Blackburn piston 2 Service Manual

™

PISTON 2

ANYVALVETM PUMP HEAD

Floor pump

Part# 7074786 (Matte Black/Cyan)

>20mm LONG

7074787 (Grey/Hi Viz Yellow)

INSTRUCTIONS FOR TIRE INFLATION

1. Remove the dust cap from your tire valve. If you have Presta
valves,unscrew the metal locking barrel at the tip of the valve.

2. Push in the tip of either valve type to ensure that the valve isn’t
stuck and to blow out any dirt.

3. Choose the correct pump head insert for your valve type (FIGURE 1).
If necessary, unscrew cap and reverse rubber insert.

4. Press pump head onto valve and lift the lever to lock.

5. Inflate to desired air pressure. DO NOT OVERINFLATE TIRE.

6. If necessary release air to adjust tire pressure. Use a tire gauge for accurate
tire pressure pressure. (#7085517 Blackburn HONEST Digital Pressure Gauge)

7. Press pump head lever down and remove.

8. If using Presta valves, screw the locking barrel until tight.

9. Replace the tire valve dust cap.

PRESTA

<20mm SHORT

PRESTA

LONG PRESTA/

SCHRADER

Long 37" hose

SHORT PRESTA/

DUNLOP

Wide 10.5" handle

FIGURE 1

Anyvalve™ pump head

WARNING: NEVER OVERINFLATE YOUR TIRE. SEE TIRE SIDEWALL FOR MANUFACTURER RECOMMENDED TIRE INFLATION PSI.

Visit us at blackburndesign.com for product updates.

Extra large 3" gauge

Steel base and barrel