Biketronics Titan II Installation Manual

Titan II 7.1” Speaker

Installation Guide

BT7P1

ElectraGlide fairing

1996 to Present

B I K E T R O N I C S

Step One: Mounting Adapter to Fairing

Kit Contents:

(2) 7.1” Speakers
(2) Speaker Adapters

(6) #10x⅞” Screws

(8) #6x¾” Screws
(2) Cloth-Covered Grills

Remove fairing and existing Harley speakers.
Place grills on adapter with cloth-side facing towards rider.
Begin by positioning clutch-side adapter as shown.

DO NOT OVERTIGHTEN SCREWS

Coaxial 180mm (7.1”)
2 way - 20mm tweeter, 180mm woofer
4 ohm impedance

Effi ciency - 92.6 dB/SPL

Frequency range - 45-22kHz
100 Watts RMS power, 200 Watts peak
Integrated crossover

Specifi cations:

Use new #10x⅞” screws in these three holes

Position adapter
so the “missing”
screw hole on the
adapter is on the
inside-bottom.
Brake-side will be
the mirror image
of this photo.

Clutch-side adapter shown

Outside Edge of Fairing

Page 1 of 2