Black & Decker BHFEA420J, BHFEA515J, BHFEA520J User Manual

Page 1
21
3
4
5
6
13
12
7
8
11
9
www.blackanddecker.com.au www.blackanddecker.co.nz
10
BHFEA420J BHFEA515J BHFEA520J
Page 2
12
12a
7a
7
8
A B
11a
11
7a
3
2
C
D
4
1
5
E
F
Page 3
6
6
5
G
H
6 6a
9
9a
I
J
13
9b
K
L
Page 4
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKER BHFEA420J, BHFEA515J, BHFEA520J cordless vacuum cleaners have been designed for vacuum cleaning purposes. These appliances are intended for household use only.
Read all of this manual carefully before operating the appliance.
Safety instructions
Warning! Read all safety
@
warnings and all instructions.
Failure to follow the warnings and instructions listed below may
result in electric shock, re and/or
serious injury.
u The intended use is described in this
manual. The use of any accessory or attachment or the performance of any operation with this appliance other than those recommended in this instruction manual may present a risk of personal injury.
u Retain this manual for future
reference.
u This appliance contains batteries
that are only replaceable by skilled persons.
Using your appliance
u Do not use the appliance to pick up
liquids or any materials that could
catch re.
u Do not use without dust bag and/or
lters in place
u Do not use the appliance near water. u Do not immerse the appliance in water.
u Never pull the charger lead to
disconnect the charger from the socket. Keep the charger lead away from heat, oil and sharp edges.
u This appliance can be used by
children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Inspection and repairs
Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the lead is damaged or defective.
u Never attempt to remove or replace
any parts other than those specied in
this manual.
Page 5
(Original instructions)
ENGLISH
Additional safety instructions
After use
u Unplug the charger before cleaning the
charger or charging base.
u When not in use, the appliance should
be stored in a dry place.
u Children should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from misuse, prolonged use etc. Even with the application of the relevant safety regulations and the implementa­tion of safety devices, certain residual risks can not be avoided. These include:
u Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for prolonged periods ensure you take regular breaks.
u Impairment of hearing. u Health hazards caused by breathing
dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specic voltage. Always check that the
mains voltage corresponds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the appliance with which it was supplied. Other batteries could burst, causing personal injury and damage.
u Never attempt to charge non-
rechargeable batteries.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an authorised BLACK+DECKER Service Centre in order to avoid a hazard.
u Do not expose the charger to water. u Do not open the charger. u Do not probe the charger. u The appliance/battery must be
placed in a well ventilated area when charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
#
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
$
Labels on appliance
The following symbols appear on this appliance along with the date code
Read all of this manual carefully before using the appliance
S010QS2300040
use charger S010QS2300040
Page 6
ENGLISH
(Original instructions)
Features
This tool includes some or all of the following features.
1. On/off power button
2. Charging port
3. State of charge indicator
4. Dust bowl relase button
5. Clear dust bowl
6. Cyclonic lter assembly
7. Extension pole release button
8. Extension pole
9. Floorhead (with in-built oor sense)
10. Beater bar release button
11. Crevice tool
12. Charger
13. Storage station
Assembly (Fig. A)
u Align the top of the extension tube (8) with the vacuum
inlet (7a) as shown in Fig. A.
u Push the extension tube (8) onto the vacuum inlet (7a) so
it locks into position.
u To remove an the extension tube, press the extension
tube release button (7) and gently pull the extension tube off.
Warning! When not in use position the unit with the rear of the vacuum facing a wall so that any inadvertent fall of the unit would contact a wall and not people or pets.
Charging the battery (Fig. B)
Warning! Use only with the supplied charger.
From new, the rechargeable cells of the product need a minimum charge time of 5 hours to ensure full power.
u The unit must be turned Off in order to charge. u Plug the jack plug (12a) of the charger (12) into the charg-
ing port (2) of the vacuum.
u Plug the charger into a standard electrical outlet. u While charging, the charger may get warm, this
is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indenitely. The
charger automatically reduces power consumption when charging is complete.
Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C. Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase risk of fire.
State of charge indicator (Fig. C)
This appliance include a state of charge indicator (3) which consists of three LED lights that indicate the level of charge remaining in the battery. This feature is only activated when the vacuum is powered on and when the vacuum is on
charge. The state of charge indicator is an indication of approximate levels of charge remaining in the battery pack. The LED battery indicator displays the remaining charge
and warns you when the battery is low. The nal LED will ash continuously when there is only very little runtime
remaining.
Note: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool functionality and is subject to variation based on product components, temperature and end-user application.
Use
This vacuum cleaner can be used in one of two ways.
u With the extension tube (8) and the oor head (9) as. u With the crevice tool (11) and the vacuum.
Mounting accessories (Fig. D)
u The crevice tool (11) allows for vacuuming in narrow and
hard to-reach places.
u To attach the crevice tool (11) press into vacuum inlet (7a)
so it locks into position as shown in gure D.
u To release the crevice tool (11) press the crevice tool
release button (11a) and gently pull the extension tube off.
Switching ON and OFF (Fig. E)
u To switch ON, push the on/off power button (1). u For increased power, push the On/Off button (1) again. u Push the On/Off button (1) a third time to turn the unit off.
Note: The state of charge indicator LEDs (3) will illuminate
while the vacuum is ON.
u To switch OFF, slide the on/off power switch (1) to the “O“
position.
u Return the product to the charger immediately after use
so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug.
Floorsense
Floorsense is active in the low speed. When a carpet is detected, the performance of the unit is automatically
increased to high speed. When a hardoor is detected, the
performance of the unit reduces to low speed.
Cleaning and emptying the vacuum
Warning! Projectile/Respiratory Hazard: Never use the vac
without its filter. Warning! The filter is re-usable, do not confuse it with a disposable dust bag, and do not throw it away when the product is emptied. We recommend that you replace the filter every 6–9 months depending on frequency of use.
Page 7
(Original instructions)
ENGLISH
To empty the dust canister (Fig. F, G, H, I)
u Push down the dust canister release button (4) to
release and remove the dust canister (5) from the vacuum.
u Use your index nger and thumb to pinch the lter
housing tabs and pull the lter housing (6) from the dust canister as shown in gure G.
u Place the dust canister over a trash can and empty the
dust canister as illustrated in gure H.
u Remove the foam lter (6a) from the lter housing as
shown in gure I.
u Shake or lightly brush any loose dust off of the foam
lter (6a) and lter (6).
u Rinse out the dust canister (5) with warm soapy water. u Wash the lters with warm soapy water. u Ensure the lters are completely dry before retting the
lters into the lter housing.
u Ret the clean and dry foam lter (6a) into the lter
housing (6).
u Install the lter housing into the dust canister (5). u Install the dust canister onto the vacuum, until it “clicks”
rmly into position.
Removing and cleaning the beater bar (Fig. J, K)
Warning! To reduce the risk of injury from moving parts,
disconnect the oor head and extension tube from the vacuum
before cleaning or servicing.
u To remove the beater bar (9b) from the oor head (9) Slide
the beater bar release button (9a) to the rear of the unit.
u The beater bar (9b) can now be removed and cleaned.
Safe storage (Fig. L)
The unit can be safely stored, when not in use, by placing the catch on the rear of the motor unit onto the storage station
(13) as shown in gure L.
Wall mounteing
The product can be attached to a wall to provide a convenient storage for the appliance. When mounting to a wall, make sure the mounting method is suitable for the wall type and is appropriate to the weight of the appliance.
u Mark the location of the charging station screw holes on
the wall (within reach of an electrical outlet for charging the vacuum while it is on the storage station.
u Fix the storage station to the wall using appropriate
screws and plugs for the type of wall, and weight of the appliance.
Maintenance
Your BLACK+DECKER cordless appliance has been designed to operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. Warning! Before performing any maintenance on cordless appliances:
u Run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Replacing the lters
The lters should be replaced every 6 to 9 months and when­ever worn or damaged. Replacement lters are available from
your BLACK+DECKER dealer.
u Remove the old lters as described above. u Fit the new lters as described above.
Protecting the environment
Separate collection. Products and batteries marked with this symbol must not be disposed of with normal household waste.
Z
Products and batteries contain materials that can be recov­ered or recycled reducing the demand for raw materials. Please recycle electrical products and batteries according to local provisions. Further information is available at www.2helpU.com
Technical Data
BHFEA420J BHFEA515J BHFEA520J
Voltage 14.4v 18v 18v
Watt Hours 28.8Wh 27Wh 36Wh
Approx Charge Times 5 hours 4 hours 5 hours
Weight 2.56KG 2.61KG 2.62KG
Australia & New Zealand Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 810 Whitehorse Road Box Hill VIC 3128, Australia
Page 8
N879747 03/2021
Loading...