Please read the safety instructions carefully before using this
appliance. Please retain the instructions for future refer-
ence.
SAFETY MEASURES
When using your appliance, the following basic
safety precautions should always be followed:
X Before using for the first time, check that the
appliance voltage is the same as your local supply.
X Only use the appliance for the purposes stipu-
lated by the instructions.
X Only use attachments supplied with the equip-
X To avoid electric shocks, do not immerse the appliance,
plug or power cord in water or any other liquids. Do
not place the appliance where it could come into contact with
water or other liquids. If the appliance comes in contact with
water, immediately disconnect it from the mains. Do not use
the machine again until it has been serviced by an autho-
rized service center.
X Do not let children use the appliance without supervision.
X If the plug of the appliance’s power cord does not fit
your wall outlet, contact an authorized service center.
X Use of various adapters may result in damage to the
appliance and termination of warranty.
X Always supervise the equipment while in use.
X To avoid a circuit overload, do not operate any other high
voltage equipment on the same circuit.
X Always unplug the appliance after use, before mov-
ing and before cleaning it.
X Never pull the cord to disconnect the appliance, instead grasp
the plug and pull it to disconnect.
X Do not allow the cord or the machine itself to come in contact
with hot surfaces.
X Position the equipment and the cord so that nobody can acci-
dentally overturn the equipment.
X Do not use the appliance if it has been dropped, or it has a
damaged power cord or plug. Do not modify or repair the
machine yourself.
X Do not dismantle the appliance as improper assembly might
result in an electric shock during the subsequent use of the
equipment. Repairs should only be done by authorizedservice centers.
X Do not use the appliance where the air may contain volatile
flammable substances.
X This equipment is intended for household use only, not for
commercial or industrial use.
X Please follow all the requirements of this guide.
X Do not use the appliance if it has mechanical defects (dents,
cracks etc.), get it checked by the nearest authorized service
center.
ment.
4
SPECIAL SAFETY MEASURES
X Never pour water into the appliance!
Pour the ceramic beads into the bath. The massage is performed by warmed ceramic beads,
not by water!
X To avoid overheating your feet, put on socks
before the massage.
X Never place the whole appliance in water.
X Do not move the appliance or unplug from the socket during
operation of the appliance.
X Do not stand in the appliance and only use it whilst in a sitting
position.
X To avoid fire or electric shock, do not remove leads designed
for maintenance of the electrical appliance. The electrical appliance has no elements that require a service.
X Avoid any water splashing into the controls.
X Do not use for more than 20 minutes. After 20 minutes of
continuous work, the massager should be switched off and
allowed to cool to room temperature.
X It is not advisable to use the massager if you have phlebitis,
varicose veins, severe leg edema, burns or open wounds,
diseases of the nervous system (for example, sciatica) or during pregnancy. In the above cases, we recommend you to
consult your doctor before use of the massager.
X When in use the appliance has a hot surface. Persons insensi-
tive to heat must be careful when using this appliance.
X Empty the ceramic beads from the appliance though the spe-
cial cavity.
ENGLISH
DESCRIPTION OF APPLIANCE
PARTS
Figure A:
1. Body
2. Lid
3. Operating mode switch:
0 - Off
1 - Heating
2 - Keep hot
3 - Keep warm
4. Removable massage attachments at the center of the appli-
ance.
5. Air venting holes
6. Surface for acupuncture massage
7. Heating area
8. Maximum level for filling with ceramic beads «MAX»
9. Bath emptying cavity
Figure B:
10.Non slip feet
11.Cord
12.Bottom compartment for dust removing with cover
5
BEFORE USE
Remove all packing materials from the device and clean it as specified in this Operation
Manual.
OPERATING INSTRUCTIONS
Attention: appliance operates without
water!
Appliance usage
1. Place the appliance on a level horizontal surface in front of a
comfortable seat (chair).
2. Pour in ceramic beads.
3. Make sure the mode switch (3) is in position «0»
4. Plug the appliance into a wall outlet.
5. To avoid overheating your feet, put on socks before
the massage.
6. Sit down first and then place your feet into the foot bath.
Always remain seated when placing your feet into
the bath or removing them.
7. Move the mode switch (3) to the desired position. For heating
- «1». Beads will be heated in about 13 minutes. Then select
mode «2» or «3» to maintain temperature.
8. Place your feet in the bath and massage them with the warm
ceramic beads.
9. After finishing the massaging procedures set the switch (3) to
the «0» position and follow the instructions in the «Care and
cleaning» section.
Description of operational modes
1) heating
Massage with warm ceramic beads relieves muscle tension
and improves blood circulation in the feet, giving a pleasant
and lasting sense of warmth. Warm ceramic beads effectively
massage the feet.
2) keep hot
3) keep warm
Temperature maintenance
This function provides ceramic beads temperature maintenance
during the complete procedure (15-20 minutes).
6
MAINTENANCE AND
CLEANING
1. Always switch off the appliance and unplug
it before you clean the appliance.
2. Pour the beads out of the massager.
3. Thoroughly clean the interior surface of the
appliance with water and mild detergent.
4. Carefully dry the appliance and place it in a
dry place for storage.
5. For storage, coil the cord (11) around the feet (10) located at
the bottom of the bath.
6. To keep your bath clean, it is recommended to regularly remove dust and bean powder from inside of the bottom compartment (12). Simply open the clean out cover and pull it
out.
USEFUL ADVICE
Warm ceramic beads could be placed in a cloth
bag to massage or warm the neck, waist or thigh,
joints.
DISPOSAL
This appliance should be disposed of in accordance with waste disposal regulations in your country and with the least damage to the environment.
Only ecologically safe materials are used in
the packaging of our products and the cardboard
and paper can be disposed of with normal paper
waste.
ENGLISH
AFTER-SALES SERVICE
If your appliance does not operate or does
not operate properly, contact an authorized
service center for consultancy or repair.
The warrantee does not cover:
- product packing, consumables and accesso-
- mechanical damages and natural wear of the product;
- failures due to overloading, improper or careless maintenance,
penetration of liquids, dust, insects and other foreign matters
inside the product, exposure of plastic and other not thermalresistant components to high temperatures, force-majeure circumstances (accidents, fire, flooding, power grid failure, lightning stroke, etc.);
- damages caused by:
ries (knives, tips, etc.);
7
X Non-fulfillment of the above-mentioned precautions and op-
erating manuals.
X Application in commercial purposes (application of the product
beyond personal daily living needs).
X Connection to a grid with a voltage which differs from that
indicated on the appliance.
X Unauthorized repair or replacement of the components of the
appliance, performed by an unauthorized person or service
center.
8
ENGLISH
Features may be changed by Binatone without any notice.
Warranty details are set out in the warranty card provided
with the product.
Exploitation period: 3 years after the day of purchase.
Manufacture: Binatone Industries Ltd, Great Britain, Vitabiotics