Page 1
BenQ RP Series Display
Audio Interface Cable Connection Guide
Thank you for purchasing the BenQ RP Series display!
Please note that the audio interface cable is not connected when the display was shipped from the
factory. Remember to connect the audio interface cable following the instructions below before installing
and using the display.
The operations below should be performed by at least two adult persons to avoid danger and injuries.
1. Place a clean, dry and lint-free cloth on a flat, horizontal and object-free surface. Make sure that the
size of the cloth is larger than the display and the surface is stable and sturdy enough to sustain the
weight of the display.
2. Gently lay the display on the cloth with the LCD screen facing down.
3. Locate the audio interface cable from the accessory box.
Audio interface cable
4. Connect one end of the audio
interface cable (the end with a
3.5mm Mini-jack plug and two
RCA-type plugs) to the
AUDIO IN (AUDIO1) and
AUDIO IN (AUDIO2) input
sockets on the rear panel of
the display, and the other end
(the end with a 3.5mm Minijack plug) to the audio interface
socket below the interactive
pen tray.
5. Route the cable properly using
the cable clips on the back of
the display.
Loading...