Phone Mount
How to Use Your New BigPantha Phone Mount (and Free
Cell Phone Lanyard)
Dear Customer,
You have made a wise decision by purchasing a BigPanthaPhone Mount. You can now
attach your Cell Phone / GPS device to your Bicycle, Mountain Bike, Motorcycle or Car in
just a few seconds for safe & easy hands free use!
Your new phone mount is very simple to assemble and to use. This short user manual
will guide you through the process.
Your Phone Mount will have been delivered in a box, which as you can see below
contains the phone mount parts for assembly as well as your complimentary mobile
lanyard.
From left to right we have the four parts of the phone mount - the phone Cradle (A), the
Back Mount (B), the Nut (C) and the rubberized adjustable Clamp (D), and finally...your
complimentary Mobile Lanyard (E).
What's in the Box?
A B C D E
A. Assembling the Phone Mount
This is what we're going to make:
The Cradle holds your device (Cell Phone or GPS). The Back Plate connects the Cradle to
the Clamp – together they form the Phone Mount. Then the Clamp attaches the Phone
Mount unit to the Handlebar / Steering Wheel.
It'll take just a few minutes to construct your Phone Mount. There are three simple
steps:
1) Preparing the Cradle & Back Mount
Here you can see the Cradle (A) on the left and
the Back Plate (B) on the right.
The Cradle has four holes in the back, whilst
the Back Plate has four protrusions sticking out.
Hold the Cradle with the Silver Box facing down
as shown.
What we're going to do match the Cradle and
Back Plate together and ...
...fit the Back Plate protrusions into the holes in
the Cradle as shown.
So far so good. The Back Plate is loosely in
place. Now we need to lock it - the Back Plate firmly into place...
With the Cradle held firmly in your hand (left
hand in the picture), place the thumb of your
other hand (the right hand is shown in the
picture) under the Back Plate and push the
Back Plate UP.
You will find that the Back Plate will move UP
about 5 mm and slot tightly into place. It will
not move.
If you ever want to, you can remove the back
plate by reversing the procedure.
As you can see the Cradle and the Back Plate
have formed a solid single unit.
Here is the front view.
Now let's fit it to the rubberized Adjustable Clamp...
Loading...