Black & Decker BDHS-6120 Instruction Manual

Meijer.com
INSTRUCTION MANUAL
20” High Velocity Pedestal Fan
MODEL NUMBER: BDHS-6120
USA & Canada Customer Service Number:
www.BlackandDecker.com
READ THIS MANUAL CAREFULLY BEFORE OPERATING- SAVE IT FOR FUTURE REFERENCE
1
Meijer.com
SAFETY INFORMATION
WARNING
1. Always unplug the fan before moving it or performing maintenance. Never touch the fan
with wet hands.
2. The fan should always be disassembled, repaired or rebuild by a qualified electrician.
3. Always unplug the fan when not in use.
4. Never unplug the fan by pulling the power cord, always do it by holding the plug.
5. Never use the fan if the power cord or plug is damaged. Discard the fan or return it to an
authorized service agent for examination and/or repair.
6. Never use the fan with an extension cord.
7. Do not place the fan near heat sources or fire.
8. Do not insert your hand or any other objects into the guard or moving parts.
9. Do not run the power cord under carpets. Do not cover the power cord with area rugs,
runners or similar coverings.
10. Do not place power cord under furniture or appliances. Always keep the cord away from
traffic areas so it will not be tripped over.
11. To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed
control device.
12. If the power cord is damaged, have it replaced by the manufacturer, an authorized service
agent or a similarly qualified person in order to avoid any hazard.
CAUTION
1. Always unplug the fan from the main power supply and clean it with a soft cloth.
2. DANGER: Risk of electrocution. Do not immerse the appliance or the cord in water or any
other liquid.
3. Always fit the guard onto the fan before starting up the fan.
4. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised or have been given instructions concerning the use of the fan by a person responsible for their safety. Children should be supervised to ensure they do not play with the fan.
2
PACKAGE CONTENT
Part Description
Quantity
1
Front Guard
1 2 Blade
1
3
Rear Guard
1
4
Motor
1
5
Bracket
1
6
Screw M6X40
2
7
Washer #6
2
8
Nut M6
2
9
Inner Tube
1
10
Height Adjust Knob
1
11
Outer Tuber
1
12
Base Cap
1
13
Screw M5x30
4
14
Flat Washer #5
4
15
Spring Washer #5
4
16
Base
1
Meijer.com
3
CARE AND MAINTENANCE
Meijer.com
Unplug the appliance before cleaning. Do not use water to clean metal surfaces. Slightly moisten a cloth with a mild cleaner and then wipe off the surfaces of the fan. In order to remove dust from the protective guard, use a vacuum cleaner or remove the front protective guard using a screwdriver to unscrew the securing screws on the edges of the guard. After cleaning, replace the safety guard, and fasten the securing screws on the edges of the protective guard.
ASSEMBLY INSTRUCTIONS
Step 1
Attach the outer tube (11) to the base (16) with the screws (13), flat washers (14), and spring washers (15) as shown in the picture.
Caution: The screws must be fully tightened before operating the fan.
Step 2
Slide the height adjustable ring (10) away from the outer tube (11). Save it to use it in Step 3.
4
Meijer.com
Step 3
Slide the height adjustable ring into the inner Tube (9). Then, out it into the outer tube (11) and fasten the height adjustable ring (10) to the desired height.
Step 4 Connect the fan head (1, 2 & 3) with the inner tube (9). Then firmly tighten two sets of screws (6), washers (7) and nuts (8) in the holes of the fan.
Caution: the screws must be fully tightened before operating the fan.
5
Meijer.com
OPERATING INSTRUCTIONS
1. Adjust the desired speed by rotating the knob: 0: Stop- 1:Low- 2: Medium- 3: High
2. Tilt the fan head upward or downward for the desired direction of air flow.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION The fan fails to operate 1.Fan is not plugged in 1. Make sure the fan is plugged in, and the power outlet is working properly.
2. There may be some 2. Check for any obstruction if you obstructions in the fan. find an obstruction, turn the fan OFF. Unplug fan and carefully remove the obstruction. Plug the fan in and turn it on again. Refer to OPERATING INSTRUCTIONS.
MAIN SPECIFICATIONS MODEL No. BLADE SIZE VOLTAGE/Hz Speed Wattage
BDHS-6120 500 MM 120V/60 Hz HIGH 153 20 INCHES MEDIUM 142 LOW 131
USA & Canada Customer Service Number:
MADE IN CHINA
Imported by Ragalta USA
5870 NW 163th Street,
Miami Lakes, Florida 33014
USA
www.BlackandDecker.com
6
Meijer.com
Black & Decker and the Black and Decker logo are trademarks of the Black & Decker Corporation and are used under license. All rights reserved. Product may differ slightly from the picture on the cover of this instruction manual. Not all accessories shown in the photography are included in this package. 3 Year limited warranty: Covers all defective materials and workmanship under normal household use.
7
Loading...
+ 14 hidden pages