Quick Tips
Detachable Steam Pod
1. You may only use the Detachable Steam Pod when it is removed from the
upright unit.
2. We recommend that you use it with one of the included attachments.
Red circular
bathroom brush
Black circular
kitchen brush
Grout brush Flat surface microber
cleaning tool
Cleaning with attachments
1. Attach the cleaning tool to the end of the hose
2. Clean by pressing the steam trigger to apply steam onto the area to be
cleaned
3. Slowly scrub tool back and forth over the mess
4. When cleaning is complete, remove and rinse tool in warm water
WARNING:
Refer to the enclosed user guide for
complete instructions and important
safety notices.
Package contents:
a. Detachable Steam Pod
b Upright Unit
c Maneuverable Mop Head
39W7
d Handle
e Small screw
f Mop Pads
Refer to the User’s Guide for full instructions on how
to clean, store and maintain your machine
For additional tips and troubleshooting
Please refer to User's Guide
Earn BISSELL rewards! Register your product today!
Visit: www.bissell.com
120-4367
© 2011 BISSELL Homecare, Inc.
BISSELL Homecare, Inc.
P.O. Box 1888
Grand Rapids, MI 49501
Phillips head screw driver is needed for assembly
a.
b.
c. f.
d.
e.
Assembly Ready to Steam Mop
1. Attach lower body base that contains detachable steam pod to
maneuverable swivel head.
2. Secure maneuverable swivel head with small screw and Phillips head screw
driver. Tighten until secure.
3. Secure the handle by placing it in the lower body base and screw it
clockwise until tight. Ensure that the upper handle is pointing to the rear.
4. Remove water tank and unscrew cap at the bottom. Fill with water. For best
results, water should be at room temperature.
5. Replace cap and screw until tight.
6. Slide water tank onto detachable steam pod by lining up vertical guides
and gently sliding tank into place.
7. Place steam mop pad on mop head.
1.
2.
3.
1. Plug into electrical outlet and wait approximately 30 seconds for the “Ready
Light to turn On.”
2. To steam clean your oor, depress the steam on demand trigger and hold
down until unit emits steam. You will hear a knocking noise, which means the
pump is priming. This will only occur when you rst use your steam mop or
you replace your lter. For sanitization instructions see users guide.
3. Select the steam setting by turning the steam control knob from light, which
is used for delicate ooring, to tough, which is used to clean hard to remove
messes.
4. Begin mopping your oor when you hear steam generated at the mop head,
depressing the steam on demand trigger to continuously generate steam.
5. To use the detachable steam pod, press, pull and release the PRESS GRAB
& GO button. Twist the Quick Release cord wrap clock-wise to unwrap the
cord.
6. Remove the hose by pressing on the blue button in the rear of the detachable
pod.
7. Attach one of the attachments to the end of the hose.
8. To generate steam, press the blue steam trigger button, which is located at
the top of the detachable pod.
4.
Your assembly is
now complete.
5. 7.
2.
6.
For complete user's guide, visit www.bissell.com
3.
7.
5.
8.