Bissell 6585 User Manual
PowerForce
®
BAGLESS
USER’S GUIDE
6585 SERIES
Safety Instructions
3
Product View
4
Assembly
5
Turbo
6-7
8-12
13-14
14
15
16
Operation
Maintenance and Care
Troubleshooting
Consumer Services
Replacement Parts
Warranty
ug110_4018_6585_1207.indd 1ug110_4018_6585_1207.indd 1 12/19/07 10:04:47 AM12/19/07 10:04:47 AM
Thank you for buying a BISSELL PowerForce
®
Turbo Bagless Vacuum
We’re glad you purchased a BISSELL PowerForce Turbo Bagless Vacuum.
Everything we know about floor care went into the design and construction of
this powerful, high-tech home vacuuming system.
Your BISSELL PowerForce Turbo Bagless is well made, and we back it with a
limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services Department, so, should you ever have a problem, you’ll
receive fast, considerate assistance.
My great-grandfather invented the floor sweeper in 1876. Today, BISSELL is a
global leader in the design, manufacture, and service of high quality homecare
products like your BISSELL PowerForce Turbo Bagless.
Thanks again, from all of us at BISSELL.
Mark J. Bissell
President and Chief Executive Officer
2
www.bissell.com 800.237.7691
2
ug110_4018_6585_1207.indd 2ug110_4018_6585_1207.indd 2 12/19/07 10:04:48 AM12/19/07 10:04:48 AM
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical
precautions should be observed, including the
following:
READ ALL INSTRUCTIONS
BEFORE USING YOUR
UPRIGHT VACUUM.
Always connect to a polarized outlet (left slot is wider
than right). Unplug from outlet when not in use and
before conducting maintenance.
WARNING: To reduce the
risk of fire, electric shock,
or injury:
■
Do not modify the polarized plug to fit a
non-polarized outlet or extension cord.
■
Do not leave vacuum cleaner unattended when it is
plugged in.
■
Unplug from outlet when not in use and
before servicing.
■
Do not use outdoors or on wet surfaces.
■
Do not allow children to operate vacuum
cleaner or use as a toy.
■
Close attention is necessary when used by or
near children.
■
Do not use for any purpose other than described in
this User’s Guide.
■
Use only manufacturer’s recommended
attachments.
■
Do not use with damaged cord or plug.
■
If appliance is not working as it should,
has been dropped, damaged, left outdoors,
or dropped into water, have it repaired at an
authorized service center.
■
Do not pull or carry by cord, use cord as a
handle, close a door on cord, or pull cord around
sharp edges or corners. Do not run appliance over
cord. Keep cord away from heated surfaces.
■
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
■
Do not handle vacuum cleaner or plug with
wet hands.
■
Do not put any object into openings. Do not use
with any opening blocked; keep openings free of
dust, lint, hair, and anything that may reduce
air flow.
appliance, basic
■
Keep hair, loose clothing, fingers, and all parts of
body away from openings and moving parts.
■
Turn off all controls before plugging or unplugging
vacuum cleaner.
■
Use extra care when cleaning stairs.
■
Do not pick up flammable materials (lighter fluid,
gasoline, kerosene, etc.) or use in the presence of
explosive liquids or vapors.
■
Do not pick up toxic material (chlorine bleach,
ammonia, drain cleaner, etc.).
■
Do not use vacuum cleaner in an enclosed space
filled with vapors given off by oil base paint, paint
thinner, some moth proofing substances, flammable
dust, or other explosive or toxic vapors.
■
Do not pick up hard or sharp objects such as glass,
nails, screws, coins, etc.
■
Do not pick up anything that is burning or smoking,
such as cigarettes, matches, or hot ashes.
■
Do not use without filters in place.
■
Use only on dry, indoor surfaces.
■
Keep appliance on a level surface.
■
Do not carry the vacuum cleaner while it
is running.
SAVE THESE
INSTRUCTIONS FOR
FUTURE USE.
THIS APPLIANCE HAS
A POLARIZED PLUG.
To reduce the risk of electric shock, this appliance has a
polarized plug (one blade is wider than the other). This plug
will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install a proper outlet.
Do not change the plug in any way.
This model is for household use only.
www.bissell.com 800.237.7691
ug110_4018_6585_1207.indd 3ug110_4018_6585_1207.indd 3 12/19/07 10:04:48 AM12/19/07 10:04:48 AM
3
Product view
Cord Clip
Hose Clip
Stretch Hose
Handle
Combination
Dusting Brush/
Upholstery Tool
Power Switch
Handle
Release
Pedal
Foot Hose
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with all
instructions and
operating procedures.
Crevice Tool
Carrying
Handle
Extension Wand
Quick Reach®
Handle
Hose Wand
Hose
Wand Base
Dirt Container
Filter Cup
Height
Adjustment
Knob
Furniture Protection
Guard
TurboBrush
Quick Release
Cord Wrap
Inner and Outer
Circular Filters
Powerfoot
Primary
Separator
Upper Tank
Power Cord
Lock ’n Seal
Lever
HEPA
Post-Motor
Filter
™
™
www.bissell.com 800.237.7691
4
ug110_4018_6585_1207.indd 4ug110_4018_6585_1207.indd 4 12/19/07 10:04:48 AM12/19/07 10:04:48 AM
How to use this guide
This User’s Guide has been designed to help
you get the most satisfaction from your BISSELL
PowerForce Turbo Bagless. You’ll find assembly
and operating instructions, safety precautions, as
well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before
assembling your vacuum cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate
and organize all parts before assembly. Following
this User’s Guide will greatly enhance your ability
to get the most performance from your BISSELL
PowerForce Turbo Bagless for many years.
Assembly
The only tool you’ll need to assemble your
vacuum cleaner is a screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove the
screw packet taped to the base of the handle.
2. Stand the vacuum upright and place the handle
on the top of the vacuum body.
3. Insert the screws provided from the screw
packet into the existing holes on each side.
Tighten securely with a screwdriver.
WARNING:
Plastic film can be
dangerous. To avoid
danger of suffocation, keep away from
babies and children.
Attach vacuum hose and tools
1. Attach the Twist ‘n Snap™ hose by lining up
the tabs on the base with the corresponding
notches on the back of the vacuum.
2. Turn the Twist ‘n Snap hose to the right to lock
the hose into place.
3. Grasping the quick reach handle, slide the end
of the hose wand onto the hose wand base.
Snap the hose into the hose clip.
NOTE: The powerfoot will not operate
effectively unless the hose wand is
firmly attached.
4. Slide the extension wand and the crevice tool
together into the storage clip on the side of
the vacuum.
5. Snap the combination tool into the storage clip
on the back of the vacuum.
®
6. The TurboBrush
of the handle. Attach the bracket by
aligning the pegs with the holes on the
handle and pulling down until it locks
www.bissell.com 800.237.7691
ug110_4018_6585_1207.indd 5ug110_4018_6585_1207.indd 5 12/19/07 10:04:50 AM12/19/07 10:04:50 AM
into place.
bracket slides into the front
5
Loading...