Black & Decker Acv1205 Instruction Manual [tr]
1 2 3
m.troc.rekceddnakcalb.www
4
English 4
Türkçe 7
90600124
5
4
A
C
6
B
10
9
8
7
D
11
E
2
1
F
12
2
G
3
13
H
3
ENGLISH
Intended use
Your Black & Decker Dustbuster® auto
car vacuum cleaner has been designed
for light dry vacuum cleaning purposes.
The appliance is powered from a car
electrical system and connected by the
cigarette lighter socket. This product is
intended for domestic use only.
Safety instructions
Warning! When using electrical
appliances, basic safety precautions,
including the following, should
always be followed to reduce the
risk of re, personal injury and
material damage.
Read all of this manual carefully
before using the appliance.
The intended use is described in this
manual. The use of any accessory or
attachment or the performance of
any operation with this appliance
other than those recommended in
this instruction manual may present
a risk of personal injury.
Retain this manual for future
reference.
Using your appliance
Do not use the appliance to pick up
liquids or any materials that could
catch re.
Do not use the appliance near
ammable fumes.
Do not use the appliance near water.
Do not immerse the appliance in
water.
Never pull the power lead to
disconnect the plug from the cigarette
lighter socket. Keep the lead away
from heat, oil and sharp edges.
Be careful not to pinch the lead in
the vehicle’s doors, windows or levers.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts.
Check for breakage of parts, damage
to switches and any other conditions
that may aect its operation.
Do not use the appliance if any part
is damaged or defective.
Have any damaged or defective parts
repaired or replaced by an
authorised repair agent.
Regularly check the power lead for
damage. Replace the lead if it is
damaged or defective.
Never attempt to remove or replace
any parts other than those specied
in this manual.
Electrical safety
The appliance is designed for use with
12V negative ground vehicle battery
systems.
Warning! Do not operate the appliance
with systems which have positive ground
or a dierent voltage.
Features
1.On/o switch
2.Release button
3.Dust bowl
4.Cigarette lighter connector
Fig. A
5.Crevice tool
6.Brush tool
Assembly
Fitting the accessories (g. A & C)
The appliance is supplied with the
following accessories:
–a crevice tool (5) for conned spaces
–a hard brush (6) for upholstery
4
After use
When not in use, the appliance
should be stored in a dry place.
Children should not have access to
stored appliances.
To t an accessory, proceed as follows:
Take the accessories from the
appliance.
Insert the appropriate accessory into
the front of the appliance.
ENGLISH
Additional accessories (g. C, D & E)
–an extension hose (7) and a hose
connector (8)
–a brush (9) for carpets and upholstery
–an extended crevice tool (10) for the
most dicult to reach areas.
When not in use, the appliance and the
accessories can be stored in the storage
bag (11).
To t an accessory, proceed as follows:
Fit the hose connector onto the nose
of the appliance.
Attach one end of the hose to the
connector.
Attach the appropriate accessory to
the other end of the hose.
Use
Connecting to the vehicle’s power
supply (g. B)
Make sure that the appliance is
switched o.
Remove the cigarette lighter from
the socket.
Plug the connector (4) into the
cigarette lighter socket.
Operating the appliance (g. F)
To switch on, slide the on/o switch
(1) forward.
To switch o, slide the on/o switch
back.
The appliance can be used for periods of
up to 30 minutes without noticeably
aecting the power of a normally
charged car battery in good condition.
Warning! Extended use will drain the
battery power. Do not run the vehicle’s
engine while cleaning. This can shorten
the life of the appliance.
Cleaning and maintenance
Warning! Regularly clean the lters.
Cleaning the dust bowl and lters
(g. G & H)
The lters are re-usable and should be
cleaned regularly.
Press the release button (2) and
remove the dust bowl (3).
Empty the dust bowl (g. G).
Remove the lters (12 & 13) by
twisting them clockwise.
Brush any loose dust o the lters.
Wash the lters in warm, soapy
water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and lters
are dry.
Ret the lters (12 & 13) onto the
appliance, twisting them
counterclockwise until they lock into
place.
Ret the dust bowl onto the
appliance. Make sure the dust bowl
clicks into place.
Warning! Never use the appliance
without the lters. Optimum dust
collection will only be achieved with
clean lters and an empty dust bowl.
Replacing the lters
The lters should be replaced every 6 to
9 months and whenever worn or
damaged. Replacement lters are
available from your Black & Decker
dealer (cat. no. VF40).
Remove the old lters as described
above.
Fit the new lters as described above.
Protecting the environment
Separate collection.
This product must not be
disposed of with normal
household waste.
Should you nd one day that your
Black & Decker product needs
replacement, or if it is of no further use
to you, do not dispose of it with
household waste. Make this product
available for separate collection.
Separate collection of
products and packaging allows
materials to be recycled and
used again.
5
Loading...