Bettcher 173518 Specifications

Page 1
•
BETTCHER Industries, Inc.
WHIZLUBE SPRAY Birmingham, Ohio 44816
MATERIAL SAFETY DATA SHEET 6801 St. Rt. 60
SECTION 1 – PRODUCT IDENTIFICATION
PRODUCT NAME:
CHEMICAL NAME:
Not Applicable
CHEMICAL FAMILY:
Not Applicable
SECTION 2 – INGREDIENTS
COMPONENTS
Liquefied Petroleum Gas Essentially Propane Isobutane Isoparaffinic Hydrocarbon Solvent Polymer Thickened Petroleum Lubrication Grease**
Product Contains No Carcinogens (NTP, JARC, OSHA) *PEL/TLV Not Established. This Represents The Manufacturers Suggested Total Hydrocarbon Exposure. ** See Additional Comments.
SECTION 3 – HEALTH AND HAZARDS IDENTIFICATION
Health ………………………….. 1 Flammability …………………... 4 Reactivity …………………….. 0 Protection ……………………..X
Specific Hazards: This Product Contains Hazardous Ingredients
PRODUCT CODES:
173518 – 11.25 oz. Can 06-355-06
EMERGENCY PHONE NUMBERS:
800-321-8763 800-424-9300 (CHEMTREC)
CAS NUMBER
Propellant
74-98-6 75-28-5
64742-48-9
N/A
%W
15-25
25-35 45-55
NFPA HAZARD RATING:
N/A N/A
PEL-OSHA
1000ppm N/A N/A 400ppm* 5mg/M3*
TLV-ACGIH
1000ppm N/A N/A 400ppm* 5mg/M3*
ACUTE INHALATION: CNS Depression, Irritation or Respiratory Tract. EYES: Irritation SKIN: Irritation, Defatting, Dermatitis INGESTION: Aspiration Of Material Into The Respiratory System Can Result In Severe Pulmonary
Injury. If Ingested, Do Not Induce Vomiting. Get Medical Help At Once. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None Known To Us, However, We Would
Expect Vapor Or Mist Might Aggravate Existing Respiratory Irritation. Skin Contact May Aggravate An Existing Condition.
SECTION 4 – FIRST AID MEASURES
INGESTION:
• Do Not Induce Vomiting
• Get Medical Attention
EYE CONTACT:
• Flush With Plenty of Water For At Least 15 Minutes
• Get Medical Attention
DERMAL:
• Flush With Soap & Water Contaminated Clothing-Remove & Launder
INHALATION:
• Move To Fresh Air
• Apply Artificial Respiration If Breathing Stops
• Get Medical Attention
ECN 9819 REV. A A173521 Reaffirmed 2/09 1
Page 2
BETTCHER Industries, Inc.
MATERIAL SAFETY DATA SHEET 6801 St. Rt. 60
WHIZLUBE SPRAY Birmingham, Ohio 44816
SECTION 5 – FIRE FIGHTING MEASURES
FLASH POINT:
• < 0°
FLAMMABLE LIMITS:
• LEL=1.5 UEL=12
FLAMMABLE LIMITS IN AIR % BY VOLUME: The Values Are Based on Min/Max LEL/UEL Of Components As Known To Us
SPECIAL FIRE FIGHTING PROCEDURES:
• Use Equipment Or Shielding To Protect Personnel Against Rupturing Or Venting Containers. At Elevated Temperatures (Over 130
°F) Aerosol Containers May
Burst, Vent Or Rupture.
• Cool Water Streams May Be Helpful
UNUSUAL FIRE AND EXPLOSION HAZARDS:
• Firefighters Should Wear Self-Contained, Positive Pressure Breathing Apparatus With Full Face Piece
EXTINGUISHING MEDIA:
• Carbon Dioxide
• Foam
• Dry Chemical
• Water to Cool Container
SECTION 6 – ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED :
• Remove Sources Of Ignition
• Ventilate Area
• Use Protective Equipment Consistent With the Situation
• Place Residue Into Metal Container For Proper Disposal
WASTE DISPOSAL METHODS :
• Consult Federal, State, and Local Regulations. Do Not Puncture Or Incinerate Containers. Give Empty, Leaking or Full Containers To A Disposal Service Equipped To Safely Handle and Dispose of Pressurized Containers
SECTION 7 – HANDLING AND STORAGE
• Store In Cool, Dry Area, Out of Direct Sunlight.
• Do Not Puncture, Incinerate (Burn) or Heat Above 130°F Either Full or Empty
Containers
• Read And Follow Directions On Product Label Or Any Accompanying Literature
MAINTENANCE PRECAUTION:
• Do Not Remove or Deface Label
ADDITIONAL COMMENTS:
• ** Lubrication Oil Base Of This Component Is (CAS #8042-47-5). The Noted Exposure Limit Is For Oil Mist, Not The Specified Product (Grease).
• *** FP Based On Propellant Component. Solvent/Active Portion: FP Based On Component Of Lowest Value – 18°F TCC (Excluding Propellant).
ECN 9819 REV. A A173521 Reaffirmed 2/09 2
Page 3
BETTCHER Industries, Inc.
WHIZLUBE SPRAY Birmingham, Ohio 44816
MATERIAL SAFETY DATA SHEET 6801 St. Rt. 60
SECTION 8 – EXPOSURE CONTROLS/PERSONAL PROTECTION
RESPIRATORY PROTECTION:
• Generally Not Required If Sufficient Ventilation Is Provided.
• If TLV Of Product Or Any Of Its Components Is Exceeded, An Approved Organic Vapor Mask Should Be Used
OTHER PROTECTIVE EQUIPMENT:
• Eye Protection Suggested. Goggles or Safety Glasses With Side Shields if Contact With Spray is Likely
HYGIENIC PRACTICES:
• Wash Hands Thoroughly Before Eating or Smoking After Using This Or Any Chemical Product
VENTILATION:
• Local Exhaust ………… To Maintain <PEL/TLV
• Mechanical (General)… To Maintain <PEL/TLV
• Special ………………… To Maintain <PEL/TLV
•
Other …………………... To Maintain <PEL/TLV
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
PROTECTIVE GLOVES:
• Where Prolonged Or Repeated Contact With Spray Mist Or Deposited Product Is Likely, Protective Gloves (Neoprene) Should Be Used
OTHER ENGINEERING CONTROLS:
• To Determine Exposure Levels, Monitoring Should Be Performed
WORK PRACTICES:
• Do Not Use in Confined or Closed Space. Ventilation Should Maintain Concentrations Below PEL/TLV
BOILING POINT: N/A
SPECIFIC GRAVITY (H2O=1): > 1
% VOLATILES BY VOLUME: > 60%
VAPOR PRESSURE (mm Hg) = 40 +/- 10
VAPOR DENSITY: (AIR=1) : > 1
EVAPORATION RATE: SLOW
SOLUBILITY IN WATER: NEG
APPEARANCE & ODOR Clear Mist With Odor of Petroleum Solvent As Dispensed From Aerosol Package
SECTION 10 – STABILITY AND REACTIVITY
STABILITY: Stable CONDITIONS TO AVOID FOR POLYMERIZATION: N/A CONDITIONS TO AVOID FOR STABILITY: Avoid Heat Sufficient To Burst Can (Over 130°F) and Spraying
Into Flame Or Onto Red Hot Surfaces Which May Cause Decomposition/Ignition.
INCOMPATIBILITY (Avoid Contact With): HAZARDOUS DECOMPOSITION PRODUCTS : Not Determined, However, Expect CO
Strong Oxidizers
and CO And
2
Various Incompletely Burned Hydrocarbon Products
ECN 9819 REV. A A173521 Reaffirmed 2/09 3
Page 4
BETTCHER Industries, Inc.
WHIZLUBE SPRAY Birmingham, Ohio 44816
MATERIAL SAFETY DATA SHEET 6801 St. Rt. 60
SECTION 11 – TOXICOLOGICAL INFORMATION
CHRONIC EFFECTS: None Known, However Many Petroleum Hydrocarbons Have Been Shown To Pose
Potential Human Health Risks, Which May Vary From Person To Person And As A Precaution, Exposure to Liquids, Vapor, Mists or Fumes Should Be Minimized
PRIMARY ROUTES OF ENTRY: Inhalation and Skin Contact
SECTION 12 –ECOLOGICAL INFORMATION
ENVIRONMENTAL EFFECTS – None Known. Consult Federal, State and Local Regulations.
SECTION 13 –DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD – Consult federal, state, or local authorities for proper disposal procedures :
ALL DISPOSALS MUST COMPLY WITH FEDERAL, STATE AND LOCAL REGULATIONS
SECTION 14 – TRANSPORT INFORMATION
DOT: Consumer Commodity, ORM-D IMO: Aerosols, Flammable, UN 1950, Class 2, Limited Quantity.
SECTION 15 – REGULATORY INFORMATION
This Product Meets The Requirements As Set Forth By NSF International As A Continuation
Of The USDA Product Approval Program And Based On The Regulatory Requirem ents
Of FDA 21 CFR For Appropriate Use, Ingredient And Labeling.
The information and recommendations contained herein are, to the best of Bettcher Industries’ and the manufacturer of this product, accurate and reliable as of the date issued. Bettcher and the manufacturer shall not be liable for any loss or damage arising out of the use thereof. The information and recommendations are offered for the user’s consideration and examination, and it is the user’s responsibility to satisfy itself that they are suitable and complete for its particular use.
PLEASE NOTE: “The above information is accurate to the best of our knowledge. However, since data, safety standards and government regulations are subject to change and the conditions of handling and use, or misuse are beyond our control, Bettcher Industries, Inc. MAKES NO WARRANTY, EITHER EXPRESS OR IMPLIED, WITH RESPECT TO THE COMPLETENESS OR CONTINUING ACCURACY OF THE INFORMATION CONTAINED HEREIN AND DISCLAIMS ALL LIABILITY FOR RELIANCE THEREON. User should satisfy himself that he has all current data relevant to his particular use.”
ECN 9819 REV. A A173521 Reaffirmed 2/09 4
Loading...