Page 1
PR1000R
Instruction manual
Page 2
Page 3
PR1000R Manual
Instruction manualPR1000R
1
Page 4
2
Music Sources & Sound Systems
Safety information
• Please check the carton box for any kind of damage on
reception of the goods. In case of a damaged carton, please
contact your dealer before opening the carton.
• !!!! Danger !!!! Exposure to extremely high noise levels may
cause a permanent hearing loss. Individuals vary considerably to
noise induced hearing loss but nearly everyone will lose some
hearing if exposed to sufficiently intense noise for a sufficient
amount of time. Therefore it is recommended that all persons
exposed to equipment capable of producing high sound
pressure levels, such as this amplifier, be protected by hearing
protection while installing or operating this unit.
• Read all documentation before operating your equipment.
• Keep all documentation for future reference.
• Save the carton and packing material even if the equipment has
arrived in good condition.
• Should you ever need to ship the unit, use only the original
factory packing.
• Do not spill water or other liquids into or on the unit.
• Make sure power outlets conform to the power requirements
listed on the back of the unit.
• Do not use the unit if the electrical power cord is frayed or
broken.
• Have gain controls on amplifiers turned down during power-up
to prevent speaker damage if there are high signal levels at the
inputs.
Page 5
Instruction manualPR1000R
• Do not connect the inputs / outputs of amplifiers or consoles
to any other voltage source, such as a battery, mains source, or
power supply, regardless of whether the amplifier or console is
turned on or off.
• Power down & disconnect units from mains voltage before
making connections.
• Do not use the unit near stoves, heat registers, radiators, or
other heat producing devices.
• Do not remove the cover. Removing the cover will expose you
to potentially dangerous voltages.
• In case of mal-function this device should be serviced by
qualified service personnel only.
• The apparatus shall not be exposed to dripping or splashing
and that no objects filled with liquids, such as vases, shall be
placed on the apparatus.
features
• Versatile design, easy to integrate in rack mounted professional
audio distribution systems, stereo hifi systems, multi-room
audio systems and computer controlled audio systems.
• Removable 19 inch rack-ears (included).
• Galvanically separated antenna and RS232 connectors to avoid
hum.
• Active FM antenna signal buffer.
• AM/FM tuner with adaptive noise suppression. Compatible with
3
Page 6
4
Music Sources & Sound Systems
cable antenna signal networks and standard wire antennas
(included).
• RDS information: program type, song name identification, radio
station identification.
• Standalone operation and/or remote controlled by infrared and/
or RS232.
• Adjustable audio output level.
• High class brushed aluminum front.
• Low power consumption.
• Attractive clearly readable dot matrix gas display and led status
indicators.
• Excellent real world performance.
• Infrared remote control unit included.
• Separate infrared minijack input for seamless integration in
multi-room audio systems, allowing link through of infrared
signals via the multiroom system (check your multi-room
system’s specifications for compatibility).
• 40 station memory presets.
Page 7
Front panel
Instruction manualPR1000R
5
8
4
6
2
9
5
3
1
7
10
12
11
13
14
18
22
20
16
17
21
19
15
24
23
1. Power knob / power led: flip the switch to turn the unit on and
off. In standby mode, the power led lights up slightly dimmed.
In the off position the unit is fully turned off.
2. AM / FM mode selection: push this button to alternate between
FM and AM band mode.
3. Scan : push this button to automatically scan the stored preset
radio stations, with every push on the scan button, you will
jump to the next preset. When you keep the button pushed for
a few seconds, M-SCAN appears in the display and the tuner
will automatically scan all presets once.
4. Mono / stereo selector : in FM tuning mode, use this switch to
activate stereo or mono mode. In case of weak reception, mono
mode will drastically reduce noise. In case of stereo reception,
the led ‘12’ will light up.
5. Save button: push this button to save the currently selected
radio station, push a numeric button (or button combination)
afterwards and confirm your selection by pressing the save
button a second time.
Page 8
6
Music Sources & Sound Systems
6. Search forward button: push this button to search for a radio
station upward in the radio band.
7. Search downward button: push this button to search for a radio
station downward.
8. + PRG TYPE: push this button to activate and display program
type information if RDS is available. FM mode only, this has no
function when no RDS or PRG information is transmitted by the
radio station. Led ‘10’ lights up when the function has been
activated. Activating this function will automatically deactivate
the + INFO TEXT function.
9. + INFO TEXT: push this button to activate and display RDS
information, such as song name identification. FM mode
only, this has no function when no RDS or PRG information
is transmitted. Led ‘11’ lights up when the function has been
activated. Activating this function will automatically deactivate
the + PRG TYPE function.
10. RDS PRG led: lights up when the + PRG TYPE function is
activated.
11. RDS INFO led: lights up when the + INFO TEXT function is
activated.
12. FM stereo led: lights up when FM reception is stereo.
13. Dot matrix gas display: multifunctional display showing radio
station frequency and preset number or RDS information.
14. Numeric button 1: push this button to select or save radio
station preset number 1.
15. Numeric button 6: push this button to select or save radio
station preset number 6.
Page 9
Instruction manualPR1000R
16. Numeric button 2: push this button to select or save radio
station preset number 2.
17. Numeric button 7: push this button to select or save radio
station preset number 7.
18. Numeric button 3: push this button to select or save radio
station preset number 3.
19. Numeric button 8: push this button to select or save radio
station preset number 8.
20. Numeric button 4: push this button to select or save radio
station preset number 4.
21. Numeric button 9: push this button to select or save radio
station preset number 9.
22. Numeric button 5: push this button to select or save radio
station preset number 5.
23. 10+ button: numeric button to select preset number 10 to
39: when pushed once, 1_ will appear in the display. Then,
if you press any numeric button 1 - 9 within a few seconds,
stations 11 - 19 can be selected (or saved). If no further button
ispushed, preset 10 will be recalled (or saved) after a few
seconds. Pushing the button twice will show 2_, pushing 3
times will show 3_
7
24. Tuning: turn left or right to manually tune the frequency in
steps of 50 kHz (FM mode) or 9 kHz (AM mode).
Page 10
8
Back panel
Music Sources & Sound Systems
1
1. FM antenna input: connect the supplied FM antenna here, or
use the signal from a cable distribution network. This input
is galvanically separated from the audio ground and serial
interface.
2. AM antenna input: connect the supplied AM antenna here.
3. Output level control: turn this control to match the tuner’s
output with the output level of other music sources such as CD
players.
4. Line level output on cinch connectors.
5. IR control external input: connect the optional IR extender here
(PIR-REC), or connect a suitable electrical IR signal from a multiroom audio system or other compatible system. Connector tip
= supply +5V, ring = data, sleeve = GND.
6. RS232 port: connect your computer or other compatible
equipment on this connector. Cable specifications are
mentioned below.
7. Mains fuse holder: this holder contains the mains fuse. In case
of fuse failure, replace it only with a fuse with the same voltage
and current rating as mentioned on the back panel, in this case:
T 315 mA L 250V~
4
3
5
6 7
82
Page 11
Instruction manualPR1000R
8. Mains in: connect the included mains cable here.
RS232 Cable specifications
Pin 2: TX data: data transmission output
Pin 3: RX data: data reception input
Pin 5: GND: ground
Other pins are not used.
RS232 supported command list
• set echo on/off: related to RS232 communication
• set standby on/off: activate standby mode, wake up tuner from
standby
• set baudrate 2400/4800/9600/19200/38400 (19200 default
value)
• get info: display the current tuner settings
• rcl preset XX: recall a previously stored preset radio station
• str preset XX: store the current frequency at defined preset
number
• set mantun XXX.XX: manually set the radio frequency
9
Page 12
10
Music Sources & Sound Systems
• set stereo on/off: activate stereo/mono mode (FM operation
only)
• inc search: search radio station upward
• dec search: search radio station downward
• set modula AM: activate AM band
• set modula FM: activate FM band
• inc mantun: increase frequency by 1 step upward, FM 50 kHz,
AM 9 kHz
• dec mantun: decrease frequency by 1 step downward, FM 50
kHz, AM 9 kHz
• get rdsinf ps: activate RDS reception of station name
• get rdsinf rt: activate RDS reception of RDS text info
Note: X stands for a numeric value, e.g. XXX.XX could be 100.90.
Commands not mentioned in this list are not supported, however,
these commands allow complete control of all tuner functions
via RS232. Default RS232 communication settings are : baud rate
19200, echo on, CR on, BS on, valfb on (value feedback on).
Page 13
Infrared codes:
Instruction manualPR1000R
11
10EF4B
10EF4E 10EF4D 10EF49 10EF48 10EF0F
10EF52
10EF55
10EF51
10EF5B 10EF5A
10EF5D
10EF59
10EF98 10EF1F
Page 14
12
Specifications
Music Sources & Sound Systems
FM tuning range 87.5 - 108 mHz
Presets 40
AM tuning range 522 - 1611 kHz
FM sensitivity (26 dB S/N) @ 75
Ohm unbalanced
AM sensitivity (26 dB S/N) 38 μV
FM channel selectivity (200 kHz) 50 dB
FM channel selectivity (400 kHz) 70 dB
Audio S/N ratio FM 78 dB (IHF)
Audio bandwidth ± 1.5 dB 30 – 15 kHz
THD <0.1 %
Stereo separation >50 dB @ 1 kHz
Power supply 230 VAC / 50 - 60 Hz
Power consumption max 10 VA
Power consumption standby mode 1 watt
Rack ears Included, removable
Adjustable audio output level
Galvanically separated antenna and RS232 connectors
Active FM antenna signal buffer
Tuner with adaptive noise suppression
Dimensions l x w x h 484 (430) X 270 (245) x 44 mm
Weight 2.8 kg
1.1 μV
Page 15
Instruction manualPR1000R
Included accessories: Mains power cable, printed manual, RS232
and infrared specifications, infrared control unit, FMwire antenna,
AM loop antenna.
13
Page 16
developed
by
Industriepark Brechtsebaan 8 bus 1
Audioprof nv
2900 Schoten - Belgium
Company names, product names and trademarks are property of their
Apart-Audio specifications are subject to change without notice.
respective owners.
Loading...