Bionaire BSF1731 User Manual

oscillating STAND fan

remote control

MODEL BSF1731

STAND fan

BSF1731RC BSF1731RC-CN

Read instructions before operating. Retain for future reference.

Instruction Leaflet

INFO-LINE

If after having read this leaflet, you have any questions

or comments on your fan,

call 1-800-788-5350 in North America.

☎

428-0307

Model BSF1731 Shown

FAN SAFETY

PLEASE READ AND SAVE

THESE IMPORTANT

SAFEGUARDS.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1) Read all instructions before using the appliance.

2) To avoid fire or shock hazard, plug the appliance directly into a 120 V AC electrical outlet.

3) Keep the cord out of heavy traffic areas. DO NOT let the cord hang over the edge of a table or counter. To avoid fire hazard, NEVER put the cord under rugs, near heat registers, radiators, stoves, or heaters.

4) To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.

5) Close supervision is necessary when any appliance is used by or near children, or by disabled people.

6) Always unplug the fan before moving it, putting on or taking off parts, cleaning, or whenever the fan is not is use. Be sure to pull by the plug and not the cord.

7) Avoid contact with moving parts. DO NOT operate without fan grills properly in place.

8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair.

9) DO NOT operate in the presence of explosive and/or flammable fumes.

10) Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by Bionaire may cause hazards.

11) DO NOT use outdoors.

12) Always use on a dry, level surface.

13) Keep unit away from heated surfaces and open flames.

14)WARNING: To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control device.

15) DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.

BSF 1731 9/00

PLEASE READ AND SAVE THESE

IMPORTANT SAFEGUARDS.

THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current) PLUG (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet.

DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY.

ASSEMBLY INSTRUCTIONS

Figure 1

BSF1731

A. Grill Hub B. Front Grill C. Fan Blade Nut

D. Fan Blade E. Rear Grill

Mounting-Ring F. Rear Grill G. Motor Shaft H. Motor Housing I. Upper Pole

J. Height Adjustment Knob K. Lower Pole L. Base Insert

M. Base N. Weighted Insert O. Weight Nut P. Fixed Screw Q. Grill Ring R. Remote Control Housing S. Fan Post Screw

T. Remote Control

Figure 2

BSF1731RC

BASE/POLE ASSEMBLY

Step 1: Insert lower pole into the base until the threaded end of the pole protudes through the opening in the center of the base. Twist the pole clockwise until locked.

Step 2: Turn the base upside down and place the weighted insert into the base by aligning it between the two parallel ribs. Secure the base, weight, and pole system together by tightening the weight nut to the threaded portion of the pole. Place the base on the floor, right side up. Step 3:Replace the height adjustment knob over the pole, slide it down the pole, and secure it to the base by turning clockwise.

+ 5 hidden pages