Belt Drives CS-34A User Manual

CS-34A Compensator Installation Instructions

Read all installation instructions first! Verify primary chain sprocket alignment using supplied washers
/ spacers before final installation. Refer to OEM Service Manual for removal and installation of stock
primary drive components. Note* CS-34A is fully assembled with minimal amount of Anti-seize from
the factory and must be disassembled completely before following these instructions.

1. Safely support and secure motorcycle.

2. Disconnect the battery as per s ervice manual.

3. Drain primary fluid into pan.

4. Remove outer primary cover and gasket.

5. Remove existing sprocket or compensator.
Primary chain and clutch basket if needed. Visibly
mark primary chain to ensure same rotaion on
sprockets.

6. To assemble CS-34A apply a thin coat of
Anti-seize to the sprocket carrier threads as
needed. Apply a thin coat of assembly lube to the
larger Nylatron washer and install washer over
threads of sprocket carrier, to the face of the flange.

7. Apply a thin coat of Anti-seize to the threads of
the CS-34A sprocket. Note the recessed surfaces of
the sprocket, the larger recess faces larger Nylatron
washer and carrier body.

8. read sprocket onto carrier body until
sprocket stops against the carrier body flange, fully
seating Nylatron washer into recess of sprocket. DO
NOT PINCH NYLATRON WASHER BETWEEN
FLANGE AND SPROCKET this can / will cause
compensator to operate incorrectly, and may cause
compensator failer.

9. Install clutch basket and primary chain back onto
motorcycle.

10. Apply a thin coat of assembly lube to the smaller
Nylatron washer.

Note: DO NOT PINCH EITHER OF THE
NYLATRON WASHERS BETWEEN SPROCKET,
CARRIER BODY, AND THE OUTER FLANGE.

11. Fully seat smaller Nylatron washer into recess
on CS-34A sprocket, then install outer flange. Align
CS-34A assembly and outer flange with splines on
sprocket sha and install.