Benq AWL100 Users Manual
Benq Wireless LAN PCMCIA Adapter
AWL100
User Manual
Version 1.0
MPE Statement (Safety Information)
Your device contains a low power transmitter. When device is transmitted it sends out Radio
Frequency (RF) signal.
Safety Information
In order to maintain compliance with the FCC RF exposure guidelines, this equipment should
be installed and operated with minimum distance 2.5cm between the radiator and your body.
Use only with supplied antenna. Unauthorized antenna, modification, or attachments could
damage the transmitter and may violate FCC regulations.
Caution Statement of the FCC Radio Frequency Exposure
This Wireless LAN radio device has been evaluated under FCC Bulletin OET 65C and found
compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and
15.247(b)(4) addressing RF Exposure from radio frequency devices. The radiation output
power of this Wireless LAN device is far below the FCC radio frequency exposure limits.
Nevertheless, this device shall be used in such a manner that the potential for human contact
during normal operation—as a mobile or portable device but use in a body -worn way is strictly
prohibit. When using this device, a certain separation distance between antenna and nearby
persons has to be kept to ensure RF exposure compliance. In order to comply with the RF
exposure limits es tablished in the ANSI C95.1 standards, the distance between the antennas
and the user should not be less than 2.5cm.
In order to avoid from mutual interference, this device must not be co-located or
operating in conjunction with any other antenna or transmitter.
Federal Communications Commission (FCC) Requirements, Part 15
This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and
receiver.
---Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
---Consult the dealer or an experienced radio/TV
technician for help.
The identification of the product:
Product Name : BenQ WLAN PCMCIA Adapter
Model : AWL100
BenQ Wireless LAN Technical Support:
BenQ Corporation
Address : 8, Jihu Rd., Nei-hu Dist., Taipei 114, Taiwan, R.O.C.
Telephone : 886-2-2799-8600
Fax : 886-2-2799-8822
Technical Support in the US:
BenQ Incorporated
Address : 20480 East Business Parkway, City of Industry,
CA 91789, USA
Telephone : 1-909-569-0700
Fax : 1-909-569-0701
WWW : www.benq.com
Benq Wireless LAN
Contents
Contents ..........................................................................................................................i
1. Installation..................................................................................................................1
1.1 Driver Installation....................................................................................1
2. AWL100 Wireless Settings ........................................................................................3
2.1 Status ........................................................................................................5
3.2 Configuration ...........................................................................................7
3.3 Encryption................................................................................................8
3.4 Site Survey...............................................................................................9
3.5 About......................................................................................................10
AWL100 PCMCIA Adapter User Manual i
Benq Wireless LAN
1
1. Installation
1.1 Driver Installation
Insert AWL100 PCMCIA Adapter into your PC, and then Windows will show the
dialog – ‘Add New Hardware Wizard’.
Select ‘Search the location of the driver’ and press Next button.
AWL100 PCMCIA Adapter User Manual
Loading...