BENDIX TCH-005-013 User Manual

Technical Bulletin

Bulletin No: TCH-005-013b Effective Date:9/12/2011 Cancels: TCH-005-013a dated 9/7/07 Page: 1 of 1

Subject: Brake Actuator Push Rod Qualications for Use with Bendix

®

ASA-5® and

Bendix® Versajust™ Slack Adjusters

This Bulletin updates Bendix Commercial Vehicle Systems LLC guidelines for push rods used with Bendix®
ASA‑5® and Bendix® Versajust™ automatic slack adjusters.

Both these slack adjusters adjust the clearance between the brake linings and the drums during a brake application

and require push rods with the following specications to be used:

1. For push rods up to eight (8) inches in length, must be made with steel with strength
that meets or exceeds SAE 1018 or equivalent grade (based on the yield strength
of the material). (See dimension A shown below).

A

A

2. Without exception, in cases where longer push rods are necessary, they must
be made from steel with strength that meets or exceeds SAE 1035 or equivalent
grade (based on the yield strength of the material). In these cases, the push rod
must be a minimum of 0.625 inch in diameter and only partially threaded (i.e. Only

threaded the rst three to four inches at the end of the rod).

Push rod length ‘A’ is
measured from the
bottom of the actuator
to the end of the push
rod. This dimension is
taken with the spring
brakes released or
caged.

3 ‑ 4

inches

max.

Push

Rod

Diameter

WARNING. Brake actuator push rods that do not meet these recommendations can be permanently

deformed by the forces generated during a braking application. Bent brake actuator push rods may

negatively affect the braking performance at the wheel end.

If you have further questions, contact your Bendix Account Manager or call 1‑800‑AIR‑BRAKE.

Reference Materials

See the following Bendix Service Data sheets available from the document library

at www.bendix.com or from the Literature Center at the web site:

SD‑05‑1269 Bendix® ASA‑5® Automatic Slack Adjuster
SD‑05‑4630 Bendix® Versajust™ Automatic Slack Adjuster

SD‑02‑4525 Bendix® EverSure® Spring Brake

© 2011 Bendix Commercial Vehicle Systems LLC, a member of the Knorr‑Bremse Group. 9/11. All Rights Reserved.