Billi 915100LBR, 915100LMB User Manual
User guide
Billi B-5000 Sparkling
Tap option XL
User guide
Billi B-5000 Sparkling – XL.
Contents
Warnings & Important information ........2
General Maintenance.....................3
Features and Modes......................4
Tap Options & Operation
XL Tap.................................5
Dispenser Icon Codes
XL Tap.................................6
Filtration Information.....................7
Changing the filter .......................8
Changing the CO
Service Support ........................11
cylinder ................9
2
Warnings & Important information
– For continued safety of this appliance it
must be installed, operated and maintained
in accordance with the manufacturer's
instructions.
– Your appliance should be installed
by a suitably qualified tradesperson.
– For correct operation of this appliance
it is essential to observe the instructions
as outlined in this booklet.
– Do not use this appliance with water that
is microbiologically unsafe or with water
of unknown quality without adequate
disinfection before or after the system.
Systems certified for cyst reduction
may be used on disinfected water
that may contain filterable cysts.
– Filter replacement must be performed
at intervals of not more than 12 months.
– Use this appliance only as directed
in these instructions and only for its
designed purpose.
– This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
– This appliance is not suitable in an area
where a water jet could be used.
– Children should be supervised to ensure
that they do not play with the appliance.
– DANGER: The operation of the thermal
cut-out indicates a possibly dangerous
situation. Do not reset the thermal cut-out
until the water heater has been serviced
by a suitably qualified person.
– WARNING: Do not connect any restrictor
or pressure relief device to the vent pipe
of this water heater if installed.
– If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid creation of a hazard.
2
User guide
Billi B-5000 Sparkling – XL.
– Billi hose sets as supplied with the appliance
are to be used. Old or other manufacturer’s
hose sets should not be re-used.
– If the appliance is located where the
ambient air temperature could fall below
4°C when the heater is not in use, do not
turn o the power supply to the appliance.
This safeguard does not oer the same
protection to the connecting pipework
and fittings.
– The ambient temperatures this unit
should operate within are 4°C to 45°C.
– Turn o power to unit, by unplugging
the power cord from the power point,
if water supply is turned o
Caution and safety
Boiling water is dangerous and can cause
severe burns, particularly with young children.
Boiling water must always be handled with
caution. Use this appliance only as directed
in these instructions and only for the purpose
for which it has been designed. Your Billi
B-5000 is designed to be safe and practical.
In an environment with young children,
it is recommended that the boiling water
safety switch is activated.
The following safety features have been
included:
– Ergonomic levers
– Levers/touch activations located safely
above water outlet.
– Smooth electronically controlled boiling
water flow rate. Flow is briefly reduced as
water first enters cup to prevent splashing.
– Dispenser remains cool to touch.
– Childproof safety switch.
– Boiling water Safety Isolation mode.
General Maintenance
Your B-5000 Sparkling has been designed
to require minimal maintenance other
than replacement of filter cartridges.
During each filter change, check all water
connection fittings for signs of leakage.
Check all tubing for any signs of damage.
Check the cupboard area around the
base of unit for any signs of moisture.
Ensure side vents of the under bench module
are kept clear and airflow is not obstructed.
Restricted airflow will cause inecient
operation of the refrigeration system.
—Cleaning the dispenser
Your B-5000 Sparkling Dispenser is fabricated
from solid zinc casting material with tough
protective chrome plating. Proper care of the
Billi Electronic dispenser crucial; Avoid using
abrasive cleaners. Wipe clean using a damp
cloth. Use of a non-solvent, non-smearing
cleaner such as Windex is recommended.
Do not pour water over dispenser.
Cupboard ventilation requirements
Your B-5000 Sparkling underbench module
requires cupboard ventilation, refer to install
guide for details. Care should be taken when
using the cupboard space, to avoid stretching
or damaging plastic pipe work. Check fittings
and tubing at each filter change for signs of
damage or leakage. Always ensure access
to power switch and water supply tap is not
restricted.
3
User guide
Billi B-5000 Sparkling – XL.
Features and Modes
Dispenser Swivel
The B-5000 dispenser incorporates a swivel
function, allowing the dispenser to be swung
out of the way if more sink space is required.
A central position stop provides positive
location during normal usage.
Safety Timeout
Your B-5000 Sparkling incorporates a
water delivery Safety Timeout to prevent an
uncontrolled flow of water. Water flow
stops automatically after a set time interval.
Flow can be started again by releasing and
pressing the dispenser lever or buttons.
Boiling water timeout – 10 secs;
Chilled water – 1 minute.
Childproof safety switch
Your B-5000 Sparkling is fitted with a
childproof safety lock-out feature to protect
against accidental dispensing of boiling water
and the risk of burns. Please refer to safety
switch settings on page 5.
Self learning timer (EcoIntelligence)
Your Billi B-5000 incorporates an energy
saving self learning timer. This timer
learns the users behaviour over a period
of time (up to one month) and pre-empts
the need for water throughout each 24-hour
period over a week. Data is lost when the
power is removed however learnings from
the first days use is applied to the entire
learning cycle so the unit will quickly resume
intelligent timer operation. When the selflearning timer is enabled the unit will enter
standby if no water is expected to be used
for a 3 hour or more period. The unit will
shutdown completely if no water is expected to
be used for a 6 hour or more period. In oce
environments this feature will typically cause
the unit to turn o outside normal business
hours, ie: overnight and on weekends. In
domestic environments with no one home
during working hours the unit will turn o
through each weekday but may remain on at
night and during weekends. See page 6 for
dispenser icons. To activate, refer to Options,
page 5.
Standby Mode
Standby operation may be optionally
enabled to reduce power consumption.
In standby mode the hot water set point
is reduced to 72°C. When enabled, standby
is invoked after two hours from the time
of last use. When a tap lever or button is
pressed in standby no water is dispensed.
The indicators will flash to indicate the
water is not ready. The lever or button can
be repressed to dispense water. During
Standby mode the moon & star icon will flash.
See page 6 for dispenser icons. To activate,
refer to Options, page 5.
Boiling water disabled mode
Your B-5000 Sparkling features an additional
boiling water safety isolation feature.
Once activated, delivery of boiling water
becomes totally disabled. Chilled water
can be dispensed normally.
During this mode, the red, hot, icon will remain
o. To activate, refer to Options & Operation,
Safety Switch Settings, page 5.
Holiday mode
Holiday Mode is provided to save energy
when the unit will not be used for long periods.
In this mode both the water chiller and water
heater are disabled and the unit will use
very little power. Pressing the Pressure
Relief button places the unit in Holiday Mode.
The unit will exit Holiday Mode if either the
power is turned o then on or if any of the
levers are pressed. The Self Learning Timer
will ignore user behaviour while the unit is in
Holiday Mode and resume normal operation
when the mode is terminated. Holiday Mode
is indicated by the star & moon icon being
illuminated. See page 6 for icon images.
4
Loading...