Bendix Commercial Vehicle Systems ASA-5 TEMPLATE User Manual
Y
O
K
E
P
I
}
N
6˝
5.5˝
5˝
6˝
5.5˝
5˝
L
I
N
K
P
I
{
N
Bendix®ASA-5®Slack
Adjuster Template
1. Block the wheels, mechanically cage the parking brakes and drain
all air pressure from the system.
2. Before installing the ASA-5
instructions packaged with the service replacement ASA-5®slack
adjuster, or the service data sheet SD-05-1269.
3. Remove the existing slack adjuster and yoke.
4. Install the ASA-5
5. Center the hole “A” on the brake camshaft.
6. Center the ASA-5®slack adjuster yoke pin in the template hole.
7. The full diameter of the ASA-5®slack adjuster link pin must be within the appropriate slot in the template (6˝ yoke pin to 6˝ link pin,
etc.). If not aligned, adjust the yoke adapter on the actuator rod.
BW1641 © 2009 Bendix Commercial Vehicle Systems LLC 12/2009
®
slack adjuster on the brake camshaft.
Printed in U.S.A. All rights reserved.
®
slack adjuster, read the installation
HOLE
A
This template is not needed for the ASA-5® slack adjuster installation. Please refer to the installation
instructions included with your product. This template can be used for assistance, if needed.
Please print this template at 100% on cardstock for assistance with the installation of your ASA-5
®
slack adjuster.
L
6˝
I
N
K
P
}
I
N
5.5˝
5˝
6˝
5.5˝
5˝
{
Bendix®ASA-5®Slack
Adjuster Template
1. Block the wheels, mechanically cage the parking brakes and drain
all air pressure from the system.
2. Before installing the ASA-5®slack adjuster, read the installation
instructions packaged with the service replacement ASA-5®slack
adjuster, or the service data sheet SD-05-1269.
3. Remove the existing slack adjuster and yoke.
4. Install the ASA-5
5. Center the hole “A” on the brake camshaft.
6. Center the ASA-5®slack adjuster yoke pin in the template hole.
7. The full diameter of the ASA-5
in the appropriate slot in the template (6˝ yoke pin to 6˝ link pin,
etc.). If not aligned, adjust the yoke adapter on the actuator rod.
BW1641 © 2009 Bendix Commercial Vehicle Systems LLC 12/2009
®
slack adjuster on the brake camshaft.
®
slack adjuster link pin must be with-
Printed in U.S.A. All rights reserved.
Y
O
K
E
P
I
N
HOLE
A
This template is not needed for the ASA-5® slack adjuster installation. Please refer to the installation
instructions included with your product. This template can be used for assistance, if needed.
Please print this template at 100% on cardstock for assistance with the installation of your ASA-5® slack adjuster.
Loading...