
WATER FILTER:
C
D
• Close water reservoir cover.
• Press brew basket compartment release button to open.
• Take out removable brew basket.
• Place empty 8 to 12 cup paper filter into removable brew basket.
• Place basket into brew basket compartment (B).
• Close brew basket compartment until is snaps into place.
• Place empty carafe on warming plate.
1. Remove carbon filter from packing material.
2. Press latch on filter holder to open (C).
3. Place carbon filter inside.
4. Close the filter holder tightly until it snaps into place (D).
5
6
5. Place filter holder inside the water reservoir and insert it
12:00
AM
-
+
PROG
HR
MIN
O
PEN
-1
2
MA
X
-1
0
-2
-8
-
6
-4
-
+
P RO G
HR
M
I N
OPEN
-1
2
M
AX
-1
0
-8
-6
-4
-2
-
+
-
+
P
R O
G
HR
MI N
6:20
AM
NOT FRESH
-
+
PROG
HR
MIN
6:00
AM
FRESH
-
+
PROG
HR
MIN
PROG
AUTO
BREW
STRENGTH
MILD
REGULAR
STRONG
6:00
AM
FRESH
-
+
AUTO
-
+
HR
MIN
into the recess at the bottom right hand corner (E).
Note: Replace carbon filter every 60 brewing cycles or
every 2 months after removing it from the sealed package.
(Call the 800 number on the front cover for replacements).
E
WATER FILTER REPLACEMENT:
1. Press latch on filter holder to open (see illustration C).
2. Dispose of old carbon filter.
3. Remove new carbon filter from packing material.
4. Place new carbon filter inside filter holder.
5. Close the filter holder tightly until it snaps into place (see illustration D).
6. Place filter holder inside the water reservoir and insert it into the recess at the
bottom right hand corner (see illustration E).
Note: Replace carbon filter every 60 brewing cycles or every 2 months after removing it from the sealed package. (Call the 800 number on the front cover for
replacements). SETTING THE CLOCK:
1. Plug appliance into standard electrical outlet.
2. The digital clock display flashes 12:00 A.M. (F).
3. To change the time: Press HR button until the correct time appears on the display. Repeat with the Min button.
Tip: Holding the button down makes the hours and minutes
F
change rapidly after a short delay; tapping changes the time in 1 minute increments.
Note: If the unit is unplugged or power is interrupted even momentarily, the time will need to be reset.
BREWING COFFEE:
1. Plug cord into a standard electrical outlet.
2. Open water reservoir cover.
3. Fill carafe with desired amount of cold tap water using the water markings on the carafe; pour into water reservoir (G).
Note: Do not exceed the 12-cup maximum level.
4. Close water reservoir cover securely.
G
5. Press brew basket compartment release button to open.
6. Place 8 to 12 cup basket style paper filter into the
removable brew basket (H).
7. Add desired amount of ground coffee.
8. Close brew basket compartment securely.
9. Place empty carafe on the warming plate.
7
H
10. Select the brew strength desired by pressing the Brew Strength button and selecting one of the 3 levels desired (J):
• Mild
• Regular
• Strong
Note: The Brew Strength can be selected before or after
J
brewing begins.
11. Press the Power button and brewing begins. Note: To delay brewing see, Delayed Brewing section.
12. The unit will beep 3 times when the brewing cycle is complete.
13. Once the brewing cycle is complete the word Fresh and the Fresh icon will appear on the digital display (K).
K
14. After 20 minutes the digital display will change to Not Fresh and the icon will also indicate the same (L).
15. Keep carafe on the warming plate between servings to preserve the temperature of the coffee
L
in the carafe.
16. Once coffee grounds have cooled, press brew basket compartment release button to open.
17. Use basket handle to remove and discard used grounds and paper filter. Replace basket and close brew basket compartment.
18. The coffee maker automatically shuts off after 2 hours.
19. Unplug appliance when not in use.
SNEAK-A-CUP® INTERRUPT FEATURE
The Sneak-A-Cup® feature allows you to pour a cup of coffee from the carafe while the coffee is brewing. When the carafe is removed the brewing process is paused. Simply replace the carafe on the warming plate within 30 seconds and brewing resumes.
TEMPERATURE CONTROL FOR WARMING PLATE
This coffeemaker has a temperature selector gauge for the warming plate on the control panel.
1. By pressing the left or right button you can decrease or
increase the temperature of the warming plate (M).
2. The bar on the LCD gives a visual display of the amount of heat of the warming plate.
M
8
Loading...
+ 10 hidden pages