Biamp USB 200 User guide

Biamp USB 200

Quick Start Guide

What Is In The Box

1 x

USB 200

1 x

Screw

Selection

Switch between manual

or priority mode

1 x

Power Supply

1 x

A

nchor

Mounting Options

1 x

Euro Connector

2 x

Zip Ties

PC1 - Input PC2 - Input Device - Output For manual switching mode

Use the screw and plug to mount

the USB 200 to the wall

USB- A

Power (optional)

Switch input

(PC1 / PC2)

Use zip ties to attach the USB 200 to the wall-

mount brackets at the back of the monitor

Biamp USB 200

LED Behavior

Status

PC1 selected - PC1 LED

PC2 selected - PC2 LED

State

Get Started Application Diagram

Use the Switch to select the
Manual or Priority Mode.

When using Manual Mode
external control system switch connector.

Connect USB cables (not included)
to the device and Host PC’s.

If auxiliary power supply is required, connect
mains power via the power supply unit.

See the application diagram for
the recommended setup.

, connect an

Standard USB HUB

Featuring

• Supports both USB 2.0 and USB 3.0.

• Power switch delay cuts power for 2 seconds when switching
between computers, to secure stable switching of the device.

• Built-in USB extender extends USB 2.0 cable lengths to up to 17 feet (5m
and USB 3.0 cable lengths up to 10 feet (3m) on each side of the switch.

BYOD In Room PC

biamp.com[phone]

17JAN2022